CAUTION:_______DO NOT OVER SERVICE THE SUMP. IF YOU DO, DAMAGE TO THE STARTER DURING ITS OPERATION CAN OCCUR.
(3) Add the oil to the starter.
(a) ENGINE STARTERS WITHOUT THE OIL LEVEL VIEW GLASS; Add the oil through the fill port until the oil flows freely from the oil overfill port.
NOTE: The capacity of the oil sump in the starter is
____
10 fluid ounces (300 cc).
EFFECTIVITYùùùùùùùùùùùùùùùùùùùùùùùùùùùùùù. ú
12-13-41
ALL ú ú 01 Page 308 ú Nov 12/00
BOEING PROPRIETARY - Copyright (C) - Unpublished Work - See title page for details.
A 737-300/400/500MAINTENANCE MANUAL
1) Catch the oil that flows from the oil overfill port in a container.
(b) 2) Let the oil drain from the oil overfill port until the flow slows and falls in drops.ENGINE STARTERS WITH THE OIL LEVEL VIEW GLASS; Add the oil through the fill port until you see the oil full in the view glass.
NOTE:____ The capacity of the oil sump in the starter is 23.3 fluid ounces (700 cc).
(c) (d) (e) If you use a different approved oil of the same type (AMM 70-10-01/201), it is not necessary to flush the starter sump.If you use an approved oil of a different type, you must drain and flush the starter sump, then drain it again with a quart (liter) of the new oil, before you fill the starter sump.If you accidentally use an oil that is not approved, you must drain and flush the starter sump, then drain it again with a quart (liter) of the new oil, before you continue.
S 433-016
(4) ENGINE STARTERS WITHOUT THE OIL LEVEL VIEW GLASS; Install the cap on the oil overfill port. (a) Push the cap and turn it clockwise until it locks.
S 433-021
(5) Install the cap on the oil fill port. (a) Push the cap and turn it clockwise until it locks.
S 413-022
(6) Close the left fan cowl panel (AMM 71-11-02/201).
S 863-012
(7) Remove the DO-NOT-CLOSE tag and close this circuit breaker: (a) On the P6 Load Control Center: 1) Engine Start Valve
EFFECTIVITYùùùùùùùùùùùùùùùùùùùùùùùùùùùùùù. ú
12-13-41
ALL ú ú 01 Page 309 ú Nov 12/00
BOEING PROPRIETARY - Copyright (C) - Unpublished Work - See title page for details.
A
737-300/400/500MAINTENANCE MANUAL
AIR CYCLE MACHINE - SERVICING
_____________________________
1. General_______
A. This procedure has one task. The task gives instructions to do a check of the oil level in the air cycle machine. The task also gives instructions to add oil to the air cycle machine if it is necessary.
TASK 12-13-51-603-001
2. Air Cycle Machine - Servicing (Oil Level Check) (Fig. 301)_______________________________________________
A. Consumable Materials
(1) Lubricant - Oil, as approved by AiResearch Manufacturing Company or one of these below (Ref 20-30-21/201):
(a)
D00068 MIL-L-23699
(b)
D00071 MIL-L-7808G
B. References
(1) 21-51-11/301, Air Cycle Machine
C. Access
(1)
Location Zones
212 Left Air Conditioning Equipment Bay
214 Right Air Conditioning Equipment Bay
(2)
Access Panels
3303L Air Conditioning Access Panel
3403R Air Conditioning Access Panel
D. Procedure
S 013-002
(1)
Open the access doors to the air conditioning bay to get access to the air cycle machine.
S 213-003
(2)
Look through the sight glass on the air cycle machine to examine the oil level.
(3)
Make sure the oil level in the sight glass is three-fourths full.
中国航空网 www.aero.cn
航空翻译 www.aviation.cn
本文链接地址：737-300 400 500 AMM 飞机维护手册 SERVICING(56)
