• 热门标签

当前位置: 主页 > 航空资料 > 机务资料 >

时间:2011-04-02 16:53来源:蓝天飞行翻译 作者:航空
曝光台 注意防骗 网曝天猫店富美金盛家居专营店坑蒙拐骗欺诈消费者

 (8)  Tighten the bleeder valve to 40 pound-inches and install the bleed
 screw and the washer.
 S 842-034
 (9)  Remove the lockwire on the bypass lever of the hydraulic fuse that
 you do a test on.
 NOTE:____ The Decoto hydraulic fuse does not have lockwire installed on
 the lever.

 S 722-035
 (10)
 Move the bypass lever to the open position and hold it open for a minimum of five seconds.

 S 842-036

 (11)
 Release the bypass lever on the fuse, allow the lever to go back to the closed position and install the lockwire.


 NOTE: The Decoto hydraulic fuse does not have lockwire installed on
____ the lever.
 S 722-037
 (12)
 Do the test at each of the four brake locations.

 S 722-038

 (13)
 Make sure that the quantity of fluid collected in the container from all four brakes is not more than 1.50 gallons.

 S 842-039

 (14)
 Fill the hydraulic reservoir of system B (AMM 12-12-00/301).


 EFFECTIVITYùùùùùùùùùùùùùùùùùùùùùùùùùùùùùù. ú

 32-41-00
 ALL  ú ú 01 Page 206 ú Jul 15/92
BOEING PROPRIETARY - Copyright (C) - Unpublished Work - See title page for details.
A
737-300/400/500MAINTENANCE MANUAL
 F. Alternate Brake System Test
 S 842-040
 (1)  
Remove the screw from the end of the bleed fitting on the brake and install the bleed hose in the end of the fitting.

 S 492-041

 (2)  
Put a container (with a minimum capacity of two U.S. gallons) below the bleed fitting of the brake to make sure that the fluid will drain directly into the container.

 S 842-042

 (3)
Remove the pressure from hydraulic system B (AMM 29-15-00/201).

 S 842-043

 (4)  
Push the brake pedals to the maximum position to apply full brake pressure.


 NOTE: The parking brake can be used to keep the brake pedals pushed
____
 during the check.

 S 722-044
 (5)  
While full brake pressure is applied, open the brake bleeder valve and let the fluid drain into the container until the flow stops.

 S 722-045

 (6)  
Make sure that the quantity collected in the container is
 42-80 cubic inches or approximately 0.18 to 0.35 gallons.


 (7)  
Close the bleeder valve and remove the bleed hose.

 S 432-047

 (8)  
Tighten the bleeder valve to 40 pound-inches and install the bleed screw and the washer.


 S 842-046
 EFFECTIVITYùùùùùùùùùùùùùùùùùùùùùùùùùùùùùù. ú

 32-41-00
 ALL  ú ú 01 Page 207 ú Mar 15/92
BOEING PROPRIETARY - Copyright (C) - Unpublished Work - See title page for details.
A
737-300/400/500MAINTENANCE MANUAL
 S 842-048
 (9)  Remove the lockwire on the bypass lever of the hydraulic fuse that you do a test on.
 NOTE: The Decoto hydraulic fuse does not have lockwire installed on
____
 the lever.

 S 722-049
 (10)
 Move the bypass lever to the open position and hold it open for a minimum of five seconds.

 S 842-050

 (11)
 Release the bypass lever on the fuse, allow the lever to go back to the closed position and install the lockwire.


 NOTE: The Docoto hydraulic fuse does not have lockwire installed on
____
 the lever.

 S 722-051
 (12)
 Do the test at one brake on each main landing gear.

 S 722-052

 (13)
 Make sure that the quantity of the fluid collected in the container from the two brakes is not more than 0.70 gallons.

 (14)
 Fill the system A reservoir (AMM 12-12-00/301).

 (15)
 Put the airplane back to its usual condition.


 S 842-053
 S 842-054
 EFFECTIVITYùùùùùùùùùùùùùùùùùùùùùùùùùùùùùù. ú
 
中国航空网 www.aero.cn
航空翻译 www.aviation.cn
本文链接地址:737-300 400 500 AMM 飞机维护手册 起落架 LANDING GEAR 3(10)