747-400 AMM 飞机维护手册 机载辅助动力 1(132)

曝光台 注意防骗 网曝天猫店富美金盛家居专营店坑蒙拐骗欺诈消费者

FUEL PUMP DRIVE PAD  OIL  1.0 CC/HR (50 DROPS/HOUR)  REPLACE THE FUEL PUMP DRIVE 
SPUR GEARSHAFT OIL SEAL 
(AMM 49-27-06/401) 
FUEL LINE SHROUD  FUEL  NONE  REFER TO CHAPTER 28 TO CORRECT 
THE FUEL LEAKAGE PROBLEM 
STARTER MOTOR  OIL  1.0 CC/HR (50 DROPS/HOUR)  REPLACE THE MAIN DRIVESHAFT OIL 
DRIVEPAD  SEAL (AMM 49-27-02/401) 
GENERATOR NO. 1 OR  OIL  1.0 CC/HR (50 DROPS/HOUR)  REPLACE THE APPLICABLE AC 
GENERATOR NO. 2  GENERATOR DRIVE OIL SEAL 
DRIVE PAD  (AMM 49-27-05/401) 
COMBUSTION CHAMBER  FUEL  DURING APU OPERATION:  NO CORRECTIVE STEPS ARE 
NONE  NECESSARY 
DURING APU USUAL SHUTDOWN: 
SOME LEAKAGE OF FUEL WHICH IS 
NOT BURNED IS SATISFACTORY 

TABLE 601

APU Drain - Inspection
Figure 601 (Sheet 2)

EFFECTIVITYùùùùùùùùùùùùùùùùùùùùùùùùùùùùùù. ú

 49-16-00
 ALL  ú
 ú  01  Page 603
 ú  Feb 18/02 

BOEING PROPRIETARY - Copyright (C) - Unpublished Work - See title page for details.
A
747-400
MAINTENANCE MANUAL

 (9)  
49-52-06/401, APU Diverter Valve Control

 C.
Access

 (1)  
Location Zone
 316 Area Aft of Stabilizer Box Compartment, RH

 D.
Procedure

 S 496-002
 (1)  
Put the 1 gallon (4 liter) container below the drain mast and the three fuselage drain outlets.

 S 866-003

 (2)
Do this task: "APU Starting and Operation" (Ref 49-11-00/201).

 S 216-004

 (3)  
Do the check of the APU drain system:

 (a)  
Let the APU engine operation become stable.

 (b)  
During the engine operation, examine the drain mast and the three drain outlets for drops of fluid.

 (c)  
Write down the length of time of the engine operation.

 (d)  
If you see drops of fluid, do these steps: 1) Identify the drain line the fluid comes out of. 2) Write down the number of drops that drain out during the

 engine operation.
 S 866-005
 (4)  Do this task: "APU Usual Shutdown" (Ref 49-11-00/201).
 NOTE: When you do the APU shutdown, fuel can drain out the fuel
____ system outlet from the flow divider/dump valve. This is a permitted shutdown condition.
 S 096-029
 (5)  
Remove the container that is below the drain mast and the three drain outlets.

 S 976-006

 (6)  
Use the engine operation time and the quantity of fluid to find the leakage rate.

 EFFECTIVITYùùùùùùùùùùùùùùùùùùùùùùùùùùùùùù. ú

 49-16-00
 ALL  ú ú 01 Page 604 ú Feb 10/91
BOEING PROPRIETARY - Copyright (C) - Unpublished Work - See title page for details.
A
747-400 MAINTENANCE MANUAL
 S 286-007
 (7)  
Make sure the leakage rate is in the permitted limits shown in Table

 601.

 (a)  
Do these steps if the leakage rate is not in the permitted limits: 1) Do this task if it is necessary: "Leakage Source Isolation"

 (Ref par. 3). 2) Do the repair steps for the leak (Ref Table 601).
 TASK 49-16-00-206-011
 3.  Leakage Source Isolation (Fig. 602)________________________
 A. General
 (1)  
Some of the drain lines connect to more than one component. You must isolate the source of the leakage if the leakage is from this type of drain line. This task isolates the source component for this type of drain line.

 B.
Standard Tools and Equipment

 (1)  
Container - 1 cup (250 cc) capacity, for fuel and oil (quantity necessary to isolate the drain sources)

 (2)  
Cylinder - With graduations, 250 cc capacity, 1 cc divisions, for fuel and oil

 C.
Access

 (1)  
Location Zone
 317 APU Compartment, LH
 318 APU Compartment, RH

 (2)  
Access Panel
 317AL APU Access Door
　
中国航空网 www.aero.cn
航空翻译 www.aviation.cn
本文链接地址：747-400 AMM 飞机维护手册 机载辅助动力 1(132)