• 热门标签

当前位置: 主页 > 航空资料 > 机务资料 >

时间:2011-03-26 14:47来源:蓝天飞行翻译 作者:admin
曝光台 注意防骗 网曝天猫店富美金盛家居专营店坑蒙拐骗欺诈消费者

 WARNING : USE THE CORRECT PERSONAL PROTECTION.

_______ OIL CAN HAVE ADDITIVE CALLED TRICRESYL PHOSPHATE IN IT. THIS CHEMICAL IS AN ASPHYXIANT, IT IS POISONOUS AND CAN BE ABSORBED THROUGH THE SKIN. USE CARE WHEN ENGINE OIL IS DRAINED. HOT OIL CAN POSSIBLY CAUSE BAD BURNS.
 CAUTION : MAKE SURE THAT ALL PLUMBING IS FREE FROM OBSTRUCTION.
_______
 (1)
 Do an oil level check on the oil sight glass (3). NOTE : If the oil level is at the FULL mark on the oil sight glass

____ (3), do not add oil to the APU oil reservoir.

 (2)
 Put the container in position below the APU gear box to collect oil leakage or overflow.

 (3)
 Make sure that the oil scupper (1) and the oil filler cap (2) are clean. Clean them with a lint-free cloth, if they are dirty.

 (4)
 Remove the overflow port cover (5) and connect the overflow drain hose to the overflow port (4). Put the hose end into the oil container.

 (5)
 Open the oil filler cap (2). WARNING : BE CAREFUL WHEN YOU DRAIN THE ENGINE OIL AND/OR LOOSEN THE


_______ FILLER CAP. HOT OIL CAN SPILL PAST THE FILLER CAP WHEN THE OIL LEVEL IS ABOVE THE 'ADD' RANGE (MARKED ON THE SIGHT GLASS).
 CAUTION : MAKE SURE THAT ALL PLUMBING IS FREE FROM OBSTRUCTION.
_______
 (a) Open the lock and slowly loosen the oil filler cap (2) to release remaining pressure from the oil reservoir.


 Oil Servicing
 Figure 301/TASK 49-90-00-991-001

 CES


 Guideline for the Oil Consumption of the APU GTCP 36-300 in Service Figure 302/TASK 49-90-00-991-004

R EFF : 001-003, 051-099, 401-499, 49-90-00Page 307 Config-1 Aug 01/05
 CES


 (b) Remove the oil filler cap and dry it with a lint-free cloth.
 (6) Add the oil
 WARNING : PUT THE OIL INTO THE GRAVITY-FILL PORT SLOWLY. THIS WILL

_______ PREVENT A BLOW-BACK OF HOT OIL WHICH CAN BURN YOU.
 CAUTION : DO NOT FILL THE GEARBOX ABOVE THE FULL MARK ON THE SIGHT
_______ GLASS. DURING APU OPERATION THE OIL EXPANDS WHICH COULD CREATE AN OVER-FILLED CONDITION RESULTING IN LEAKAGE AND POSSIBLE OIL SMELL IN THE CABIN.
 CAUTION : USE ONLY APPROVED TYPES/BRANDS OF LUBRICANTS. DO NOT MIX
_______
 TYPES//BRANDS OF LUBRICANTS.

 (a)
 Make sure that the oil-can(s) is(are) clean and the oil does not contain unwanted materials.

 (b)
 Carefully add the oil until the oil level in the oil reservoir is at the FULL mark on the oil sight glass (3), or until oil flows from the overflow (4).


 NOTE : If you want to change/mix the oil brands:
____ (Ref. TASK 49-90-00-600-002) or (Ref. TASK 49-90-00-600-002).
 (7)
 Install and lock the oil filler cap (2).
 NOTE : Make sure that the oil filler cap is tight and locked


____
 correctly.


 (8)
 Wait until oil stops flowing from the overflow hose, then remove the overflow hose from the port (4) and install the cover (5).

 (9)
 Remove the oil from the oil scupper and make it dry with a lint-free cloth.


 (10)
 Remove the container.

 (11)
 If oil fell on the APU, the air intake duct and/or the adjacent area, remove it and make the area dry with a lint-free cloth.

 (12)
 If applicable, make an entry in the necessary log(s) to tell people that you have added oil to the APU oil reservoir.

 


 Subtask 49-90-00-612-051
 B. Check Oil Level and Replenish (Pressure Fill Procedure)
 WARNING : USE THE CORRECT PERSONAL PROTECTION.

_______ OIL CAN HAVE ADDITIVE CALLED TRICRESYL PHOSPHATE IN IT. THIS CHEMICAL IS AN ASPHYXIANT, IT IS POISONOUS AND CAN BE ABSORBED THROUGH THE SKIN. USE CARE WHEN ENGINE OIL IS DRAINED. HOT OIL CAN POSSIBLY CAUSE BAD BURNS.
 CAUTION : MAKE SURE THAT ALL PLUMBING IS FREE FROM OBSTRUCTION.
_______
 (1)
 Do an oil level check on the oil sight glass (3). NOTE : If the oil level is at the FULL mark on the oil sight glass,

____
 do not add oil to the APU oil reservoir.


 (2)
 Put the container in position below the gearbox to collect oil leakage.

 (3)
 Put the TANK - ENGINE OIL FILLING UP in position below the APU gearbox.

 (4)
 Make sure that the TANK - ENGINE OIL FILLING UP is in the correct condition.


 CAUTION : USE ONLY APPROVED TYPES/BRANDS OF LUBRICANTS. DO NOT MIX
_______
 TYPES//BRANDS OF LUBRICANTS.

 (a) Make sure that the TANK - ENGINE OIL FILLING UP is filled with clean oil which is of the same type and brand than the oil which is in the APU oil reservoir.
 
中国航空网 www.aero.cn
航空翻译 www.aviation.cn
本文链接地址:A320飞机维护手册 AMM 机载辅助动力 AIRBORNE AUXILIARY POWER 6(58)