_________
(Ref. Fig. 401/TASK 49-94-14-991-003) Subtask 49-94-14-020-052
A. Removal of the Low Oil Pressure (LOP) Switch
(1)
Disconnect the electrical connection (1).
(2)
Put blanking caps on the disconnected electrical connectors.
(3)
Put a container in position below the gearbox.
(4)
Loosen the nut (4) that secures the LOP switch (2) in the gearbox.
(5)
Remove the LOP switch (2) from the gearbox.
(6)
Remove and discard the O-ring (3).
(7)
Put a blanking plug in the gearbox port.
R EFF : 001-049, 101-105, 107-107, 151-199, 49-94-14Page 403 201-210, Config-2 Aug 01/05
CES
Low Oil Pressure Switch
Figure 401/TASK 49-94-14-991-003
CES
TASK 49-94-14-400-003
Installation of the Low Oil Pressure Switch (8091KM) (131-9(A))
1. Reason for the Job
__________________
Self Explanatory
2. Job Set-up Information
______________________
A. Fixtures, Tools, Test and Support Equipment
-------------------------------------------------------------------------------REFERENCE QTY DESIGNATION -------------------------------------------------------------------------------
No specific container 2 l (0.5283 USgal)
B. Consumable Materials
-------------------------------------------------------------------------------REFERENCE DESIGNATION -------------------------------------------------------------------------------
Material No. 03-002 GB DEF-STAN 91-101 LUBRICATING OIL TURBINE ENGINE SYNT BASE (Ref. 20-31-00)
C. Expendable Parts
-------------------------------------------------------------------------------FIG.ITEM |DESIGNATION |IPC-CSN -------------------------------------------------------------------------------
packing 49-94-09 01 -030
R EFF : 001-049, 101-105, 107-107, 151-199, 49-94-14Page 405 201-210, Config-2 Aug 01/05
CES
D. Referenced Information
-------------------------------------------------------------------------------REFERENCE DESIGNATION -------------------------------------------------------------------------------
24-42-00-861-001 Energize the Ground Service Network from the External Power 24-42-00-862-001 De-energize the Ground Service Network Supplied from the External Power 29-00-00-864-001 Put the Related Hydraulic System in the Depressurized Configuration before Maintenance Action 29-14-00-614-002 Pressurization of the Hydraulic Reservoirs through
the Ground Connector 49-00-00-860-008 APU Start by External Power (131-9(A)) 49-00-00-860-009 APU Shutdown by External Power (131-9(A)) 49-90-00-600-007 Check and Replenish Oil Level (131-9(A)) 52-41-00-010-001 Open the APU Doors for Access 52-41-00-410-001 Close the APU Doors after Access 49-94-14-991-003 Fig. 401
3. Job Set-up
__________
Subtask 49-94-14-860-057
A. Aircraft Maintenance Configuration
(1)
Energize the ground service network
(Ref. TASK 24-42-00-861-001).
(2)
On the panel 25VU make sure that the APU MASTER SW p/bsw is OFF.
(3)
Make sure that there is a warning notice in the cockpit to tell persons not to start the APU.
(4)
Make sure that hydraulic systems are depressurized
(Ref. TASK 29-00-00-864-001).
(5)
Make sure that the access platform is in position below the APU compartment.
(6)
Make sure that the APU access doors are open (Ref. TASK 52-41-00-010-001).
(7)
Make sure that the LIGHT SW 11LJ is set to the ON position.
(8)
Make sure that the container is in position below the LOP switch.
R EFF : 001-049, 101-105, 107-107, 151-199, 49-94-14Page 406 201-210, Config-2 Aug 01/05
CES Subtask 49-94-14-865-059
B. Make sure that this(these) circuit breaker(s) is(are) open, safetied and tagged
-------------------------------------------------------------------------------PANEL DESIGNATION IDENT. LOCATION -------------------------------------------------------------------------------121VU APU/APU/CTL 2KD L42 121VU APU/ECB/SPLY 1KD L41
Subtask 49-94-14-010-054
C. Make sure that the APU access doors 315AL and 316AR are open.
4. Procedure
_________ (Ref. Fig. 401/TASK 49-94-14-991-003) Subtask 49-94-14-420-052
A. Installation of the Low Oil Pressure (LOP) Switch
(1)
Apply a layer of lubricant OILS (Material No. 03-002) to the new packing (3).
中国航空网 www.aero.cn
航空翻译 www.aviation.cn
本文链接地址：A320飞机维护手册 AMM 机载辅助动力 AIRBORNE AUXILIARY POWER 6(180)
