27-09-91
ALL ú ú 02 Page 608 ú Nov 12/00
BOEING PROPRIETARY - Copyright (C) - Unpublished Work - See title page for details.
A 737-300/400/500MAINTENANCE MANUAL
LEFT ELEVATOR TAB
(RIGHT ELEVATOR TAB IS OPPOSITE)
Elevator and Elevator Tab Freeplay Checks
Figure 604
EFFECTIVITYùùùùùùùùùùùùùùùùùùùùùùùùùùùùùù. ú
27-09-91
ALL ú ú 01 Page 609 ú Jul 12/01
BOEING PROPRIETARY - Copyright (C) - Unpublished Work - See title page for details.
A 737-300/400/500MAINTENANCE MANUAL
HINGE BRACKET
HINGE BRACKET
CLAMPED HINGE (TYPICAL) SLIP HINGE (TYPICAL) B-B B-B
1
THIS IS THE FLANGED BUSHING THAT IDENTIFIES
THE HINGE AS A CLAMPED HINGE.
Elevator Tab Hinge Free-Play Checks Figure 605
L13665
EFFECTIVITYùùùùùùùùùùùùùùùùùùùùùùùùùùùùùù. ú
27-09-91
ALL ú ú 02 Page 610 ú Mar 12/00
BOEING PROPRIETARY - Copyright (C) - Unpublished Work - See title page for details.
A
737-300/400/500MAINTENANCE MANUAL
D. Access
(1)
Location Zone
711 Elevator and Tab, LH
712 Elevator and Tab, RH
E.
Procedure
S 226-013
(1)
Do a check of the bus linkage of the elevator output torque tube:
(a)
Pressurize the elevator hydraulic system A (AMM 27-31-00/201).
CAUTION: USE SUFFICIENT PADDING ON THE FORCE SCALE TO PREVENT
_______
DAMAGE TO THE CONTROL SURFACE.
(b) Put a piece of tape on the left side of the airplane tailcone adjacent to the elevator trailing edge, and do the step that follows: 1) Tape a pointer on the trailing edge of the elevator.
NOTE: Put the end of pointer close to the tape but without
____
touching it.
(c) Apply force to the elevator within 0.5 inch forward of the trailing edge and 1 inch outboard of inboard edge. Do these steps: 1) Push up with a force of 8 |0.5 pounds on the trailing edge
of the left elevator.
2) With the force applied, make a mark on the tape showing the
upward limit of elevator travel.
3) Slowly release the force on the elevator.
4) Push down with a force of 8 | 0.5 pounds on the trailing
edge of the left elevator.
5) With the force applied, make a mark on the tape showing the
downward limit of elevator travel.
6) Slowly release the force on the elevator.
7) Measure the distance between the upward limit mark and the
downward limit mark. 8) Make sure the distance between the up and down limits is not more than 0.210 inch.
(d)
Release the pressure from the elevator hydraulic system A (AMM 27-31-00/201).
(e)
Pressurize the elevator hydraulic system B (AMM 27-31-00/201).
(f)
Put a piece of tape on the right side of the airplane tailcone adjacent to the elevator trailing edge, and do the step that follows: 1) Tape a pointer on the trailing edge of the elevator.
NOTE: Put the end of pointer close to the tape but without
____
touching it.
EFFECTIVITYùùùùùùùùùùùùùùùùùùùùùùùùùùùùùù. ú
27-09-91
ALL ú ú 02 Page 611 ú Jul 12/00
BOEING PROPRIETARY - Copyright (C) - Unpublished Work - See title page for details.
A
737-300/400/500MAINTENANCE MANUAL
2) Push up with a force of 8 | 0.5 pounds on the trailing edge of the right elevator. 3) With the force applied, make a mark on the tape showing the
upward limit of elevator travel. 4) Slowly release the force on the elevator. 5) Push down with a force of 8 | 0.5 pounds on the trailing
edge of the right elevator. 6) With the force applied, make a mark on the tape showing the
downward limit of elevator travel. 7) Slowly release the force on the elevator. 8) Measure the distance between the upward limit mark and the
downward limit mark. 9) Make sure the distance between the up and down positions is not more than 0.210 inch (AMM 27-31-11/601).
中国航空网 www.aero.cn
航空翻译 www.aviation.cn
本文链接地址：737-300 400 500 AMM 飞机维护手册 飞行操纵 FLIGHT CONTROLS 1(60)
