52-32-00
ALL ú ú 04 Page 550 ú Jun 15/98
BOEING PROPRIETARY - Copyright (C) - Unpublished Work - See title page for details.
(d)
A
747-400 MAINTENANCE MANUAL
7) As you turn the latch actuator 8 |1/4 turns clockwise (switch actuates 7 |1/4 turns prior to external stops [closed] position [Fig. 510]), adjust the switch to get a continuity between pins 9 and 10 of connector DX225C.
NOTE: The switch must operate as the latch actuator is
____ turned to the closed stops (clockwise). One turn of the limit switch locknut will change the switch operation point approximately one turn on the latch actuator.
8) Connect electrical connector DX225C to the cargo door junction box.
9) Turn the latch actuator counterclockwise to the fully open
position before you operate the door.
Do the operational check of the latches closed switch as
follows:
CAUTION:_______ IN CASE THE DOOR DOES NOT OPEN, STOP IMMEDIATELY. DO
NOT OPERATE THE DOOR CONTROL SWITCH. HOLDING THE
DOOR CONTROL SWITCH MAY DAMAGE THE ACTUATOR. WAIT AT
LEAST 1 MINUTE BEFORE SECOND ATTEMPT. IF THE DOOR
STILL DOES NOT OPEN, WAIT AT LEAST 10 MINUTES BEFORE
THIRD ATTEMPT.
1) Open the door electrically 1 to 2 feet. 2) Fully close the door electrically.
NOTE: You must close the door electrically, since the
____ latch position at electrical shutoff finds if the switch setting is acceptable.
3) Use a torque wrench with a dial indicator to apply 25 |5 pound inches torque to the manual drive of the latch actuator in the clockwise direction.
4) Carefully count the number of turns that remain until the external stops are touched (Fig. 510).
NOTE: The external stops must be touched in 3 |1 turns.
____
5) If the external stops are not touched in 3 |1 turns, do these steps: a) Subtract the actual number of turns that remain from
the 3 turns. b) Subtract this difference from 8 |1/4 turns.
EFFECTIVITYùùùùùùùùùùùùùùùùùùùùùùùùùùùùùù. ú
52-32-00
ALL ú ú 04 Page 551 ú Jun 15/98
BOEING PROPRIETARY - Copyright (C) - Unpublished Work - See title page for details.
A
747-400 MAINTENANCE MANUAL
c) Do the initial latches closed switch adjustment and replace the new value for the 8 |1/4 turns.
EXAMPLE: Assume 1 turn remains until stops are
_______ contacted. The 3 required turns minus the 1 actual turn equals 2 turns. Use 6 |1/4 turns (8 |1/4 minus 2).
中国航空网 www.aero.cn
航空翻译 www.aviation.cn
本文链接地址:747-400 AMM 飞机维护手册 舱门 DOORS 2(98)