(2)
Install the related lining panel to close access to the oxygen storage (Ref. TASK 25-55-12-400-003).
(3)
Set the CARGO COMPT LIGHT switch 8LU to the OFF position.
(4)
Remove the access platform(s).
(5)
Close the AFT cargo-compartment door 826 (Ref. TASK 52-30-00-860-002).
Subtask 35-23-11-862-050
B. De-energize the aircraft electrical circuits
(Ref. TASK 24-41-00-862-002).
SWITCH - ALTITUDE (16WR) - REMOVAL/INSTALLATION
_______________________________________________
TASK 35-23-15-000-001
Removal of the Altitude Switch (16WR)
1.
Reason for the Job
__________________
Self Explanatory
2.
Job Set-up Information
______________________
A. Fixtures, Tools, Test and Support Equipment
-------------------------------------------------------------------------------REFERENCE QTY DESIGNATION -------------------------------------------------------------------------------
No specific blanking cap
No specific circuit breaker(s) safety clip(s)
No specific access platform 2 m (6 ft. 7 in.)
B. Referenced Information
-------------------------------------------------------------------------------REFERENCE DESIGNATION -------------------------------------------------------------------------------
35-23-15-991-001 Fig. 401
3. Job Set-up
__________ Subtask 35-23-15-010-050
A. Get Access
(1)
Put the access platform in position at the access door 824.
(2)
Open the access door 824.
EFF : ALL
35-23-15Page 401
Subtask 35-23-15-865-050
B. Open, safety and tag this(these) circuit breaker(s):
-------------------------------------------------------------------------------PANEL DESIGNATION IDENT. LOCATION -------------------------------------------------------------------------------49VU OXYGEN/PASSENGER/CTL AND WARN 1WR HA02
4. Procedure
_________
(Ref. Fig. 401/TASK 35-23-15-991-001) Subtask 35-23-15-020-050
A. Removal of the Altitude Switch
(1)
Disconnect the electrical connector (1) from the altitude switch (2).
(2)
Put a blanking cap on the electrical connector (1).
(3)
Remove the screws (4) and the washers (5) and remove the altitude switch (2) from its support (3).
EFF : ALL
35-23-15Page 402
Altitude Switch
Figure 401/TASK 35-23-15-991-001
EFF : ALL 35-23-15 Page 403
Feb 01/98
CES
TASK 35-23-15-400-001
Installation of the Altitude Switch (16WR)
1.
Reason for the Job
__________________
Self Explanatory
2.
Job Set-up Information
______________________
A. Fixtures, Tools, Test and Support Equipment
-------------------------------------------------------------------------------REFERENCE QTY DESIGNATION -------------------------------------------------------------------------------
No specific blanking cap
No specific access platform 2 m (6 ft. 7 in.)
B. Referenced Information
-------------------------------------------------------------------------------REFERENCE DESIGNATION -------------------------------------------------------------------------------
35-23-00-720-002 Functional Test of the Passenger Emergency-Oxygen System R 52-41-00-410-002 Close the Avionics Compartment Doors after Access 35-23-15-991-001 Fig. 401
3. Job Set-up
__________
Subtask 35-23-15-860-050
A. Aircraft Maintenance Configuration
(1)
Make sure that the access platform is in position at the access door
824.
(2)
Make sure that the access door 824 is open.
EFF : ALL
35-23-15Page 404
Subtask 35-23-15-865-051
B. Make sure that this(these) circuit breaker(s) is(are) open, safetied and tagged
-------------------------------------------------------------------------------PANEL DESIGNATION IDENT. LOCATION -------------------------------------------------------------------------------49VU OXYGEN/PASSENGER/CTL AND WARN 1WR HA02
4. Procedure
_________
(Ref. Fig. 401/TASK 35-23-15-991-001)
Subtask 35-23-15-420-050
A. Install the Altitude Switch
(1)
Install the altitude switch (2) on its support (3) and install and tighten the screws (4) and the washers (5).
中国航空网 www.aero.cn
航空翻译 www.aviation.cn
本文链接地址：A320飞机维护手册 AMM OXYGEN 氧气(144)
