• 热门标签

当前位置: 主页 > 航空资料 > 机务资料 >

时间:2011-04-01 19:06来源:蓝天飞行翻译 作者:航空
曝光台 注意防骗 网曝天猫店富美金盛家居专营店坑蒙拐骗欺诈消费者

 1.  General_______
 A.  Each escape slide assembly has these components:
 (1)  
an escape slide pack

 (2)  
an escape slide compartment

 (3)  
two floor brackets.


 B.  The escape slide assemblies are installed on the lower inboard face of each entry and galley service door.
 C.  Two floor brackets are attached to the floor inboard of the doorway.
 D.  The escape slide pack has these components:
 (1)  
an escape slide

 (2)  
a detachable girt

 (3)  
a girt bar

 (4)  
an air bottle


 E.  The air bottle holds high-pressure gas to inflate the slide.
 F.  The compartment holds the slide pack in the folded position and opens when the slide is used.
 2.  Operation (Fig. 1)_________
 A.  Prepare and inflate the escape slide.
 (1)  
Install the slide assembly with the door closed.

 (2)  
To arm the slide, remove the girt bar from the stowage hooks on the door and install it in the floor brackets.

 (3)  
Open the door as usual but do not hesitate until it is fully open.

 (4)  
The girt will extend while you open the door.

 (5)  
As you open the door, the conection between the girt and the latch will pull tight, and unlatch the compartment.

 (6)  
When the door is almost fully open, the slide pack will pull down and out of the compartment.

 (7)  
The slide will fully inflate in approximately six seconds.

 (8)  
If the slide does not inflate automatically, pull the inflation handle sharply to inflate the slide manually.

 (9)  
To remove the slide from the airplane, lift the flap and pull the ditching handle.


 EFFECTIVITYùùùùùùùùùùùùùùùùùùùùùùùùùùùùùù. ú

 25-61-35
 ALL  ú ú 02 Page 1 ú Nov 15/92
BOEING PROPRIETARY - Copyright (C) - Unpublished Work - See title page for details.
A 737-300/400/500MAINTENANCE MANUAL
SLIDE COMPARTMENT 
DOOR 
CLOSED  PRESSURE GAGE 
STOWAGE HOOKS 
COMPARTMENT 
DOOR 
GIRT  STOWAGE HOOKS 
BAR 
FLOOR 
BRACKET  FLOOR 
(2 LOCATIONS)  BRACKET  GIRT 
1. INSTALL THE SLIDE ASSEMBLY WITH (2 LOCATIONS)  BAR 
THE DOOR CLOSED. 
2. TO ARM THE SLIDE, REMOVE THE 
GIRT BAR FROM THE STOWAGE HOOKS 
ON DOOR AND INSTALL IT IN THE 
FLOOR BRACKETS. 
3. OPEN THE DOOR AS USUAL BUT 
DO NOT HESITATE UNTIL THE 
DOOR IS FULLY OPEN. 
DOOR 
COMPARTMENT 
COVER 

SLIDE COMPARTMENT
SLIDE
GIRT
PACK
4. THE GIRT WILL EXTEND WHILE  5. AS YOU OPEN THE DOOR, THE CONNECTION
YOU OPEN THE DOOR.  BETWEEN THE GIRT AND THE LATCH WILL PULL TIGHT, AND UNLATCH THE COMPARTMENT.
Escape Slide Operation Figure 1 (Sheet 1)
EFFECTIVITYùùùùùùùùùùùùùùùùùùùùùùùùùùùùùù. ú

 25-61-35
 ALL  ú ú 02 Page 2 ú Nov 15/92
BOEING PROPRIETARY - Copyright (C) - Unpublished Work - See title page for details.
A

737-300/400/500
MAINTENANCE MANUAL

OPEN DOOR
TOP OF 
DOOR  SLIDE 
SLIDE 
COMPARTMENT 

7. THE SLIDE WILL FULLY INFLATE IN APPROXIMATELY SIX SECONDS.
GIRT
SLIDE 
BAR  PACK 
6. WHEN THE DOOR IS ALMOST FULLY OPEN, THE 
SLIDE PACK WILL PULL DOWN AND OUT OF THE 
COMPARTMENT. 
OPEN DOOR 
FLAP 
SEE  A 
SLIDE 

OPEN DOOR
INFLATION 9. TO REMOVE THE SLIDE FROM THE AIRPLANE, HANDLE LIFT THE FLAP AND PULL THE DITCHING HANDLE.
SLIDE
DETACHABLE GIRT
8. IF THE SLIDE DOES NOT INFLATE AUTOMATICALLY, PULL THE INFLATION HANDLE SHARPLY TO INFLATE THE SLIDE MANUALLY.
FLAP
NOTE:YOU MUST PULL THE HANDLE WITH ITS CABLEFREE FROM THE SLIDE (DISCARD THE HANDLE).
A
Escape Slide Operation Figure 1 (Sheet 2)
 
中国航空网 www.aero.cn
航空翻译 www.aviation.cn
本文链接地址:737-300 400 500 AMM 飞机维护手册 EQUIPMENT/FURNISHINGS(146)