32-22-00
ALL ú ú 01 Page 102 ú Oct 10/88
BOEING PROPRIETARY - Copyright (C) - Unpublished Work - See title page for details.
A
747-400
FAULT ISOLATION/MAINT MANUAL
FORWARD DOOR OPERATOR ASSEMBLY
SEE B
AFT DOOR OPERATOR ROD
DRIVE CRANK (REF)
AFT NOSE GEAR DOOR
NOSE GEAR TRUNNION
AFT DOOR OPERATOR ASSEMBLY B NOTE:____ LEFT SIDE SHOWN RIGHT SIDE SIMILAR.
Nose Gear Doors - Component Location
Figure 102 (Sheet 2)
EFFECTIVITYùùùùùùùùùùùùùùùùùùùùùùùùùùùùùù. ú
32-22-00
ALL ú ú 01 Page 103 ú Oct 10/88
BOEING PROPRIETARY - Copyright (C) - Unpublished Work - See title page for details.
A
747-400 MAINTENANCE MANUAL
FORWARD NOSE WHEEL WELL DOORS - MAINTENANCE PRACTICES
_____________________________________________________
1. General_______
A. This procedure covers removal and installation of the nose gear wheel well forward doors. It also contains steps to adjust the doors and wear limit data for installation components.
TASK 32-22-01-002-001
2. Forward Nose Wheel Well Doors Removal (Fig. 201)_____________________________________
A. References
(1)
AMM 09-11-00/201, Towing
(2)
AMM 32-00-30/201, Landing Gear Door Locks
(3)
AIPC 32-22-01 Fig. 1
(4)
AIPC 32-22-03 Fig. 2
B.
Access
(1)
Location Zone
711 Nose Landing Gear Door, Forward, LH
712 Nose Landing Gear Door, Forward, RH
C.
Procedure
S 492-002
(1) Make sure the ground locks are installed in the landing gear (AMM 09-11-00/201).
S 492-003
WARNING: REFER TO AMM 32-00-30/201 FOR THE LOCK INSTALLATION PROCEDURE.
_______ THE DOORS CAN CLOSE QUICKLY IF YOU DO NOT INSTALL THE DOOR LOCKS CORRECTLY. THIS CAN CAUSE INJURY TO PERSONS OR DAMAGE TO EQUIPMENT.
(2)
Install the door locks for the nose landing gear (AMM 32-00-30/201).
S 022-004
(3)
Remove the forward wheel well doors:
(a)
Disconnect the bonding jumpers from the forward door hinges.
1) Remove the screws (16, Fig. 201) and the washers (17, 18, and 19).
EFFECTIVITYùùùùùùùùùùùùùùùùùùùùùùùùùùùùùù. ú
32-22-01
ALL ú ú 01 Page 201 ú Jun 18/01
BOEING PROPRIETARY - Copyright (C) - Unpublished Work - See title page for details.
A
747-400 MAINTENANCE MANUAL
STA 253 SEE B
SEE C
SEE C
BONDING JUMPER
16.
SCREW
17.
WASHER
18.
WASHER
19.
WASHER
FWD
3.
BOLT
4.
WASHER
1.
LEFT FORWARD DOOR
2.
RIGHT FORWARD DOOR (OPP)
BONDING JUMPER
16. SCREW
A
17.
WASHER
18.
WASHER 7. NUT 5. SPACER
19.
WASHER
6. WASHER
15. BOLT 8. BOLT
14. WASHER B
13. SPACER
9.
WASHER
10.
BUSHING
12. NUT
10.
BUSHING
11.
WASHER
C
Forward Nose Wheel Well Doors Installation Figure 201 (Sheet 1)
EFFECTIVITYùùùùùùùùùùùùùùùùùùùùùùùùùùùùùù. ú
32-22-01
ALL ú ú 01 Page 202 ú Jun 10/90
BOEING PROPRIETARY - Copyright (C) - Unpublished Work - See title page for details.
A
747-400
MAINTENANCE MANUAL
SEE D
DOOR
SEE F ACTUATOR
FWD
BELLCRANK
BELLCRANK SUPPORT FITTING
OPERATOR ROD
SEE E SHOWN WITH THE DOORS OPEN
D
22. OPERATOR ROD
DOOR OPERATEDSEQUENCE VALVE ROD ASSY
24.WASHER
(LEFT)
LOCKNUT
20. BUSHING
27.NUT 25.BUSHING
21. DOOR FITTING
中国航空网 www.aero.cn
航空翻译 www.aviation.cn
本文链接地址：747-400 AMM 飞机维护手册 起落架 LANDING GEAR 3(162)
