(8)
With mode switch to ANT, select BFO or TONE (on). A 1020 Hz signal should be heard along with the broadcast station audio.
(9)
Turn BFO or TONE switch off.
(10)
Tune ADF system to receive a known standard broadcast station in 550 kHz to 830 kHz range. Verify loud, clear reception of transmission.
(11)
Set mode switch to ADF.
(12)
Check that both RMI's indicate in tolerance bearing to selected station.
EFFECTIVITY
AF 121, 122, 152-999;
IB 406-499; LH 011-099, SN 303-399; CONFIG 2 AT, AZ, GN, MD AND VM ALL 11 Page 502
Sep 25/94
34-57-00
(13)
Repeat previous three steps using a known standard broadcast station in 830 kHz to 1750 kHz range.
(14)
Repeat above procedures for second ADF system. ADF system 1 drives narrow indicator needles and ADF system 2 drives wide needles.
(15)
Make representative range and AM broadcast station frequency checks with both ADF systems operating. Check for erratic operation, crosstalk, unusual noise, and other irregularities not noticed in single system operation. Check that both systems function normally in ANT and ADF modes when both systems are tuned to different transmitting station frequencies.
(16)
Select ADF/ANT switch to ANT.
(a) With ANT mode selected, retune to zero beat and check that frequency readout on control panel checks within 1% of listed frequency for stations selected. Repeat with ADF mode selected.
(17)
Tune ADF to an open frequency. Set and hold mode selector switch to TEST and verify that applicable needle on both RMI's is 45 (|5) degrees to the left of the lubber line.
(18)
Tune ADF to an open frequency.
(19)
On AZ airplanes, press TEST pushbutton on ADF control panel and verify applicable needle on both RMI's is 45 (|5) degrees to the left of the lubber line.
(20)
On ALL EXCEPT AZ airplanes, press TEST pushbutton on ADF receiver and verify applicable needle on both RMI's is 45 (|5) degrees to the left of the lubber line.
(21)
On AT airplanes, select right position of TFR switch on control panel. Repeat steps (5) and on except use right frequency control knobs and readout indicator.
(22)
Remove electrical power if no longer required (Ref 24-22-00).
EFFECTIVITY
AF 121, 122, 152-999;
IB 406-499; LH 011-099, SN 303-399; CONFIG 2 AT, AZ, GN, MD AND VM ALL 09 Page 503
Sep 25/94
34-57-00
ADF ANTENNA COMPONENTS - REMOVAL/INSTALLATION
_____________________________________________
1. General_______
A. The ADF antenna components consist of sense antennas, sense antenna couplers, fixed loop antennas and quadrature error correctors (Fig. 401).
2. Equipment and Materials_______________________
A. Bonding Meter
B. Cloth - lint-free
C. Primer - BMS 10-79 type III
D. Sealant - Aerodynamic, BMS 5-95
E. Solvent - Aliphatic Naptha TT-N-95
F. Solvent - BMS 11-7
3. Referenced Procedures_____________________
A. AMM 20-22-01/601, Electrical Bonding
B. AMM 24-22-00/201, Maintenance Practices (Apply Power)
C. 32-00-30, Maintenance Practices
D. AMM 51-31-01/201, Seals and Sealing
E. AMM 51-21-03/701, Corrosion (Removal and Control)
F. AMM 51-21-04/701, Alodized Surfaces
G. AMM 51-24-13/701, Water Displacing Corrosion Preventative Compound
4. Prepare for Removal___________________
A. Open ADF AC and DC circuit breakers on P7 panel.
B. Check that landing gear ground locks are installed.
C. Install main body gear door locks.
WARNING:_______REFER TO 32-00-30 FOR LOCK INSTALLATION PROCEDURE. RAPID ACTION OF DOORS MAY INJURE PERSONNEL OR DAMAGE EQUIPMENT IF LOCKS ARE NOT PROPERLY INSTALLED.
D. On airplanes with sense antennas installed forward of wheel wells: access to the sense antenna couplers, coaxial cables, and antenna cable studs on inboard surface of the sense antennas can be attained thru the latch-opened air conditioning underwing access panel just forward of sense antenna No. 1.
5. Remove Sense Antenna Coupler (Fig. 401)____________________________
A. On airplanes with sense antennas installed aft of wheel wells (Fig. 401):
(1)
Remove four screws attaching coupler mounting plate to aft wheel well bulkhead to gain access to coupler.
中国航空网 www.aero.cn
航空翻译 www.aviation.cn
本文链接地址：747飞机维护手册AMM CHAPTER 34 - NAVIGATION 第34章导航4(113)
