(2)
AIRPLANES WITHOUT EFIS;
AMM 34-11-00/501, Pitot Static System
(3)
AIRPLANES WITHOUT EFIS;
AMM 34-12-00/501, Air Data Computer System
EFFECTIVITYùùùùùùùùùùùùùùùùùùùùùùùùùùùùùù. AIRPLANES WITHOUT MODE S ú
34-53-00
ú ú 02 Page 523 ú Mar 15/96
BOEING PROPRIETARY - Copyright (C) - Unpublished Work - See title page for details.
A
737-300/400/500MAINTENANCE MANUAL
(4)
AIRPLANES WITH EFIS;
AMM 34-12-01/501, Air Data Computer System
(5)
24-22-00/201, Manual Control
D. Access
(1)
Location Zones
101/102 Flight Compartment
205 Electronic Compartment
(2)
Access Panel
1201 Electronics Equipment Access Door
E. Prepare for the System Test
NOTE: The test set is a source of interference for radio and L-band
____ radar equipment. Turn the test set off as soon as the test is completed or when other near by airplane do radio checks.
S 845-103
CAUTION: DO NOT PLACE THE REMOTE TEST SET ANTENNA CLOSER THAN 15 INCHES
_______ (.40 METERS) TO THE AIRCRAFT ANTENNA WITH THE TEST SET ON. THIS WILL CAUSE DAMAGE TO THE TEST SET.
(1)
Put the remote test set antenna between 6 and 300 feet (2 and 90 meters) from the ATC antenna for the related system.
S 845-105
(2)
Put the test set antenna in position towards the aircraft antenna.
S 845-104
(3)
Connect the coax cable from the remote test set antenna to the test set.
S 865-106
(4)
Close these circuit breakers:
(a) P6 Load Control Center Circuit Breaker Panel
1) 6D16 ATC - L
EFFECTIVITYùùùùùùùùùùùùùùùùùùùùùùùùùùùùùù. AIRPLANES WITHOUT MODE S ú
34-53-00
ú ú 03 Page 524 ú Mar 15/99
BOEING PROPRIETARY - Copyright (C) - Unpublished Work - See title page for details.
A
737-300/400/500MAINTENANCE MANUAL
(b) P18 Second Seat and Observer Circuit Breaker Panel 1) 18B2 ATC - R
S 865-107
(5) Set the PWR switch on the test set to the ON position.
NOTE: The test set is a source of interference for radio and L-band
____ radar equipment operating on the airplane and located near the test set. Turn the test set off as soon as the test is completed or when you must perform other radio checks on the airplane.
S 865-108
(6) Push the SETUP key to enter the SETUP menu.
NOTE: For information about the battery test, timing and
____ recharging refer to the operation section of the test set operators manual.
S 865-109
(7) Enter the HEIGHT and RANGE (in feet) of the ATC antenna.
(a)
Use the slew keys to change the values.
(b)
Use the select keys to change the items.
S 865-151
(8)
Enter the gain listed on the test set antenna into the GAIN_1030 and GAIN_1090 field.
S 865-152
(9)
Enter the cable loss listed on the cable in the LOSS field.
F. Test ATC system
S 865-139
CAUTION:_______DO NOT USE CODES 7500, 7600-7677, OR 7700-7777. THESE ARE THESE ARE EMERGENCY CODES.
(1)
Set the switches on ATC control panel as follows:
(a)
Transponder Select - Applicable system
(b)
Altitude Reporting - OFF
(c)
Code Select - 0000
(2)
Do the ATC system Operational Test
S 865-123
(3)
Push the AUTO TEST key on the test set.
S 715-132
(a) Make sure the results of the last auto test are shown.
EFFECTIVITYùùùùùùùùùùùùùùùùùùùùùùùùùùùùùù. AIRPLANES WITHOUT MODE S ú
中国航空网 www.aero.cn
航空翻译 www.aviation.cn
本文链接地址：737-300 400 500 AMM 飞机维护手册 导航 NAVIGATION 3(167)
