49-91-11
ALL ú ú 01 Page 503 ú Mar 15/92
BOEING PROPRIETARY - Copyright (C) - Unpublished Work - See title page for details.
////////////////////////A / GTCP85-129 SERIES /737-300/400/500/ ENGINES/MAINTENANCE MANUAL ////////////////////////
(j) Install the cap on the manifold.
S 415-010 CAUTION: KEEP A MINIMUM CLEARANCE OF 0.18 INCHES (5 MM) BETWEEN THE
_______ ENGINE, FIRE DETECTOR, CLAMPS AND LOWER SHROUD.
BE CAREFUL WHEN YOU MOVE THE LOWER SHROUD. SHROUD DRAIN LINES CAN OCCURE. DAMAGE TO THE
(5) Install the lower shroud: (a) Hold the lower shroud against the upper shroud. (b) Close the shroud latches.
(6) S 415-007Close the APU cowl door: (a) Disconnect the door support rods. (b) Put the door support rods in the clips on the APU cowl door. (c) Close the APU cowl door. (d) Close the latches for the APU cowl door.
(7) S 865-012Remove the DO-NOT-OPERATE tag from the APU master switch on the P5 forward overhead panel.
EFFECTIVITYùùùùùùùùùùùùùùùùùùùùùùùùùùùùùù. ú
49-91-11
ALL ú ú 01 Page 504 ú Mar 15/92
BOEING PROPRIETARY - Copyright (C) - Unpublished Work - See title page for details.
OIL PUMP - INSPECTION/CHECK
___________________________
1. General
_______
A. This procedure gives the task to examine the APU oil pump. The APU oil pump is on the APU gearbox. You can get access to the oil pump through the APU cowl door.
TASK 49-91-11-206-003
2. Oil Pump Inspection
___________________
A. References
(1)
AMM 49-11-00/201, APU Power Plant
(2)
AMM 49-11-00/401, APU Power Plant
(3)
AMM 49-91-12/401, Oil Pump Filter
(4)
AMM 49-91-31/301, Oil Tank
B. Access
(1)
Location Zones
101 Control Cabin, LH
205 Electronic Compartment
703 APU Compartment
(2)
Access Panels
1201 Electronic Equipment Access Door
3804 APU Cowl Door
C. Procedure
S 026-001
(1)
Remove the filter element for the oil pump (AMM 49-91-12/401).
S 216-002
(2)
Examine the filter element for metal particles.
(a)
If the filter element has metal particles in it, do these steps: 1) Change the oil (AMM 49-91-31/301). 2) Replace the filter element (AMM 49-91-12/401). 3) Operate the APU for a minimun of 15 minutes (AMM
49-11-00/201). 4) Remove the filter element for the oil pump (AMM 49-91-12/401). 5) Examine the filter element. a) If the filter element has metal particles in it, replace the APU (AMM 49-11-00/401).
(b)
If the filter element does not have metal particles in it, install the filter element (AMM 49-91-12/401).
EFFECTIVITYùùùùùùùùùùùùùùùùùùùùùùùùùùùùùù. ú
49-91-11
ALL ú ú 01 Page 601 ú Nov 15/91
BOEING PROPRIETARY - Copyright (C) - Unpublished Work - See title page for details.
OIL PUMP FILTER - REMOVAL/INSTALLATION
______________________________________
1. General_______
A. This procedure gives the tasks for the removal and the installation of
the oil pump filter.
B. The oil pump is on the forward bottom end of the APU engine. You can get access to the oil pump through the APU cowl door.
TASK 49-91-12-004-001
2. Oil Pump Filter Removal (Fig. 401)_______________________
A. Standard Tools and Equipment
(1) Container - 1 U.S. Gallon (4 Liter) capacity, for oil
B. Access
(1)
Location Zones
101 Control Cabin, LH
205 Electronic Compartment
703 APU Compartment
(2)
Access Panels
1201 Electronic Equipment Access Door
3804 APU Cowl Door
C. Procedure
S 864-002
(1) Set the switch and the circuit breaker:
(a)
Set the APU master switch on the P5 forward overhead panel to the OFF position and attach a DO-NOT-OPERATE tag.
中国航空网 www.aero.cn
航空翻译 www.aviation.cn
本文链接地址：737-300 400 500 AMM 飞机维护手册 AIRBORNE AUXILIARY POWER 2(152)
