R (5) Remove the Lower Attachments
R (Ref. Fig. 404A/TASK 25-33-41-991-013-B)
R WARNING : SUPPORT THE UNIT/ASSEMBLY OR IT WILL FALL AND BECOME_______
R DAMAGED OR INJURE PERSONNEL. THE UNIT/ASSEMBLY IS HEAVY.
R (a) Remove the screws (2) and the covers (1).
R (b) Remove the bolts (3), the washers (4) and the nuts (10).
R (c) Remove the eccentric bushes (6) and the eccentric plugs (7).
R (d) Prevent damage to the component interface and the adjacent area.
R (e) Carefully lift the galley off the blocks (13) and move it to the
R center of the aircraft.
R (f) Remove the shims (14).
R NOTE : Identify the position and number of the shims for the____
R installation procedure.
R (g) Remove the bolts (8) and the washers (9).
R (h) Remove the blocks (13).
R (i) Remove and discard the packings (12).
R (j) Remove the bushes (11).
R Subtask 25-33-41-020-052-C
R B. Disconnect the Galley Splitline
R NOTE : This procedure is only necessary if you must remove the galley____
R from the cabin.
R NOTE : The galley splitline screws and bolts are painted red.____
R (1) Disconnect the Splitline Supply Connections
R (Ref. Fig. 406/TASK 25-33-41-991-032-A)
R (a) Disconnect the ring (11) from the drain cable (10) and the drain
R valve (12).
R (b) Remove the clamp (5) and disconnect the drain pipe (6) from the
R sink (4).
CES
R R Spliline Connections - G5 Figure 405A/TASK 25-33-41-991-014-B
R EFF : 051-099, 25-33-41 Page 435 May 01/05
CES
R Splitline Connections - G5 Figure 405B/TASK 25-33-41-991-014-A12 (SHEET 1)
EFF : 151-199, 25-33-41 Page 436 May 01/05
CES
R Splitline Connections - G5 Figure 405B/TASK 25-33-41-991-014-A22 (SHEET 2)
EFF : 151-199, 25-33-41 Page 437 May 01/05
CES
R R Splitline - Supply Connections Figure 406/TASK 25-33-41-991-032-A
R EFF : 051-099, 25-33-41 Page 438 May 01/05
CES
R (c) Remove the clamp (2) and disconnect the exhaust-air hose (3) from
R the manifold (1).
R (d) Remove the clamp (8) and disconnect the drain pipe (9) from the
R pipe (7).
R (e) Loosen the nut (14) and disconnect the potable water pipe (15)
R from the fittings (13).
R (f) Put blanking plugs on the disconnected line ends.
R (2) Disconnect the Splitline Electrical Connections
R (Ref. Fig. 407/TASK 25-33-41-991-031-A)
R (a) Remove the bolts (5), the washers (4) and the clamps (3).
R (b) Disconnect the elctrical connectors (2) from the receptacles (1).
R (c) Disconnect the electrical connectors (6) from the junction
R receptacle (7).
R (d) Put blanking caps on the disconnected electrical connectors.
R (3) Disconnect the Galley at the Splitline
中国航空网 www.aero.cn
航空翻译 www.aviation.cn
本文链接地址:A320飞机维护手册 AMM EQUIPMENT/FURNISHINGS 设备3(21)