(2)
Access Panels
Electronics Compartment Access Door
C. Procedure
(1)
Make sure these circuit breakers are open with DO-NOT-CLOSE tags attached:
(a) P7 Overhead Circuit Breaker Panel
1) WX RDR R/T 1
2) WX RDR R/T 2
3) WX RDR IND 1
4) WX RDR IND 2
(2)
Do these steps to install each of the R/T mount filters:
(a)
Attach the filter to the filter bracket.
(b)
Carefully install the filter assembly into the filter enclosure.
(c)
Put the cover on the top of the filter enclosure.
(d)
Tighten the cover with the two knobs and four washers.
(3)
Do this task to install the left WXR R/T in the E5 equipment rack: "Weather Radar Receiver/Transmitter Installation" (AMM 34-43-02/401).
(4)
Do this task to install the right WXR R/T into the E5 equipment rack: "Weather Radar Receiver/Transmitter Installation. (AMM 34-43-02/401).
(5)
Remove the DO-NOT-CLOSE tags and close these circuit breakers:
(a) P7 Overhead Circuit Breaker Panel
1) WX RDR R/T 1
2) WX RDR R/T 2
3) WX RDR IND 1
4) WX RDR IND 2
(6)
Do this task to supply electrical power: "Manual Control"
(AMM 24-22-00/201).
(7)
Do the operational test test (AMM 34-43-00/501).
(8)
If access is not necessary;
Close the access door on the 117AL electronic compartment.
(AMM 06-09-01/201).
(9)
If electrical power is not necessary;
Do this task to remove electrical power: "Manual Control"
(AMM 24-22-00/201).
EFFECTIVITY
AF 160, 162-171, 183, 184 01 Page 402 Apr 25/97
34-43-21
WEATHER RADAR R/T MOUNT FILTER - CLEANING/PAINTING
__________________________________________________
1. General
_______
A. This subject has one task, to clean the R/T mount filters.
2. Filter Cleaning
_______________
A. Standard Tools and Equipment
(1) Dry air pressure source.
B. Consumable Materials
(1) B00541 Cleaner - General purpose detergent, P-D-220
C. References
(1) AMM 34-43-21/401, Weather Radar R/T Mount Filter
D. Access
(1)
Location Zones Area Between the Nose Gear Well and the Fuselage, RH
(2)
Access Panels
Electronics Compartment Access Door
E. Procedure
(1)
Do this task to remove the R/T mount filter: "R/T Mount Filter Removal" (AMM 34-43-21/401).
(2)
Clean the R/T mount filter.
(a)
Clean the filter in a container with hot water and detergent soap.
(b)
Dry the filter with a clean, dry compressed air.
NOTE: The air pressure must be between 25 and 38 psi.
____
(3) Do this task to install the R/T mount filter: "R/T Mount Filter Installation" (AMM 34-43-08/401).
EFFECTIVITY
AF 160, 162-171, 183, 184 01 Page 701 Apr 25/97
34-43-21
CENTRAL INSTRUMENT WARNING SYSTEM - DESCRIPTION AND OPERATION
_____________________________________________________________
1. General_______(Fig. 1.)
A. The central instrument warning system (CIWS) monitors data inputs to the flight instruments and illuminates appropriate annunciator lights on each pilots' instrument panel when the input data is invalid. One system is installed in the airplane consisting of a CIWS computer, captain's and first officer's CIWS annunciators, and captain's and first officer's self-test switches. On AF ALL; AT ALL; AZ ALL; GN ALL; MD ALL; SN ALL; VM ALL; IB 406-499; LH 011-099; PLUS ATLAS AIRPLANES INCORPORATING SB 34-2059, The system also includes a captain's and first officer's attitude comparator aural warning unit.
B. The system performs the following:
(1)
Monitors warning flag signals from the horizontal situation indicators (HSI), attitude director indicators (ADI), inertial navigation system (INS), magnetic heading reference system (MHRS), VOR/ILS system,
(2)
Compares the roll and pitch attitude displays in the ADI's.
中国航空网 www.aero.cn
航空翻译 www.aviation.cn
本文链接地址：747飞机维护手册AMM CHAPTER 34 - NAVIGATION 第34章导航4(25)
