CES
R R Door Sill Figure 405/TASK 25-41-41-991-017
EFF : ALL Page 41525-41-41 Config-2 Aug 01/05
CES
R Tube Connections - Component Location Figure 406/TASK 25-41-41-991-019
EFF : ALL Page 41625-41-41 Config-2 Aug 01/05
CES
(4)
Remove the upper and lower attachments. R (Ref. Fig. 407/TASK 25-41-41-991-020)
(a)
Get access to the lateral avionics compartment and remove the bolt (69) and the washer (68).
(b)
Get access to the cockpit and open the flap (64) on the life vest container (61).
(c)
Loosen the fasteners (65) and remove the container.
(d)
In the wardrobe remove the screws (63) and the plate (62).
(e)
Remove the sealant from around the angle plate (74) with a SCRAPER - NON METALLIC.
(f)
Remove the screws (72), the washers (73) and the angle plate (74).
(g)
Remove the bolts (67).
(h)
Remove the quick-release pins (70).
(i)
Move the lavatory assembly to the center of the aircraft aisle.
(5)
Disconnect the electrical connections. R (Ref. Fig. 408/TASK 25-41-41-991-021)
(a)
Remove the screws (85) and the micro switch (86).
(b)
Disconnect the electrical cable (84) from the micro switch.
(c)
Remove and discard the cable ties (91).
(d)
Remove the screws (88) and the washers (89).
(e)
Make sure that the oxygen-box electrical connector (83) is disconnected.
(f)
Put blanking caps on the disconnected electrical connectors.
(g)
Carefully remove the cable assembly (84) and the terminal block
(87) through the cut out in the ceiling panel (81).
(h)
Temporarily attach the cable assembly and the terminal block to the ceiling panel.
R EFF : 001-049, 051-099, 101-149, 151-199, 25-41-41Page 417 201-210, 213-299, 301-399, 401-499, Config-2 Aug 01/05
CES
R Lower and Upper Attachments Figure 407/TASK 25-41-41-991-020- 12 (SHEET 1)
EFF : ALL Page 41825-41-41 Config-2 Aug 01/05
CES
R Lower and Upper Attachments Figure 407/TASK 25-41-41-991-020- 22 (SHEET 2)
R EFF : ALL Page 41925-41-41 Config-2 Aug 01/05
CES
R Electrical Connections - Mikro Switch Figure 408/TASK 25-41-41-991-021
R EFF : ALL Page 42025-41-41 Config-2 Aug 01/05
CES
(6) Disassemble the lavatory. R (Ref. Fig. 409/TASK 25-41-41-991-022)
(a)
Remove the sealant from around the floor pan (9) with a SCRAPER -NON METALLIC.
(b)
Remove the screws (10) and (12) and the washers (11).
(c)
Remove the lavatory assembly from the floor pan (9).
(d)
Remove the screws (6) and the washers (5).
(e)
Remove the cap (8) and the screw (7).
(f)
Remove the screws (4) and the washers (3).
(g)
Divide the lavatory subassemblies (1) and (2).
(h)
Remove the lavatory subassemblies from the aircraft.
(i) Remove the stepladder.
**ON A/C 211-212,
Subtask 25-41-41-020-058-C
E. Removal of the Lavatory A
(1)
Remove the door sill. R (Ref. Fig. 405/TASK 25-41-41-991-017)
(a)
Remove the screws (7) and the door sill (8).
(b)
Remove the old sealant with a SCRAPER - NON METALLIC.
(2)
Disconnect the electrical connector 7200VC-A. R (Ref. Fig. 405/TASK 25-41-41-991-017)
(a)
Remove the access panel (1)
-
Remove the cap and remove the rivets with a DRILL DIA 1/128 IN.
-
Remove the access panel (1) from the lining (3).
(b)
Disconnect the electrical connector 7200VC-A (2).
(c)
Put blanking caps on the disconnected electrical connectors.
(3) Disconnect the air supply connections.
(a)
Put the STEPLADDER 1.0 M (3.3 FT) in position.
中国航空网 www.aero.cn
航空翻译 www.aviation.cn
本文链接地址：A320飞机维护手册 AMM EQUIPMENT/FURNISHINGS 设备3(71)
