S 862-008
(8)
Set the FLT CONTROL HYD POWER TAIL switches on the P461 Pilot's Overhead Maintenance Panel in SHUTOFF.
S 862-010
(9)
Open these circuit breakers and attach DO-NOT-CLOSE tags:
(a)
P180 DC Power Distribution Panel
1) 180E7 ELEV/RUD VLV SYS 2
S 862-007
EFFECTIVITYùùùùùùùùùùùùùùùùùùùùùùùùùùùùùù. ú
27-21-17
ALL ú ú 01 Page 202 ú Oct 10/91
BOEING PROPRIETARY - Copyright (C) - Unpublished Work - See title page for details.
A
747-400 MAINTENANCE MANUAL
2) 180E22 ELEV/RUD VLV SYS 4
3) 180H8 ELEV/RUD VLV SYS 1
4) 180H23 ELEV/RUD VLV SYS 3
S 012-011
(10)
Open the access panel 324FL (Ref 06-09-07/201).
S 012-072
(11)
Open the access door 315A (Ref 06-09-06/201).
S 492-012
(12)
Install rig pin R-4 in the rudder feel, centering, and trim mechanism.
S 492-075
(13)
Install the rig pin E-2 in the elevator aft torque tube.
S 012-013
(14)
Remove the access panels 324UL and 324UR, or 324DR and 324DL (Ref 06-09-07/201).
E.
Remove the Power Control Module
S 032-014
(1)
Disconnect the electrical connector, DM8004, from the upper PCM, or the electrical connector, DM8005, from the lower PCM.
S 492-066
(2)
Put a bucket below the PCM to catch all hydraulic fluid.
S 022-015
(3)
Remove the rudder PCM (3 or 5):
(a)
Disconnect the hydraulic lines from the rudder PCM. 1) Make sure you seal all the hoses with caps.
(b)
Remove the bolt (27) to disconnect the input control rod from the rudder PCM.
NOTE: Make sure you do not change the length of the input
____
control rod.
(c) Make sure the input control rod is clear of the rudder PCM.
EFFECTIVITYùùùùùùùùùùùùùùùùùùùùùùùùùùùùùù. ú
27-21-17
ALL ú ú 01 Page 203 ú Jun 18/00
BOEING PROPRIETARY - Copyright (C) - Unpublished Work - See title page for details.
A
747-400
MAINTENANCE MANUAL
SEE A
1. UPPER ACTUATOR FOR THE UPPER RUDDER FRONT SPAR
2.
CENTER ACTUATOR FOR THE UPPER RUDDER
3.
POWER CONTROL
10. RATIO CHANGER FOR
MODULE FOR THE
THE UPPER RUDDER
UPPER RUDDER
INPUT CONTROL ROD
9. LOWER ACTUATOR FOR
THE UPPER RUDDER
27.
BOLT
28.
WASHER
29.
WASHER
30.
NUT
INPUT CONTROL ROD
4. FEEL, CENTERING AND TRIM MECHANISM
33. JUMPER RB CABLE RA CABLE FRONT SPAR8. UPPER ACTUATOR FOR
THE LOWER RUDDER
5. POWER CONTROL
INPUT CONTROL ROD MODULE FOR THE LOWER RUDDER
6.
LOWER ACTUATOR
7.
RATIO CHANGER
FOR THE LOWER RUDDER FOR THE RUDDER
27.
BOLT
28.
WASHER
29.
WASHER
30.
NUT
INPUT
CONTROL
ROD
A
Upper and Lower Rudder Power Control Module Figure 201 (Sheet 1)
EFFECTIVITYùùùùùùùùùùùùùùùùùùùùùùùùùùùùùù. ú
27-21-17
ALL ú ú 01 Page 204 ú Jun 18/00
BOEING PROPRIETARY - Copyright (C) - Unpublished Work - See title page for details.
A
747-400
MAINTENANCE MANUAL
11. WASHER
31. ELECTRO-HYDRAULIC 12. BOLT SERVO VALVE (2 LOCATIONS)
13. BUSHING
15. BACKUP RING
17. BACKUP RING
16. FILTER
18. O-RING
17. BACKUP RING
26. O-RING 19. FILTER CAP
3. POWER CONTROL 24. BACKUP RING
MODULE FOR THE 20. FILTER CAP
UPPER RUDDER 25. O-RING 23. FILTER
20. FILTER CAP 24. BACKUP RING
中国航空网 www.aero.cn
航空翻译 www.aviation.cn
本文链接地址：747-400 AMM 飞机维护手册 飞行操纵 FLIGHT CONTROLS 2(152)
