(4)
Do a check of the rigging for the left and right deflector doors.
(a)
Make sure that the track rollers behind the deflector doors are not more than 0.60 inch from the stops.
(b)
If the track rollers are more than 0.60 inch from the stops, adjust the adjustable link until the distance is less than 0.60 inch.
S 865-171
(5)
Supply pneumatic power (AMM 36-05-00/201).
S 865-172
(6)
Open the isolation valve.
S 865-175
(7)
Disconnect the electrical connector D486 (left side) and D490 (right side) from the left and right pack valve limit switches.
NOTE: The electrical connector is on the side of the visual
____
indicator for the pack valve.
S 715-035
(8)
Make sure that the left and right turbofan valves open and the turbofans start.
(9)
Make sure that the RAM DOOR FULL OPEN lights are on.
S 865-186
(10)
Open this circuit breaker on the P6 panel and attach a DO-NOT-CLOSE tag:
S 715-040
(a) AIR/GND RELAY & LTS
S 715-060
(11) Make sure that the left and right deflector doors for the ram air inlet go to the fully closed position.
EFFECTIVITYùùùùùùùùùùùùùùùùùùùùùùùùùùùùùù. ú
21-52-00
ALL ú ú 02 Page 504 ú Nov 12/99
BOEING PROPRIETARY - Copyright (C) - Unpublished Work - See title page for details.
A
737-300/400/500MAINTENANCE MANUAL
S 715-180
(12)
Make sure that the inlet doors remain open. S 715-061
(13)
Make sure that the RAM DOOR FULL OPEN lights stay on. S 865-096
(14)
Fully retract the wing flaps with electrical or hydraulic power.
WARNING:_______ MAKE SURE THAT WHEN RETRACTING THE TRAILING EDGE FLAPS PERSONS
AND EQUIPMENT ARE CLEAR OF THE LEADING EDGE SLATS AND THE
TRAILING EDGE FLAPS. DURING RETRACTION, THE TRAILING EDGE
FLAPS CAN MOVE QUICKLY. THIS CAN CAUSE INJURY TO PERSONS AND
DAMAGE TO EQUIPMENT.
(a) Make sure that the left and right inlet modulation panels and exhaust louvers close.
NOTE: Airplanes after incorporation of SB 21-1123 do not have
____ exhaust louvers.
1) BEJ 061, 062 PRE-SB 21-1102; If the modulation panels and exhaust louvers did not close, make sure that the mach trim switch opened.
NOTE: The flaps must be fully retracted to open the mach
____ trim switch.
2) BEJ 061, 062 PRE-SB 21-1102; If the mach trim switch did not open, do a check of the system for the trailing edge flaps (Ref Chapter 27).
3) BEJ 061, 062 POST-SB 21-1102; BEJ 101-999; If the modulation panels and exhaust louvers did not close, make sure that the mach trim switch (left side) and the stall warn switch (right side) opened.
NOTE: The flaps must be fully retracted to open the
____ mach trim switch (left side) and the stall warn switch (right side).
4) BEJ 061, 062 POST-SB 21-1102; BEJ 101-999; If the mach trim switch (left side) or the stall warn switch (right side) did not open, do a check of the system for the trailing edge flaps (Ref Chapter 27).
EFFECTIVITYùùùùùùùùùùùùùùùùùùùùùùùùùùùùùù. ú
21-52-00
ALL ú ú 09 Page 505 ú Mar 12/01
BOEING PROPRIETARY - Copyright (C) - Unpublished Work - See title page for details.
A
737-300/400/500MAINTENANCE MANUAL
(b)
Make sure that the left and right turbofans stop.
(c)
Make sure that the RAM DOOR FULL OPEN lights go out.
S 225-063
(15)
AIRPLANES WITH RAM AIR EXHAUST LOUVERS (PRE-SB 21-1123); Make sure that the clearance on the left and right sides between the trailing edge louver and the adjacent louver is 0.65 to 1.00 inch (Fig. 501).
S 715-187
(16)
Do a test of the 230°F control sensor using the Controlled Heat Source:
(a)
Remove the 230°F control sensor T438 (left side) and T439 (right side) for the ram air system from the compressor discharge duct of the air cycle machines (AMM 21-52-12/401).
中国航空网 www.aero.cn
航空翻译 www.aviation.cn
本文链接地址：737-300 400 500 AMM 飞机维护手册 空调 AIR CONDITIONING 2(49)
