PULL THE BIT SWITCH TO THE
"INDICATE" POSITION.
IS THE "VSCF FAULT DETECTED" LIGHT ON?
NO
SEE SHEET 2 (BLOCK 4)
The HIGH OIL TEMP Light Comes On
Figure 102 (Sheet 1)
EFFECTIVITYùùùùùùùùùùùùùùùùùùùùùùùùùùùùùù. VARIABLE SPEED CONSTANT FREQUENCY ú
24-11-00
GENERATOR/CONVERTERS ú CONFIG 2 ú 01 Page 104 ú Jul 15/92
BOEING PROPRIETARY - Copyright (C) - Unpublished Work - See title page for details.
A 737-300/400/500MAINTENANCE MANUAL
FROM SHEET 1
(BLOCK 3)
NO
YES YES
4 DISCONNECT CONNECTOR D2510
21 DISCONNECT CONNECTOR D1086
44 FOR ENGINE 1 (ENGINE 2),
EXAMINE THE CIRCUIT FROM CON-NECTOR D2510, PIN A, TO THE
VSCF OIL OVERHEAT SENSOR,
S754, AND CONNECTOR D1086,
PIN 40 (CONNECTOR D636,
PIN 50)(WDM 24-11-11,-12).
REPAIR THE PROBLEMS THAT YOU FIND.
FROM THE VSCF OIL OVERHEAT FROM THE P5-5 MODULE. DO A SENSOR, S754. CONTINUITY CHECK BETWEEN D1086 IS THE HIGH OIL TEMP LIGHT PIN 40 AND STRUCTURE GROUND. ON? IS THERE CONTINUITY?
NO
NO
45 REPLACE THE P5-5 MODULE (WDM 24-11-11). RECONNECT D2510 AND D1086.
5 CONNECT PINS A AND C OF D2510 WITH A JUMPER.
IS THE HIGH OIL TEMP LIGHT ON?
YES
NO
The HIGH OIL TEMP Light Comes On
Figure 102 (Sheet 2)
EFFECTIVITYùùùùùùùùùùùùùùùùùùùùùùùùùùùùùù. VARIABLE SPEED CONSTANT FREQUENCY ú
24-11-00
GENERATOR/CONVERTERS ú CONFIG 2 ú 01 Page 105 ú Jul 15/92
BOEING PROPRIETARY - Copyright (C) - Unpublished Work - See title page for details.
A 737-300/400/500MAINTENANCE MANUAL
PREREQUISITE ENGINES SHUT DOWN
THE GEN DRIVE OIL TEMP GAGE SHOWS A RISE TEMPERATURE OF 0`C OR MORE THAN 20`C
YES
1
MAKE SURE THAT THE ENGINES
ARE SHUT DOWN FOR 5 MINUTES
MINIMUM. REMOVE THE VENT PLUG
AND EXAMINE THE OIL LEVEL IN
THE SIGHT GLASS OF THE VSCF.
IS THE OIL LEVEL BELOW THE "ADD" LINE?
NO
YES
2 INSTALL THE VENT PLUG. REMOVE THE FILTER ELEMENT FROM
THE FILTER IN THE GENERATOR
DRIVE OIL LINE (AMM 24-11-31/
201). EXAMINE THE FILTER FOR
LARGE METAL PARTICLES.
DOES THE FILTER ELEMENT CONTAIN LARGE METAL PARTICLES?
NO
NO
3 INSTALL THE FILTER ELE-MENT. DISCONNECT CONNECTOR D6
AT THE VSCF. MEASURE THE
RESISTANCE BETWEEN PINS 3 AND
4 OF THE J6 RECEPTACLE ON THE
VSCF.
IS THE RESISTANCE INSIDE THE LIMITS GIVEN IN FIG. 105?
YES NO
4 MEASURE THE RESISTANCE BETWEEN PINS 5 AND 6 OF THE J6
RECEPTACLE.
IS THE RESISTANCE INSIDE THE LIMITS GIVEN IN FIG. 106?
P5-5 MODULE (WDM 24-11-11).
IF THE PROBLEM CONTINUES, THEN FOR ENGINE 1 (ENGINE 2),EXAMINE THE CIRCUIT FROM CON-NECTOR D6, PINS 3,4,5, AND 6, TO THE VSCF, AND CONNECTOR D1086, PINS 32,39,38, AND 39 (CONNECTOR D636, PINS 18,17, 39 AND 17), TO THE P5-5 MODULE (WDM 24-11-11,-12).
REPAIR THE PROBLEMS THAT YOU FIND.
The GEN DRIVE OIL TEMP Gage Shows a Rise Temperature of 0`C or More Than 20`C Figure 103
EFFECTIVITYùùùùùùùùùùùùùùùùùùùùùùùùùùùùùù. VARIABLE SPEED CONSTANT FREQUENCY ú
24-11-00
GENERATOR/CONVERTERS ú CONFIG 2 ú 01 Page 106 ú Jul 15/92
BOEING PROPRIETARY - Copyright (C) - Unpublished Work - See title page for details.
A 737-300/400/500MAINTENANCE MANUAL
PREREQUISITE
IN TEMPERATURE OF TEMP GAGE SHOWS AN THE GEN DRIVE OIL MORE THAN 120`C C467 CSD CONT-2 C466 CSD CONT-1CBs: ENGINES SHUT DOWN ELECTRICAL POWER (24-22-00/201)
OF THE VSCF EXTERNAL OILCOOLER.
ARE THE PASSAGES CLEAR?
MATERIAL FROM THE AIR PASSAGES ON THE OIL COOLER.
YES
NO
2 MAKE SURE THAT THE ENGINES
ARE SHUT DOWN FOR 5 MINUTES
MINIMUM. REMOVE THE VENT PLUG
AND EXAMINE THE OIL LEVEL IN
THE SIGHT GLASS OF THE VSCF.
IS THE OIL LEVEL BETWEEN THE "FULL" LINE AND THE "ADD"LINE?
YES
中国航空网 www.aero.cn
航空翻译 www.aviation.cn
本文链接地址：737-300 400 500 AMM 飞机维护手册 电源 ELECTRICAL POWER(18)
