737-300 400 500 AMM 飞机维护手册 AIRBORNE AUXILIARY POWER 2(73)

曝光台 注意防骗 网曝天猫店富美金盛家居专营店坑蒙拐骗欺诈消费者

 S 864-024
 (4)  Open the circuit breaker and attach a DO-NOT-OPERATE tag: (a) E3-3 Electrical Shelf, APU Control Unit
 S 014-004
 (5)  Open the access door for the horizontal stabilizer compartment.
 S 024-012
 (6)  Disconnect the electrical connector from the stabilizer trim electric actuator.
 S 024-013
 (7)  Disconnect the electrical connector from the autopilot stabilizer trim servo.
 S 424-014
 (8)  Install caps on the electrical connectors and receptacles for protection.
 S 024-005
 (9)  Remove the pneumatic actuator: (a) Disconnect the pneumatic pressure line from the pneumatic actuator.
 (b)  Install a cap on the pneumatic pressure line to prevent contamination.
 (c) (d)  Remove the cotter pin, the washers, and the pin that attach the link to the actuator assembly.Remove the lockwire from the nut that attaches the pneumatic actuator to the mounting bracket.

 EFFECTIVITYùùùùùùùùùùùùùùùùùùùùùùùùùùùùùù. ú

 49-51-32
 ALL  ú ú 01 Page 405 ú Nov 12/99
BOEING PROPRIETARY - Copyright (C) - Unpublished Work - See title page for details.
////////////////////////A / GTCP85-129 SERIES /737-300/400/500/ ENGINES/MAINTENANCE MANUAL ////////////////////////
(e)  
AIRPLANES WITH THE -5 COOLING AIR SHUTOFF VALVE; Remove the retainer, the teflon bushing, the nut, and the washer that attach the actuator assembly to the valve bracket.

 NOTE:____The teflon bushing can be loose in the actuator. Be careful not to let the bushing fall to the ground when you remove the retainer.

 (f)  
AIRPLANES WITH THE -7 COOLING AIR SHUTOFF VALVE; Remove the nut and the washer that attach the actuator assembly to the valve bracket.

 (g)  
Remove the pneumatic actuator from the bracket on the cooling air shutoff valve.

 TASK 49-51-32-404-006
 3.  Pneumatic Actuator Installation (Fig. 401)_______________________________
 A. References
 (1)  AMM 49-51-21/501, Cooling Air Shutoff Valve
 B. Access
 (1)  
Location Zones
 101 Control Cabin, LH
 205 Electronic Compartment
 701 Tail Section
 703 APU Compartment

 (2)  
Access Panels
 1201 Electronic Equipment Access Door
 3701 Horizontal Stabilizer Compartment Access Door

 

 C. Procedure
 S 864-015
 (1)  Make sure the switch and the circuit breaker are set correctly:
 (a)  
Make sure the APU master switch, on the P5 forward overhead panel, is in the OFF position with a DO-NOT-OPERATE tag attached.

 (b)  
Make sure this circuit breaker is open with a DO-NOT-CLOSE tag attached: 1) E3-3 Electrical Shelf, APU Control Unit

 S 864-016
 (2)  Make sure the electrical connectors are disconnected:
 (a)  
Make sure the electrical connector is disconnected from the stabilizer trim electric actuator.

 (b)  
Make sure the electrical connector is disconnected from the autopilot stabilizer trim servo.

 S 424-007
 (3)  Install the pneumatic actuator:
 (a)  Put the pneumatic actuator in its position on the bracket on the cooling air shutoff valve.
 EFFECTIVITYùùùùùùùùùùùùùùùùùùùùùùùùùùùùùù. ú

 49-51-32
 ALL  ú ú 01 Page 406 ú Nov 15/97
BOEING PROPRIETARY - Copyright (C) - Unpublished Work - See title page for details.
(b)  
AIRPLANES WITH THE -5 COOLING AIR SHUTOFF VALVE; Attach the pneumatic actuator to the bracket with the washer, the nut, the teflon bushing, and the retainer.

 (c)  
AIRPLANES WITH THE -7 COOLING AIR SHUTOFF VALVE; Attach the pneumatic actuator to the bracket with the washer and the nut. 1) Tighten the nut. 2) Install a lockwire on the nut.

 (d)  
Connect the link to the actuator assembly with the pin, the washers, and the cotter pin.

 (e)  
Remove the cap from the pneumatic pressure line.

 (f)  
Connect the pneumatic pressure line to the pneumatic actuator.

 S 024-017
　
中国航空网 www.aero.cn
航空翻译 www.aviation.cn
本文链接地址：737-300 400 500 AMM 飞机维护手册 AIRBORNE AUXILIARY POWER 2(73)