1) Send the wheel and tire assembly for an inspection to find the cause for the low tire pressure.
(b)
Replace the wheel and tire assembly installed on the opposite side of that axle. 1) Mark on the tire that it was on the same axle with a wheel
and tire assembly that was replaced because of low tire pressure. 2) Send the tire for inspection for damage.
S 613-028
(10)
Use the tire pressure gage to measure the nose landing gear tire pressures.
S 613-033
(11)
For the applicable airplane maximum taxi weight and tire, find the minimum nose tire service pressure.
S 613-034
(12)
Make sure both of the nose gear tires are above the minimum cold specified pressures for the airplane's maximum weight.
S 613-032
CAUTION: DO NOT DEFLATE A HOT TIRE TO LOWER THE PRESSURE TO THE AVERAGE
_______ PRESSURE VALUE. PRESSURE SHOULD NEVER BE BLED FROM A HOT TIRE TO ACHIEVE A SPECIFIED VALUE. DAMAGE TO EQUIPMENT CAN OCCUR.
(13) If the pressure of one tire is low 5% - 10% less than the other tire, inflate the tire with the low pressure to the pressure of the other tire.
WARNING:_______USE A REGULATED PRESSURE SOURCE TO SERVICE THE TIRES. AN UNREGULATED PRESSURE SOURCE CAN CAUSE INJURIES TO PERSONS AND DAMAGE TO EQUIPMEMNT.
EFFECTIVITYùùùùùùùùùùùùùùùùùùùùùùùùùùùùùù. ú
12-15-51
ú ALL ú
ú ú ú 01.101 ú BOEING PROPRIETARY - Copyright (C) - Unpublished Work - See title page for details. Page 307Jul 12/02
A
737-300/400/500MAINTENANCE MANUAL
(a)
Connect the inflator, F70199-1 to the inflation valve and inflate the tire with nitrogen, BB-N-411, Type I or MIL-PRF-27401, Type I to the value of the other tire.
(b)
Remove the inflator, F70199-1 from the inflation valve.
S 613-035
(14) If the tire pressure of the low tire is more than 10% below the pressure of the other tire, do these steps:
(a) Replace the wheel and tire assembly (AMM 32-45-21/401).
1) Send the wheel and tire assembly for an inspection fo find the cause for the incorrect tire pressure.
S 613-042
(15) If the tire pressure of one tire is more than 20% below the average pressure of the other tire, do these steps:
(a)
Replace the tire and wheel assembly.
1) Send the wheel and tire assembly for an inspection to find the cause for the low tire pressure.
(b)
Replace the wheel and tire assembly installed on the opposite side of the axle. 1) Mark on the tire that it was on the same axle with a wheel
and tire assembly that was replaced because of low tire pressure. 2) Send the tire for inspection for damage.
EFFECTIVITYùùùùùùùùùùùùùùùùùùùùùùùùùùùùùù.
ú
12-15-51
ú ALL ú ú ú 01.101 Page 308 ú ú Jul 12/02
BOEING PROPRIETARY - Copyright (C) - Unpublished Work - See title page for details.
A
737-300/400/500MAINTENANCE MANUAL
208 PSIG MAXIMUM INFLATION PRESSURE (A)
70 75 80 85 90 95 100 105 110 115 120 125 130 135 140
TAKEOFF GROSS WEIGHT
1000 LBS
VARIABLE TIRE PRESSURE(TIRE PRESSURE CAN CHANGE IN THE ABOVE LIMITS)
NOTE: 1. FOR THE DESIRED MAXIMUM TAXI WEIGHT, DETERMINE THE MINIMUM SERVICE PRESSURE (SLOPED LINE) FROM THE CHART.
2. DETERMINE THE MAXIMUM SERVICE PRESSURE
THIS IS A 737-200 WHEEL AND TIRE ASSEMBLY.
(HORIZONTAL LINE) FROM THE CHART.
TEMPORARY USE OF 737-200 WHEEL AND TIRE 3. SELECT A NOMINAL SERVICE PRESSURE
ASSEMBLIES ON 737-300 OR 737-400 AIRPLANES BETWEEN THE MINIMUM AND MAXIMUM.
IS PERMITTED BY SERVICE BULLETIN 737-32-1160.
4. INFLATE ALL TIRES ON THE SAME GEAR TO
YOU MUST REFER TO THIS SERVICE BULLETIN BEFORE THE SELECTED NOMINAL PRESSURE |5 PSIG.
中国航空网 www.aero.cn
航空翻译 www.aviation.cn
本文链接地址：737-300 400 500 AMM 飞机维护手册 SERVICING(79)
