73-21-00
ALL ú ú C01 Page 513 ú Jul 15/96
BOEING PROPRIETARY - Copyright (C) - Unpublished Work - See title page for details.
////////////////////////A / /
CFM56 ENGINES
737-300/400/500/ /MAINTENANCE MANUAL ////////////////////////
~.............................................................. | AIRPLANE MODEL | ENGINE TYPE | DIFFERENTIAL VOLTAGE | ................................................................ | 737-300 | CFM56-3-B1 | 4.52 - 4.86 VDC | | | CFM56-3B-2 | 4.52 - 4.86 VDC | | | CFM56-3C-1 | 3.37 - 3.71 VDC | ................................................................ | 737-400 | CFM56-3-B1 | 4.52 - 4.86 VDC | | | CFM56-3B-2 | 4.52 - 4.86 VDC | | | CFM56-3C-1 | 4.52 - 4.86 VDC | ................................................................ | 737-500 | CFM56-3-B1 | 4.52 - 4.86 VDC | | | CFM56-3C-1 | 3.07 - 3.41 VDC | 2..................…...............…...........................1
TABLE 3 - DIFFERENTIAL VOLTAGE VALUES
S 025-067-C00
(11) If the calculated voltage differential is not between these limits:
(a)
Test the PMC and related components to examine the PLA RVDT in the MEC and the harness connections. Use one of these procedures: 1) Test the PMC and related components with the PMC Tester Kit 2) Test the PMC and related components with the new PMC
Resistance Tester 3) Test the PMC and related components with the alternate procedure with power cables and digital voltmeter
(b)
If the PLA RVDT check fails, replace the MEC.
(AMM 73-21-01/401).
S 865-034-C00
(12)
Shut down the opposite engine (AMM 71-00-00/201).
S 085-035-C00
(13)
Remove the rig pin no. 3 from the part power position (the hole with the mark "P") on the fuel control box.
(14)
Put the thrust levers in the idle position.
S 865-036-C00
EFFECTIVITYùùùùùùùùùùùùùùùùùùùùùùùùùùùùùù. ú
73-21-00
ALL ú ú C02 Page 514 ú Nov 15/98
BOEING PROPRIETARY - Copyright (C) - Unpublished Work - See title page for details.
////////////////////////A / /
CFM56 ENGINES
737-300/400/500/ /MAINTENANCE MANUAL ////////////////////////
S 085-037-C00
(15)
Remove the test cables and the PMC tester (or the digital voltmeter, if used) as applicable.
S 435-038-C00
(16)
Connect the electrical plug(s) P2 to the PMC electrical connector(s) J2.
S 435-039-C00
(17)
Install a protective cover on the electrical connector J5 on the PMC that was examined.
S 415-040-C00
(18)
Close the right fan cowl panel(s) (AMM 71-11-02/201).
H. PMC and Related Components Tests (PMC Tester) (Recommended Method)
NOTE: If you do not have a PMC Tester, do the test of the PMC and the
____ related components with the power cable and a digital voltmeter.
S 845-042-C00
(1) Do these steps to prepare for the PMC and related components tests:
(a)
Open the fan cowl panels (AMM 71-11-02/201).
(b)
Make sure the POWER ON switch on the PMC tester unit and the power supply for the PMC tester are in the OFF position.
(c)
Connect the PMC tester unit and the power supply to the PMC (Figure 504). 1) Connect the cables between the PMC tester and the
N2 alternator, the engine sensors, and the plug D3010.
NOTE: Make sure all the connections to the PMC testor, its
____ power supply, all pressure, temperature, speed and MEC connections are installed tight. Loose connections can give results that are not accurate.
(d)
Put the correct PMC model code in the PMC tester. 1) Use the numeric keypad.
(e)
Set the ENGLISH/METRIC switch to the applicable mode.
EFFECTIVITYùùùùùùùùùùùùùùùùùùùùùùùùùùùùùù. ú
73-21-00
ALL ú ú C03 Page 515 ú Jul 15/97
BOEING PROPRIETARY - Copyright (C) - Unpublished Work - See title page for details.
////////////////////////A / /
CFM56 ENGINES
737-300/400/500/ /MAINTENANCE MANUAL ////////////////////////
中国航空网 www.aero.cn 航空翻译 www.aviation.cn 本文链接地址：737-300 400 500 AMM 飞机维护手册 发动机燃油和控制(78)
