NOTE: The switch is on the side brace of the left main gear.
____
1) Make sure the green light for the left main gear goes off and the red light stays on.
(c) Put a steel actuator bar above the uplock sensor switch of the left main gear (S72). 1) The switch is found adjacent to the left main gear uplock
hook. 2) Make sure the red light for the left main gear goes off.
S 735-243
(33) Do the Thrust Lever/Landing Gear Warning Test again, but do a check of the light indications and horn condition for the left main gear.
NOTE: Do not do the steps to simulate the nose gear retracted.
____
EFFECTIVITYùùùùùùùùùùùùùùùùùùùùùùùùùùùùùù. ú
31-26-00
ALL ú ú 01 Page 530 ú Nov 12/00
BOEING PROPRIETARY - Copyright (C) - Unpublished Work - See title page for details.
A
737-300/400/500MAINTENANCE MANUAL
S 865-244
(34) Do the steps that follow to put the left main gear back to an extended position.
(a)
Put the landing gear lever in the DOWN position.
(b)
Remove the steel actuator bar from the uplock sensor switch of the left main gear (S72).
(c)
Remove the aluminum or copper deactuator shield from the downlock sensor of the left main gear (S71). 1) Make sure the left main gear red light on the P2 panel goes
off and the green light comes on.
S 865-245
(35) Move thrust lever No. 1 to a position of less than 33 degrees but more than 8.5 degrees from the idle position.
(a)
Make sure you do not hear the continuous horn.
(b)
Put the thrust levers back to a position of more than 33 degrees forward of the idle position.
I. Flap Position/Landing Gear Warning Test (with or without airplane jacks)
NOTE: Do the applicable Prepare-To-Test steps first.
____ S 865-246
(1)
Pressurize hydraulic systems A and B (AMM 29-15-00/202, and
AMM 27-51-00/201).
S 865-247
(2)
If the airplane is on jacks:
(a)
Remove the lockpins
(b)
Put one or all of the landing gear in a retracted position.
S 865-248
(3) If the airplane is not on jacks, put the left main gear in a simulated retracted position as follows:
(a) Put the landing gear lever in the OFF position. 1) Make sure all the red and green gear lights come on.
EFFECTIVITYùùùùùùùùùùùùùùùùùùùùùùùùùùùùùù. ú
31-26-00
ALL ú ú 01 Page 531 ú Jul 12/01
BOEING PROPRIETARY - Copyright (C) - Unpublished Work - See title page for details.
A 737-300/400/500MAINTENANCE MANUAL
(b) Put an aluminum or copper deactuator shield between the downlock sensor switch (S71) of the left main gear and the steel actuator arm.
NOTE:____ The switch is on the side brace of the left main gear.
(c) 1) Make sure the green light for the left main gear goes off. 2) Make sure the red light for the left main gear stays on.Put a steel actuator bar above the uplock sensor switch of the left main gear (S72). 1) The switch is found adjacent to the left main gear uplock hook. 2) Make sure the red light for the left main gear goes off.
(4) S 865-249Put the landing gear handle in the OFF position.
NOTE:____ The thrust levers must be in a position of more than 33 degrees forward from the idle position.
(5) S 865-250Extend the flaps to 15 units.
(6) S 865-251Move the thrust levers No. 1 and 2 to 19-24 degrees from the idle position. (a) Make sure you hear the continuous horn at thrust levers positions less than 31 degrees from the idle position.
(7) S 865-306Push the horn cutout switch on the control stand. (a) Make sure you hear the continuous horn.
(8) S 865-252Move thrust lever No. 1 forward. (a) Make sure the continuous horn is off at thrust lever positions greater than 33 degrees from the idle position.
EFFECTIVITYùùùùùùùùùùùùùùùùùùùùùùùùùùùùùù. ú 中国航空网 www.aero.cn 航空翻译 www.aviation.cn 本文链接地址：737-300 400 500 AMM 飞机维护手册 仪表 INSTRUMENTS(142)
