NOTE: To lower the light assembly to the full open position,
____ disconnect the shorter lanyard.
(c)
Disconnect the wires from the screw terminals on the ballast.
(d)
Remove the bolts, washers, and nuts that hold the ballast in its position.
(e)
Remove the ballast.
(f)
Hold the ballast in its position and install the three bolts, washers, and nuts.
(g)
Attach the wires to the screw terminals on the ballast.
S 722-008
(2) Do a test of the galley light:
(a)
Close this circuit breaker and remove the DO-NOT-CLOSE tag:
1) P18-3 Load Control Center - Left a) GALLEY LIGHTS
(b)
Put the galley light switch in the BRT position. 1) Make sure the galley light is on at a bright intensity.
(c)
Put the galley light switch in the DIM position.
1) Make sure the galley light changes from a bright intensity to a dim intensity.
(d)
Put the galley light switch in the OFF position.
EFFECTIVITYùùùùùùùùùùùùùùùùùùùùùùùùùùùùùù. ú
33-27-00
ALL ú ú 01 Page 203 ú Mar 15/91
BOEING PROPRIETARY - Copyright (C) - Unpublished Work - See title page for details.
A
737-300/400/500MAINTENANCE MANUAL
E. Put the airplane back to its usual condition.
S 412-027
(1) Lift the light assembly into its position and close the latch.
NOTE: Before you close the light assembly, connect the
____
shorter lanyard.
S 862-018
(2) Remove electrical power if it is not necessary
(Ref 24-22-00/201).
EFFECTIVITYùùùùùùùùùùùùùùùùùùùùùùùùùùùùùù. ú
33-27-00
ALL ú ú 01 Page 204 ú Mar 15/91
BOEING PROPRIETARY - Copyright (C) - Unpublished Work - See title page for details.
A
737-300/400/500MAINTENANCE MANUAL
PASSENGER LOADING LIGHTS - DESCRIPTION AND OPERATION
____________________________________________________
1. General________
A. A passenger loading light is one of the interior lights which follows:
(1)
Entry Light
(2)
Threshold Light
(3)
Attendant's Work Light
(4)
Airstair Light
B. Passenger loading lights give lighting to the areas near the doors of the passenger compartment.
C. For more data about this lighting system, refer to these sources:
(1)
SSM 33-26-00
(2)
SSM 33-29-00
(3)
SSM 33-46-11
(4)
WDM 33-26-11
(5)
WDM 33-29-01
(6)
WDM 33-46-01
2. Entry Light___________
A. An entry light gives lighting to an entry area. Each entry light is installed in the aisle ceiling between the passenger door and the service door.
(1) Each entry light contains fluorescent lamps.
(a)
The 115 volts ac of electrical power for the fluorescent lamps comes from the ground service bus through a circuit breaker on the P18 panel. 1) ENTRY LIGHT WITH A TRANSFORMER;
A transformer installed above the entry light increases the voltage before the electrical power is supplied to the ballast of the fluorescent lamps.
(b)
You operate an entry light with a switch installed on the attendant's panel near the entry light. 1) In the off position, the fluorescent lamps are off. 2) In the dim position, a voltage is supplied to the entry
light ballast to make the fluorescent lamps come on dimly. 3) In the bright position, more voltage is supplied to the ballast to make the fluorescent lamps come on brightly.
EFFECTIVITYùùùùùùùùùùùùùùùùùùùùùùùùùùùùùù. ú
33-28-00
ALL ú ú 02 Page 1 ú Mar 15/94
BOEING PROPRIETARY - Copyright (C) - Unpublished Work - See title page for details.
中国航空网 www.aero.cn
航空翻译 www.aviation.cn
本文链接地址：737-300 400 500 AMM 飞机维护手册 灯 LIGHTS(46)
