• 热门标签

当前位置: 主页 > 航空资料 > 机务资料 >

时间:2011-03-31 23:57来源:蓝天飞行翻译 作者:航空
曝光台 注意防骗 网曝天猫店富美金盛家居专营店坑蒙拐骗欺诈消费者


 (2)  
Access Panels
 5746L Left Fan Cowl - Engine 1
 5737L Left Fan Cowl - Engine 2

 

 D. Drain the Oil from the Spline Cavity.
 S 013-039-002
 (1)  Open the left fan cowl on the applicable engine if it is not open (Ref 71-11-02/201).
 EFFECTIVITYùùùùùùùùùùùùùùùùùùùùùùùùùùùùùù.
 -14, -15, -16 VARIABLE SPEED CONSTANT  ú 12-13-21
 FREQUENCY GENERATOR/CONVERTERS  ú CONFIG 2 ú 03 Page 309 ú Mar 15/95
BOEING PROPRIETARY - Copyright (C) - Unpublished Work - See title page for details.
A
737-300/400/500MAINTENANCE MANUAL
 S 493-040-002
 (2)  Set the bucket below the accessory gearbox to catch the used oil. S 033-041-002
 WARNING:_______ DO NOT TOUCH THE OIL SYSTEM PARTS WHEN THEY ARE HOT.  THESE
 PARTS STAY HOTTER THAN THE OTHER ENGINE PARTS AFTER AN ENGINE
 SHUTDOWN.  OIL SYSTEM PARTS THAT ARE HOT CAN BURN YOU.
 DO NOT LET THE OIL TOUCH YOUR SKIN FOR A LONG TIME.  YOU CAN
 ABSORB POISONOUS MATERIALS FROM THE OIL THROUGH YOUR SKIN.  OIL

 ON YOUR SKIN CAN CAUSE DERMATITIS AFTER A LONG TIME.
 (3)  
Remove the drain fitting for the spline cavity from the accessory gearbox.

 S 683-042-002

 (4)  
Let the oil drain from the spline cavity.

 S 093-043-002

 (5)  
Remove the bucket.


 (a)  Discard the used oil from the bucket.
 S 433-044-002
 (6)  Install the drain fitting for the spline cavity into the accessory gearbox:
 (a)  
Replace the O-ring that is on the drain fitting.

 (b)  
Install the drain fitting for the spline cavity into the accessory gearbox.

 (c)  
Tighten it to 180-220 pound inches.

 (d)  
Install a lockwire.


 S 163-045-002
 CAUTION: IMMEDIATELY REMOVE ALL OF THE OIL THAT FALLS ON THE ENGINE
_______ PARTS. OIL CAN CAUSE DAMAGE TO THE PAINT AND SOME RUBBER PARTS.
 (7)  Clean the engine parts that have oil on them.
 EFFECTIVITYùùùùùùùùùùùùùùùùùùùùùùùùùùùùùù.
 -14, -15, -16 VARIABLE SPEED CONSTANT  ú 12-13-21
 FREQUENCY GENERATOR/CONVERTERS  ú CONFIG 2 ú 03 Page 310 ú Mar 15/95
BOEING PROPRIETARY - Copyright (C) - Unpublished Work - See title page for details.
A 737-300/400/500MAINTENANCE MANUAL
 S 613-046-002
 (8)  Add oil to the spline cavity before you operate the engine again (Ref "Fill the Spline Cavity with Oil" task).
 TASK 12-13-21-613-047-002
 6. Fill the Spline Cavity with Oil (Fig. 301)
_______________________________
 A. General
 (1)  
Leakage of the seal on the accessory gearbox will let oil flow from the accessory gearbox to the spline cavity. If the oil level in the spline cavity is usually too high, the accessory gearbox seal can be defective.

 (2)  
Leakage of the seal in the VSCF will let oil flow from the VSCF to the spline cavity. The input shaft seal can be defective if these two indications occur after you fill the VSCF with oil:

 (a)  
The oil level in the VSCF decreases.

 (b)  
The oil level in the spline cavity increases.

 


 B. Special Tools and Equipment
 (1)  
Service Cart - Malabar 53361-2, Malabar Hydraulics Co., 220 West Los Angeles Avenue, Simi Valley, CA 93065

 (2)  
Coupling - OMP2506-3, Ozone Metal Products, 101-32 101st Street, Ozone Park, Long Island, NY 11416

 (3)  
Spline Cavity Adapter - MS27404-3D, Aeroquip Corporation, Aerospace Division, 300 S. East Avenue, Jackson, MI 49203-1972.


 C. Standard Tools and Equipment
 (1)  Bucket - to hold up to 2 gallons of used oil
 D. Consumable Materials
 (1)  D00068 Oil - MIL-L-23699, MIL-L-7808, or any oil that agrees with the specifications of CFM56-3 SB79-001.
 NOTE: Refer to the marker on the VSCF to find the oil that is in
____
 the spline cavity.

 E. References
 (1)  71-11-02/201, Fan Cowl Panels
 F. Access
 
中国航空网 www.aero.cn
航空翻译 www.aviation.cn
本文链接地址:737-300 400 500 AMM 飞机维护手册 SERVICING(45)