EFFECTIVITYùùùùùùùùùùùùùùùùùùùùùùùùùùùùùù. ú
24-11-01
ALL ú ú 10 Page 614 ú Feb 18/02
BOEING PROPRIETARY - Copyright (C) - Unpublished Work - See title page for details.
A
747-400
MAINTENANCE MANUAL
o) If the sample turns cloudy or grey the water content in the IDG oil is too high. Flush the IDG and the IDG cooling system with oil (AMM 12-22-07/301).
p) Replace the scavenge filter (AMM 24-11-04/401). q) Run the engine until the IDG oil temperature reaches
175 degrees F. r) Drain the oil. s) Replace the scavenge filter (AMM 24-11-04/401). t) Service the IDG (AMM 12-13-07/301).
TASK 24-11-01-206-037
4. Check the IDG Pressure Oiler (Service Fitting) and Pressure Cover (Fig 602)
_________________________________________________________________
A. General
(1)
This is a check for pressure oiler (service fittings) and pressure cover oil leakage.
B.
Parts
(1)
Container - 2 U.S. gallon (8 liter) capacity, suitable to collect oil drainage from IDG
(2)
Overflow drain tool - Risbridger 2315, W & J Risbridger Ltd. Blechingley, NR. Redhill, Surrey RH1 4LN, England
C.
Consumable Materials
(1)
Oil - IDG
D.
References
(1)
AMM 12-13-07/301, IDG - Servicing
(2)
AMM 12-22-07/301, IDG - Servicing
(3)
AMM 24-11-00/501, Generator Drive System
(4)
AMM 24-11-04/401, Scavenge Filter
(5)
AMM 78-31-00/201, Thrust Reverser System
(6)
WDM 24-11-11, WDM 24-11-12, WDM 24-11-13, WDM 24-11-14
(7)
SSM 24-11-01, SSM 24-11-02, SSM 24-11-03, SSM 24-11-04
E.
Access
(1)
Location Zone 412 Engine 1 - Main Gearbox Aft Face 6 o'clock 422 Engine 2 - Main Gearbox Aft Face 6 o'clock 432 Engine 3 - Main Gearbox Aft Face 6 o'clock 442 Engine 4 - Main Gearbox Aft Face 6 o'clock
EFFECTIVITYùùùùùùùùùùùùùùùùùùùùùùùùùùùùùù. ú
24-11-01
ALL ú ú 13 Page 615 ú Feb 18/02
BOEING PROPRIETARY - Copyright (C) - Unpublished Work - See title page for details.
A
747-400
MAINTENANCE MANUAL
IDG Service Fitting and Pressure Cap Inspection
Figure 602
EFFECTIVITYùùùùùùùùùùùùùùùùùùùùùùùùùùùùùù. ú
24-11-01
ALL ú ú 10 Page 616 ú Feb 18/02
BOEING PROPRIETARY - Copyright (C) - Unpublished Work - See title page for details.
H18322
A
747-400
MAINTENANCE MANUAL
(2)
Access Panel
415 Left Thrust Reverser Half - Engine 1
425 Left Thrust Reverser Half - Engine 2
435 Left Thrust Reverser Half - Engine 3
445 Left Thrust Reverser Half - Engine 4
F.
Prepare for Examination
S 016-038
(1)
Open the left thrust reverser half (AMM 78-31-00/201).
S 216-040
(2)
Do this step to examnine the pressure caps.
(a)
Make sure the pressure cap has no oil leaking from the cap.
NOTE: If the pressure cap has oil leaking from the cap, the
____ pressure oiler must be replaced.
(b) Do the following to examine the pressure cap:
CAUTION: DO NOT PULL ON THE LAYNARD OR SPLIT RING TO REMOVE THE
_______ CAP. PULL ON THE OUTER COVER TO REMOVE THE CAP. DAMAGE TO THE SPLIT RING OR LAYNARD WILL OCCUR.
1) Remove the pressure cap.
2) Examine the pressure cap O-ring for cuts, nicks or a hard O-ring. a) If damage to the O-ring is found, replace the O-ring.
3) Examine the ball bearings in the cap and the bore of the cap for cuts, nicks gouges or missing bearings. a) If damage to the pressure cap bore is found, replace
the cap. 4) Clean the oil from the inside of the cap with Isporopyl alcohol. Dry the cap with dry compressed air or nitrogen.
中国航空网 www.aero.cn
航空翻译 www.aviation.cn
本文链接地址：747-400 AMM 飞机维护手册 ELECTRICAL POWER 电源 1(42)
