• 热门标签

当前位置: 主页 > 航空资料 > 机务资料 >

时间:2011-04-02 23:33来源:蓝天飞行翻译 作者:航空
曝光台 注意防骗 网曝天猫店富美金盛家居专营店坑蒙拐骗欺诈消费者

 (h)  
Set the IRS select switch to the BOTH ON R position.

 (i)  
Set these switches on the ISDU as follows. 1) Set the SYS DSPL switch to the R position. 2) Set and hold the DSPL SEL switch to the TEST position.


 NOTE: You may need to hold the switch for up to 60
____ seconds.

 a)  Make sure the WXR ATT message shows.
 3)  Release the DSPL SEL switch to the TK/GS position. a) Make sure the WXR ATT message is removed.
 4)  Set the SYS DSPL switch to the L position.
 (j)  If no more tests of the weather radar are necessary, do the Weather Radar System Shutdown Procedure.
 EFFECTIVITYùùùùùùùùùùùùùùùùùùùùùùùùùùùùùù. AIRPLANES WITH EFIS ú

 34-41-02

 ú ú 07A Page 512 ú Nov 12/01
BOEING PROPRIETARY - Copyright (C) - Unpublished Work - See title page for details.
A
737-300/400/500MAINTENANCE MANUAL
 TASK 34-41-02-735-036
 4.  Weather Radar System Shutdown Procedure_______________________________________
 A. General
 (1)  Do the weather radar system shutdown when the weather radar operational test, or system tests are done. Set the switches, controls and the circuit breakers to the shutdown configuration as follows:
 B. References
 (1)  
AMM 21-58-02/501, Equipment Cooling - Adjustment/Test

 (2)  
AMM 24-22-00/201, Manual Control - Maintenance Practices (apply power)


 C. Access
 (1)  Location Zones
 101 Control Cabin, Left
 102 Control Cabon, Right

 D. Procedure
 S 845-023
 (1)  Shut down the weather radar system as follows:
 (a)  
Set the switches on the WXR control panel as follows: 1) TEST - On (pushed) 2) GAIN - CAL 3) IDNT - Off 4) STAB - On (Pushed) 5) TILT - 0°

 (b)  
Set the controls on the EFIS control panel as follows: 1) BRT control - Midscale 2) RANGE switch - 40 3) WXR power switch - Off

 (c)  
Set the IRS select switch on the instrument switching module to NORMAL.

 (d)  
Set the L IRS and R IRS mode select switches on the mode select unit to the OFF position.

 (e)  
Set the EFI select switch on the instrument switching module to NORMAL.

 (f)  
Remove the equipment cooling if it is not necessary (AMM 21-58-02/501).


 S 865-019
 (2)  Remove the electrical power if it is not necessary
 (AMM 24-22-00/201)

 EFFECTIVITYùùùùùùùùùùùùùùùùùùùùùùùùùùùùùù. AIRPLANES WITH EFIS ú

 34-41-02
 ú ú 08A Page 513 ú Mar 12/00

BOEING PROPRIETARY - Copyright (C) - Unpublished Work - See title page for details.
A
737-300/400/500MAINTENANCE MANUAL
 WEATHER RADAR ANTENNA - REMOVAL/INSTALLATION
____________________________________________
 1.  General_______
 A.  BEJ WITH SPERRY PRIMUS 90 WXR; This procedure contains two tasks. The first task is for the removal of the weather radar antenna. The second task is the installation of the weather radar antenna. The antenna removal task has these parts.
 (1)
Open the nose radome.

 (2)
Remove the antenna.


 B.  The antenna installation task has these parts.
 (1)
Install the antenna.

 (2)
Close the nose radome.

 (3)
Do a weather radar system test.


 C.  BEJ WITH COLLINS WXR-700X WXR; This subject has six tasks which include three removal and three installation tasks. Removal tasks include the removal of the antenna, antenna flat plate and the antenna pedestal. The installation tasks include the installation of the antenna, antenna flat plate and antenna pedestal. The antenna removal task has these parts:
 (1)
Open the nose radome.

 (2)
Remove the antenna.


 D.  The removal task for the antenna flat plate has these parts:
 (1)
Open the nose radome.

 (2)
Remove the antenna flat plate.


 E.  The removal task for the antenna pedestal has these parts:
 (1)
Open the nose radome.

 (2)
Remove the antenna flat plate.
 
中国航空网 www.aero.cn
航空翻译 www.aviation.cn
本文链接地址:737-300 400 500 AMM 飞机维护手册 导航 NAVIGATION 3(81)