(a) N1 rotor vibration (N1), N2 rotor vibration (N2), broadband vibration (BB), and the rotor imbalance phase angle (N1PH) are displayed for engines 1 thru 4. The vibration readouts are scaled from zero to five units and an accelerometer source channel (A or B) is annunciated for each engine.
(13)
Engine Pressure Ratio (EPR) Data
(a)
EPR maximum (EPR MAX) is displayed for engines 1 thru 4. The EPR MAX values are calculated by the FMC's thrust management function. These values indicate the maximum thrust limit which is dependent upon atmospheric temperature, pressure and altitude.
(b)
EPR command (EPR CMD) is displayed for engines 1 thru 4. The EPR CMD values indicate the Electronic Engine Control (EEC) commanded EPR.
(c)
Actual EPR (EPR) is displayed for engines 1 thru 4. The displayed values represent the instantaneous actual pressure ratio for the engines.
(14)
N1 Rotor Speed
(a) Actual N1 rotor speed is displayed in units of percent rpm.
(15)
Exhaust Gas Temperature (EGT)
(a) EGT is displayed in units of °C (Celsius).
(16)
N2 Rotor Speed
(a) Actual N2 rotor speed is displayed in units of percent RPM.
(17)
Fuel Flow (FF)
(a) Displayed in units of kgm/hour divided by 1000.
(18)
Burner Pressure
(a) Displayed in units of psi absolute.
(19)
Duct Pressure
(a) Left and right duct pressures displayed in units of psi.
I. EICAS APU Maintenance Display (Fig. 56)
(1)
General
(a)
Auxiliary Power Unit (APU) parameters for EGT, N1, N2, oil pressure, oil temperature, oil quantity, air/ground mode, inlet door, starter, ignitor, fuel shutoff solenoids, fuel filter bypass, isolation valve, pneumatic or electrical loading, operating mode, fan valve, inlet air pressure and temperature, load compressor inlet/exit temperature, duct pressure, inlet guide vane, diverter valve, ECS demand, generator loads, battery and APU data are presented for display.
(b)
DC voltage and current values are received by the EIU on an ARINC 429 data bus from the Bus Control Unit (BCU).
(c)
All other APU maintenance page data is received by the EIU on an ARINC 429 data bus from the APU controller.
(2)
Exhaust Gas Temperature (EGT)
(a) APU EGT is represented by a 270 degree circular analog scale with a moving pointer, and as a digital readout enclosed in a box.
EFFECTIVITYùùùùùùùùùùùùùùùùùùùùùùùùùùùùùù. ú
31-61-00
ALL ú ú 35 Page 86B ú Feb 18/02
BOEING PROPRIETARY - Copyright (C) - Unpublished Work - See title page for details.
A
747-400
MAINTENANCE MANUAL
AIR/GROUND
MODE
INLET DOOR OIL QUANTITY
OIL TEMPERATURE
STARTER FUEL METERING UNIT
IGNITOR
STEPPER MOTOR COMMAND/ POSITION FUEL SHUTOFF SOLENOIDS
APU INLET AIR PRESSURE FUEL FILTER
APU INLET AIR
BYPASS TEMPERATURE
APU ISOLATION LOAD COMPRESSOR VALVE INLET TEMPERATURE
LOAD COMPRESSOR LOADING PNEUMATIC
EXIT TEMPERATURE AVAILABILITY LEFT AND RIGHT WING MANIFOLD ELECTRICAL
PRESSURES LOADING INLET GUIDE VANE AVAILABILITY COMMAND/POSITION
PNEUMATIC DIVERTER VALVE OPERATING CONTROL RESET MODE COMMAND/POSITION
LOW OIL ECS DEMANDPRESSURE SIGNALS
NO. 1 AND 2 GENERATOR LOADS
COOLING
FAN VALVE
BATTERY VOLTS AND AMPSAPU DATA
EICAS APU Maintenance Display
Figure 56
EFFECTIVITYùùùùùùùùùùùùùùùùùùùùùùùùùùùùùù. ú
31-61-00
ALL ú
ú 05 Page 86C
ú Jun 15/98
BOEING PROPRIETARY - Copyright (C) - Unpublished Work - See title page for details.
A40490
(3)
(4)
(5)
(6)
(7)
A
747-400
MAINTENANCE MANUAL
(b)
The APU EGT scale corresponds to a range of 0-1000°C. When the EGT input becomes negative the readout indicates zero. For EGT greater than 1000°C, the left most digit of the digital readout is removed. The analog scale is limited at the minimum and maximum scale range.
中国航空网 www.aero.cn
航空翻译 www.aviation.cn
本文链接地址：747-400 AMM 飞机维护手册 指示/记录系统 2(89)
