EFFECTIVITY
AF AF, AT, GN, MD, VN,
AF ALL AIRPLANES WITH AEB ATG X Page 511
AF 34-588 Apr 25/96
34-45-00
AF b) TA occurs normally, AF c) No RA occurs. AF 3) Stop scenario. AF (12) Check BELOW and ABOVE functions. AF (a) BELOW function. AF 1) Set airplane in simulated in-air condition. AF 2) Set radioaltitude above 2500 ft. AF 3) Set ADC 1 to 11000 ft. AF 4) Set the ramp test set to simulate an intruder aircraft with AF the following parameters: AF a) Intruder type: ATCRBS AF b) range: 6 NM AF c) range rate: 0 Kts AF d) altitude: 4100 ft AF e) altitutde rate: 0 ft/mn AF 5) On the TCAS control panel, place the ABV/N/B/W selector to AF BLW. AF 6) Check the other traffic intruder symbol and -69 relative AF altitude on IVSI. AF 7) Decrease intruder altitude to 3900 ft and observe intruder AF disappears from display. AF (b) ABOVE function. AF 1) Set the ramp test set to simulate an intruder aircraft with AF the following parameters: AF a) Intruder type: ATCRBS AF b) range: 6 NM AF c) range rate: 0 Kts AF d) altitude: 17900 ft AF e) altitude rate: 0 ft/mn AF 2) On the TCAS control panel place the ABV/N/BLW selector to AF ABOVE. AF 3) Check the other traffic intruder symbol and +69 relative AF altitude on IVSI. AF 4) Increase intruder altitude to 18100 ft and observe intruder AF disappears from display. AF 5) Place ABV/N/BLW control panel selector to N. AF (13) Check of intruder vertical speed arrow. Verify arrow is displayed AF when intruder vertical speed is greater than 500 ft/mn. AF (a) Intruder in climb. AF 1) Set airplane in simulated in-air condition. AF 2) Set radioaltitude above 2500 ft. AF 3) Set ADC 1 to 11000 ft. AF 4) Set the ramp test set to simulate an intruder aircraft with AF the following parameters: AF a) Intruder type: ATCRBS AF b) range: 6 NM AF c) range rate: 0 Kts AF d) altitude: 11000 ft AF e) altitude rate: +400 ft/mn AF 5) Check there is no arrow present next to intruder on IVSI AF display.
EFFECTIVITY AF AF, AT, GN, MD, VN, AF ALL AIRPLANES WITH AEB ATG X Page 512 AF 34-588 Apr 25/96
34-45-00
AF 6) Set intruder altitude rate to +600 ft/mn and verify an
AF arrow pointing up is displayed next to the intruder.
AF (b) Intruder in descent.
AF 1) Set the ramp test set to simulate an intruder aircraft with
AF the following parameters:
AF a) Intruder type: ATCRBS
AF b) range: 6 NM
AF c) range rate: 0 Kts
AF d) altitude: 11000 ft
AF e) altitude rate: -400 ft/mn
AF 2) Check there is no arrow present next to intruder on IVSI
AF display.
AF 3) Set intruder altitude rate to -600 ft/mn and verify an
AF arrow pointing down is displayed next to the intruder.
AF (14) End of test.
AF (a) Turn off TCAS ramp test set.
AF (b) Position ATC/TCAS control panel to STBY.
AF (c) Restore aiprlane to normal.
AF (d) If no longer required remove electrical power.
EFFECTIVITY AF AF, AT, GN, MD, VN, AF ALL AIRPLANES WITH AEB ATG X Page 513 AF 34-588 Apr 25/96
34-45-00
GROUND PROXIMITY WARNING SYSTEM - DESCRIPTION AND OPERATION
___________________________________________________________
1. General (Fig. 1)
_______
A. The ground proximity warning system (GPWS) provides the pilots with aural and visual warning of potentially dangerous flight paths relative to the ground. The GPWS processes radio altitude information from the No. 1 low range radio altimeter (LRRA), altitude rate information from the No. 1 central air data computer (CADC), glide slope deviation, flap position, and landing gear position signals to provide warning of the following hazards:
(1)
Inadvertent descent close to the ground.
(2)
Level flight or too shallow climb towards rising terrain.
(3)
Excessive rate of descent.
(4)
Deliberate descent in unsuspected proximity to the ground.
中国航空网 www.aero.cn
航空翻译 www.aviation.cn
本文链接地址：747飞机维护手册AMM CHAPTER 34 - NAVIGATION 第34章导航4(40)
