• 热门标签

当前位置: 主页 > 航空资料 > 机务资料 >

时间:2011-04-13 08:00来源:蓝天飞行翻译 作者:航空
曝光台 注意防骗 网曝天猫店富美金盛家居专营店坑蒙拐骗欺诈消费者

A
747-400 MAINTENANCE MANUAL
 TASK 34-43-07-004-014
 3.  FREIGHTERS; Waveguide Switch Removal (Fig. 401A)________________________
 A.  General
 (1)  The waveguide switch is attached to the waveguide switch support below the floor compartment between station 180 and 200. To remove the waveguide switch you must electrically and mechanically disconnect it.
 B.  Access
 (1)  Location Zone
 112 Freighter Main Deck-Nose to First Door,Left
 C.  Procedure
 S 864-015
 (1) Open these circuit breakers and attach DO-NOT-CLOSE tags:
 (a)  P7 Overhead Circuit Breaker Panel
 1) 7C7 WXR L RT
 2) 7C19 WXR R RT

 S 014-016
 (2) Get access to the waveguide switch below the compartment floor.
 (a)  
Release the 18 fasteners that hold the cargo floor panel.

 (b)  
Remove the cargo floor panel.


 S 024-017
 (3)  Remove the waveguide switch.
 (a)  
Disconnect the electrical connector DB139 on the waveguide switch.

 (b)  
Remove the four screws, washers and a gasket that attach the left feeder waveguide to the waveguide switch.

 (c)  
Remove the four screws, washers and a gasket that attach the right feeder waveguide to the waveguide switch.

 (d)  
Hold the waveguide switch and remove four screws and lockwashers from waveguide section 4 that mates with the waveguide switch.


 NOTE: The screws go through the holes in the waveguide switch
____ support bracket into the waveguide switch.
 EFFECTIVITYùùùùùùùùùùùùùùùùùùùùùùùùùùùùùù. ú

 34-43-07
 ALL  ú ú 05B Page 406 ú Feb 18/00
BOEING PROPRIETARY - Copyright (C) - Unpublished Work - See title page for details.
A
747-400 MAINTENANCE MANUAL
 (e)  Remove the waveguide switch from the waveguide switch support.
 S 024-074
 (4)  
Put dust caps on the electrical connectors.

 S 024-075

 (5)  
Put dust caps on the waveguide flanges.


 TASK 34-43-07-404-020
 4.  PASSENGER AIRPLANES; Waveguide Switch Installation (Fig. 401)_____________________________
 A.  General
 (1)  The waveguide switch is installed on the rear of the R/T mount that is attached to the E30 equipment rack (E30 rack). Access to the E30 rack is through the right crawlway forward of the main equipment center.
 B.  References
 (1)  
AMM 06-09-01/201, Body Section 41 Access Doors and Panels

 (2)  
AMM 24-22-00/201, Manual Control

 (3)  
AMM 24-29-01/401, Main Static Inverter

 (4)  
AMM 34-43-00/501, Weather Radar System

 (5)  
AMM 34-43-02/401, Weather Radar Receiver/Transmitter


 C.  Access
 (1)  
Location Zones 116 Area Between Nose Gear Well and Fuselage, RH

 (2)  
Access Panels
 117A Electronics Compartment Access Door

 

 D.  Procedure
 S 864-021
 (1)  
Make sure these circuit breakers are open with the DO-NOT-CLOSE tags attached:

 (a)  
P7 Overhead Circuit Breaker Panel
 1) 7C7 WXR L RT
 2) 7C19 WXR R RT


 (b)  
P6 Main Power Distribution Panel
 1) 6K2 MN BAT CONT INVERTER PWR
 2) 6K5 TRU - CONT INVERTER PWR

 


 (2)  
Remove the cover from the waveguide switch.


 S 424-076
 EFFECTIVITYùùùùùùùùùùùùùùùùùùùùùùùùùùùùùù. ú

 34-43-07
 ALL  ú ú 02B Page 407 ú Feb 18/00
BOEING PROPRIETARY - Copyright (C) - Unpublished Work - See title page for details.
SEE A
RIGHT FEEDER WAVEGUIDE
WAVEGUIDE SWITCH
SUPPORT BRACKET

WAVEGUIDE
SECTION 4
A 747-400 MAINTENANCE MANUAL SEE B . WEATHER RADAR R/T MOUNT SHELF ASSEMBLIES, E5-1 AND E5-2 TRANSMITTER LEFT RECEIVER/ 
RIGHT RECEIVER/TRANSMITTER 
WAVEGUIDE 
SCREW, WASHER (4 LOCATIONS)  FWD RIGHT R/T MOUNT  A 
 
中国航空网 www.aero.cn
航空翻译 www.aviation.cn
本文链接地址:747-400 AMM 飞机维护手册 导航 NAVIGATION 2(152)