曝光台 注意防骗
网曝天猫店富美金盛家居专营店坑蒙拐骗欺诈消费者
71-00-00
ALL ú ú C14 Page 563 ú Nov 12/01
BOEING PROPRIETARY - Copyright (C) - Unpublished Work - See title page for details.
////////////////////////A / /
CFM56 ENGINES
737-300/400/500/ /MAINTENANCE MANUAL ////////////////////////
TEST NO. 7 - VIBRATION SURVEY
_____________________________
5) Turn the selector switch on the isolation test equipment to find the source of the vibration indications above the limits.
NOTE: You can also examine the history data in the AVM
____ signal conditioner. You will find the AVM signal conditioner in the EE bay area (AMM 77-31-00/201).
6) Do the test again for all of the high vibration points that you found (if there are more than one) during the engine acceleration.
NOTE: If the test equipment is not available, find the
____ maximum vibration levels by interrogating the AVM History data (on airplanes with P/N S332T304-16/-23/-25/-27/-30; or S360N021-100/-201 AVM signal conditioners).
7) Do the fan rotor trim balance (AMM 72-31-00/501), if you find these conditions to be the source of the high vibration: a) The high vibration is in the N1 rotor only (FAN and/or
LPT (low pressure turbine)).
b) The high vibration is in the N1 rotor (FAN and/or LPT) and the N2 rotor (HPC (high pressure compressor) and the HPT (high pressure turbine)).
c) If you find the high vibrations only in the N2 rotor (HPC and/or HPT) and they are more than 3.0 units, then replace the engine (AMM 71-00-02/401).
(p) Do the engine shutdown (normal) operation (AMM 71-00-00/201).
(q) If you installed it, remove the test equipment for the engine vibration isolation (Fig. 509). 1) Open the ENG VIB MON circuit breaker. 2) Disconnect the test equipment from the electronic shelf and from the signal conditioner. 3) Disconnect the selector switch from the test equipment
unit. 4) Close the access door above the main E/E rack. 5) Install the AVM signal conditioner (AMM 77-31-03/401). 6) Close the ENG VIB MON circuit breaker.
EFFECTIVITYùùùùùùùùùùùùùùùùùùùùùùùùùùùùùù. ú
71-00-00
ALL ú ú C11 Page 564 ú Nov 12/01
BOEING PROPRIETARY - Copyright (C) - Unpublished Work - See title page for details.
////////////////////////A / /
CFM56 ENGINES
737-300/400/500/ /MAINTENANCE MANUAL ////////////////////////
TEST NO. 8 - ACCEL/DECEL CHECK
______________________________
TASK 71-00-00-715-015-C00
9. Test No. 8 - Accel/Decel Check
______________________________
A. General
(1)
This procedure makes sure of a smooth accel/decel operation with no stalls or flameouts.
B.
Equipment
(1)
Alcohol Thermometer - MIL-T-11399, Type ML-5
(or mercury thermometer, if not taken aboard
airplane), -40° to 120°F (-40° to 49°C),
|1/2°F (|1/4°C) accuracy.
(2)
Stopwatch - to measure acceleration time
C.
References
(1)
AMM 71-00-00/201, Power Plant
(2)
AMM 71-00-01/201, Power Plant-Trim Tables
(3)
AMM 71-00-42/101, Power Plant (Power & Engine Response) ú (4) AMM 72-00-00/601, Engine
D.
Access
(1)
Location Zones
506 Engine No. 1
606 Engine No. 2
(2)
Access Panels
5737L/5837R Fan Cowl Assy
5746L/5846R Fan Cowl Assy
5738L/5838R Thrust Reverser Cowl Assy
5739L/5839R Thrust Reverser Cowl Assy
E.
Procedure
S 715-016-C00
(1) Do the Accel/Decel Check
CAUTION: DO NOT USE THE TOTAL TEMPERATURE INDICATION FROM THE
_______ AIRPLANE FOR THE AMBIENT AIR TEMPERATURE. MAKE SURE THAT YOU GET THE LOCAL BAROMETRIC PRESSURE (NOT CORRECTED TO SEA LEVEL) FROM THE CONTROL TOWER. THIS WILL PREVENT AN INCORRECT TRIM TARGET SELECTION.
DO NOT PUT A MERCURY THERMOMETER ON THE AIRPLANE. MERCURY (FROM A BROKEN THERMOMETER) CAN CAUSE DAMAGE TO THE AIRPLANE COMPONENTS.
(a) Find and make a record of these conditions:
1) Make a record of the ambient air temperature (outside air temperature (OAT)) in the shade of the wheel well of the nose gear.
2) Make a record of the barometric pressure.
EFFECTIVITYùùùùùùùùùùùùùùùùùùùùùùùùùùùùùù. ú
中国航空网 www.aero.cn
航空翻译 www.aviation.cn
本文链接地址：737-300 400 500 AMM 飞机维护手册 动力装置 POWER PLANT 1(74)
