-
If the fuel leakage continues after 5 minutes at idle, shut down the engine, and repair the source of the leakage.
EFFECTIVITYùùùùùùùùùùùùùùùùùùùùùùùùùùùùùù. ú
71-00-00
ALL ú ú C11 Page 280 ú Jul 12/00
BOEING PROPRIETARY - Copyright (C) - Unpublished Work - See title page for details.
////////////////////////A / /
CFM56 ENGINES
737-300/400/500/ /MAINTENANCE MANUAL ////////////////////////
(a)
If the ambient temperature is less than -31°F (-35°C), operate the engine at idle for two minutes before you change the thrust lever position.
(b)
Up to three and one-half minutes is permitted for the oil
pressure to reach the minimum operating pressure.
1) During this period, operate the engine at idle until the
oil pressure is satisfactory.
a) The LOW OIL PRESSURE light can stay ON
b) The oil pressure can exceed the usual range.
c) The FILTER BYPASS light can come ON.
(c)
If the N2 rotor does not turn, stop the start procedure and do a check for a frozen start valve. 1) Apply heat to free the start valve, or 2) Manually turn the butterfly valve 90° clockwise through the
manual override guide port for the start valve (Fig. 209).
(d)
If one igniter starts cause a problem, use the two igniters
during the next start.
(e)
If the engine is slow to accelerate after lightup and a
hung start could occur, do the procedure to shut down the
engine.
1) Start the engine again with the usual start procedure.
(f)
If the engine is slow to start, hangs up, or will not accelerate to idle, do the engine shut down and find the cause of the problem.
S 862-137-C00
(3) Operate the engine with the procedure for the usual engine operation and add these steps:
NOTE: Operation of the engine at or near idle for two minutes will
____
give an adequate warmup, even after a long cold soak in
subzero temperatures.
During engine operation in icing conditions, the ice may form on the spinner, fan blades, and first stage stator vanes. This ice will periodically flake off and go out through the fan exhaust.
(a) Let the generator frequency become stable before you apply
large electrical loads.
NOTE: Preheat of the CSD is usually not necessary, but cold
____ oil in the CSD will make the generator slow to develop steady power. One minute of operation is usually sufficient to warm up the CSD.
EFFECTIVITYùùùùùùùùùùùùùùùùùùùùùùùùùùùùùù. ú
71-00-00
ALL ú ú C10 Page 280A ú Jul 12/00
BOEING PROPRIETARY - Copyright (C) - Unpublished Work - See title page for details.
////////////////////////A / /
CFM56 ENGINES
737-300/400/500/ /MAINTENANCE MANUAL ////////////////////////
(b) Turn on the engine anti-ice system during icing conditions (TAT below 50°F [10°C] and visible moisture). 1) Put the applicable ENG ANTI-ICE switch to the ON position. 2) Make sure the applicable COWL VALVE OPEN light comes on
dim. 3) Make sure the applicable COWL ANTI-ICE light is off.
NOTE: If the COWL VALVE OPEN light stays on bright with
____ with the engine at idle, put the APU BLEED AIR switches to the OFF position and increase thrust slightly (up to a maximum of 30% N1).
(c)
Do periodic engine run-up when icing conditions are present.
1) Increase the thrust level as high as practical (70%N1 recommended) at 30-minute intervals for approximately 30 seconds of duration.
(d)
If you do some of the Power Plant Tests (AMM 71-00-00/501), it can be necessary to turn off the engine anti-ice system. 1) Engine trim data is with no bleed air off-takes and no
electrical loads.
中国航空网 www.aero.cn
航空翻译 www.aviation.cn
本文链接地址：737-300 400 500 AMM 飞机维护手册 动力装置 POWER PLANT 1(44)
