33-40-00
ALL ú ú 09 Page 3 ú Nov 12/99
BOEING PROPRIETARY - Copyright (C) - Unpublished Work - See title page for details.
A
737-300/400/500MAINTENANCE MANUAL
WING SCANNING LIGHTS - DESCRIPTION AND OPERATION
________________________________________________
1. General (Fig. 1)_______
A. There is a wing scanning light on each side of the fuselage. Each light is forward and above the wing.
B. Each light consists of a housing assembly mounted in the fuselage and sealed against weather. A sealed beam lamp is mounted in an adjustable retainer assembly that is attached to the lamp housing. A lens assembly is mounted on the outside of the housing assembly. A cable prevents the lens assembly from falling when removed for maintenance.
C. You operate the wing scanning lights with a switch on the overhead panel, P5.
D. For more data about this lighting system, refer to these sources:
(1)
SSM 33-40-02
(2)
WDM 33-41-01
EFFECTIVITYùùùùùùùùùùùùùùùùùùùùùùùùùùùùùù. ú
33-41-00
ALL ú ú 01 Page 1 ú Mar 15/94
BOEING PROPRIETARY - Copyright (C) - Unpublished Work - See title page for details.
A
737-300/400/500MAINTENANCE MANUAL
WING SCANNING LIGHT
LENS ASSEMBLY
Figure 1
EFFECTIVITYùùùùùùùùùùùùùùùùùùùùùùùùùùùùùù. ú
33-41-00
ALL ú ú 01 Page 2 ú Jul 15/94
BOEING PROPRIETARY - Copyright (C) - Unpublished Work - See title page for details.
A
737-300/400/500MAINTENANCE MANUAL
WING SCANNING LIGHTS - MAINTENANCE PRACTICES
____________________________________________
1. General
_______
A. This procedure contains two tasks for the wing scanning light (referred to as the light):
(1)
The replacement of the lamp
(2)
The adjustment of the light.
TASK 33-41-11-962-001
2. Wing Scanning Light - Lamp Replacement (Fig. 201)
______________________________________
A. References
(1) AMM 24-22-00/201, Manual Control
B. Access
(1) Location Zone
116 Right Emergency Exit Hatch
117 Left Emergency Exit Hatch
C. Procedure
S 962-003
(1) Replace the lamp:
(a)
Open this circuit breaker and attach a DO-NOT-CLOSE tag:
1) P18 Load Control Center - Left a) WING SCAN
(b)
Loosen the fasteners on the lens assembly.
(c)
Let the lens assembly hang from its lanyard.
(d)
Remove the retainer screws and remove the outer retainer.
NOTE: Make sure you do not turn the adjustment screws.
____
(e)
Pull the lamp forward and disconnect the wires from the lamp terminals.
(f)
Remove the lamp.
(g)
Make sure the replacement lamp terminals are clean.
中国航空网 www.aero.cn
航空翻译 www.aviation.cn
本文链接地址:737-300 400 500 AMM 飞机维护手册 灯 LIGHTS(52)