EFFECTIVITYùùùùùùùùùùùùùùùùùùùùùùùùùùùùùù. ú
32-45-00
ALL ú ú 02 Page 611 ú Mar 12/00
BOEING PROPRIETARY - Copyright (C) - Unpublished Work - See title page for details.
A 737-300/400/500MAINTENANCE MANUAL
SIDEWALL SEPARATION
TIRES WITH BLISTERS OR BULGES IN THE SIDEWALL ARE NOT SERVICEABLE. REMOVE TIRE IMMEDIATELY.
TREAD SEPARATION
TIRES WITH BLISTERS OR BULGES IN THE TREAD ARE NOT SERVICEABLE. REMOVE TIRE IMMEDIATELY.
Tire Wear/Damage Conditions
Figure 602 (Sheet 7)
EFFECTIVITYùùùùùùùùùùùùùùùùùùùùùùùùùùùùùù. ú
32-45-00
ALL ú ú 02 Page 612 ú Mar 12/00
BOEING PROPRIETARY - Copyright (C) - Unpublished Work - See title page for details.
A 737-300/400/500MAINTENANCE MANUAL
NEW TIRE (REF) NEW TIRE (REF)
TIRE SHOULD BE REMOVED IF BLISTERS OR CRACKS ARE FOUND IN A GROOVE BOTTOM WHICH EXPOSES FABRIC
SHOULDER WEAR CONDITIONS
Tire Wear/Damage Conditions
Figure 602 (Sheet 8)
EFFECTIVITYùùùùùùùùùùùùùùùùùùùùùùùùùùùùùù. ú
32-45-00
ALL ú ú 02 Page 613 ú Mar 12/00
BOEING PROPRIETARY - Copyright (C) - Unpublished Work - See title page for details.
A
737-300/400/500MAINTENANCE MANUAL
MAIN GEAR WHEEL AND TIRE - REMOVAL/INSTALLATION
_______________________________________________
1. General
A. This procedure tells you how to remove and install the wheel and tire assembly of the main landing gear.
TASK 32-45-11-004-001
2. Main Gear Wheel Removal (Fig. 401)
_______________________
A. Special Tools and Equipment
(1)
F72913-14 - Thread Protector, Main Landing Gear
(2)
F72913-8 - Axle Protector, Main Landing Gear
(3)
F80168-3 - Socket, Axle Nut
B.
Standard Tools and Equipment
(1)
Dolly - Wheel Change, commercially available
C.
References
(1)
AMM 07-11-31/201, Airplane Jacking
(2)
AMM 32-00-01/201, Ground Locks
(3)
AMM 32-45-00/201, Tires and Wheels
D.
Access
(1)
Location Zone
101 Control Cabin - Left
102 Control Cabin - Right
310 Left Main Landing Gear
410 Right Main Landing Gear
E.
Procedure
S 494-002
(1)
Make sure you install the ground locks in all the landing gear (AMM 32-00-01/201).
S 844-003
(2)
Set the parking brake.
NOTE: When you set the parking brakes, the brake rotors will be
____ aligned for wheel installation. If the brake disks are not aligned when the brake pressure is off, you need to align the brake rotors before you install the wheel.
S 844-004
WARNING: IT IS RECOMMENDED THAT YOU REMOVE ONLY ONE WHEEL AND TIRE
_______ ASSEMBLY FROM THE MAIN LANDING GEAR AT A TIME. IF YOU REMOVE THE TWO WHEEL AND TIRE ASSEMBLIES AT THE SAME TIME, STRUCTURAL DAMAGE AND INJURY TO PERSONS CAN OCCUR IF THE AIRPLANE FALLS.
(3) Lift the wheel and tire assembly with jacks until it is clear of the ground (AMM 07-11-11/201).
EFFECTIVITYùùùùùùùùùùùùùùùùùùùùùùùùùùùùùù. ú
32-45-11
ALL ú ú 02 Page 401 ú Mar 15/98
BOEING PROPRIETARY - Copyright (C) - Unpublished Work - See title page for details.
A 737-300/400/500MAINTENANCE MANUAL
BRAKE
ASSEMBLY
AXLE SLEEVE
A
AXLE FWD
A
RETAINING RING SEE A
OUTER WHEEL BEARING INNER GREASE SEAL
AXLE NUT INNER WHEEL RETAINER RING BEARING
中国航空网 www.aero.cn
航空翻译 www.aviation.cn
本文链接地址：737-300 400 500 AMM 飞机维护手册 起落架 LANDING GEAR 3(106)
