737-300 400 500 AMM 飞机维护手册 EQUIPMENT/FURNISHINGS(68)

曝光台 注意防骗 网曝天猫店富美金盛家居专营店坑蒙拐骗欺诈消费者

 (4)  S 422-071Push the inboard edge of the spacer panel outboard and upward until the cam latches engage the bin rail.
 (5)  S 422-072Do these steps at the same time to clip the inboard spring clip over the termination panel wall: (a) Apply a downward force to the inboard corner of the termination panel from above. (b) Push the inboard corner of the panel slider toward the termination panel until the spring clip is aligned to grasp the wall.
 (6)  S 422-073Push the termination panel up against the bin end cap and push the spacer panel base toward adjacent panel to close the remaining gaps.

 EFFECTIVITYùùùùùùùùùùùùùùùùùùùùùùùùùùùùùù. ú

 25-23-61
 ALL  ú ú 01 Page 211 ú Jul 15/94
BOEING PROPRIETARY - Copyright (C) - Unpublished Work - See title page for details.
A
737-300/400/500MAINTENANCE MANUAL
 S 422-074
 (7)
ALign retaining block of termination panel and tighten wing nut.

 S 422-075

 (8)  
Apply upward pressure to the panel base under the cam latches to fully engage the latches.

 NOTE: The latches will generally make a "click" sound upon full
____
 engagement.

 TASK 25-23-61-822-032
 12. PSUs Adjustment (Fig. 201)
_______________
 A. Access
 (1)  Location Zone
 100 Upper Half of Fuselage

 B. Procedure
 S 822-033
 (1)  Adjust the PSUs
 (a)  
Lower the PSUs and the adjacent spacer panels.

 (b)  
Disengage the index pin on the support clamp from the index hole on the air outlet extrusion.

 (c)  
Move the outboard support clamps and the PSUs forward or aft to install the PSUs at the necessary position.

 (d)  
Engage the index pin on the support clamp with the index hole in the air duct outlet

 NOTE: The forward end of the PSUs is 28.00 |4.00 inches
____ forward of the lines between the seat cushion and the seat back.
 CAUTION: PUT THE WIRE-BUNDLE/GASPER-HOSE BRACKET 7 1/2 | 4
_______ INCHES FORWARD OF THE AFT EDGE OF THE PSU's PANEL. THE WIRE-BUNDLE/GASPER-HOSE BRACKET WILL CUT THE OXYGEN HOSE IF THE BRACKET IS PUT ADJACENT TO THE OXYGEN GENERATOR.
 (e)  
Attach the wire-bundle/gasper-hose bracket 7 1/2 | 4 inches forward of the aft edge of the PSUs panel.

 (f)  
Make sure the PSUs is not twisted or free to move when the unit is in the closed position. 1) Make sure the cold air hose does not have kinks or too much

 bend.

 (g)  
If it is necessary, move the wire bundle, or the cold air hose to a new outlet along the sidewall.

 (h)  
Lift the adjacent spacer panels. 1) Retract and latch the PSUs in the closed position.

 EFFECTIVITYùùùùùùùùùùùùùùùùùùùùùùùùùùùùùù. ú

 25-23-61
 ALL  ú ú 01 Page 212 ú Jul 15/94
BOEING PROPRIETARY - Copyright (C) - Unpublished Work - See title page for details.
A
737-300/400/500MAINTENANCE MANUAL
 S 822-034
 (2)  Adjust the clearance between the PSUs and the overhead stowage bin
 (a)  
Close and latch the PSUs and the adjacent spacer panels if they are open.

 (b)  
Put a 1/8-inch Allen wrench into the latch adjustment bolt.

 NOTE: Get access through the access hole in the inboard
____ corners of the unit and in the bottom of the latch.
 Be careful not to cause scratches on the surface around the latch access hole of the PSUs.
 (c)  
Turn the bolt to lift or lower the unit, if it is necessary to align the clearance correctly.

 (d)  
Remove the wrench.

 EFFECTIVITYùùùùùùùùùùùùùùùùùùùùùùùùùùùùùù. ú

 25-23-61
 ALL  ú ú 01 Page 213 ú Jul 15/94
BOEING PROPRIETARY - Copyright (C) - Unpublished Work - See title page for details.
A
737-300/400/500MAINTENANCE MANUAL
 PASSENGER CABIN PARTITIONS AND COMPARTMENTS -
　
中国航空网 www.aero.cn
航空翻译 www.aviation.cn
本文链接地址：737-300 400 500 AMM 飞机维护手册 EQUIPMENT/FURNISHINGS(68)