• 热门标签

当前位置: 主页 > 航空资料 > 机务资料 >

时间:2011-03-21 08:32来源:蓝天飞行翻译 作者:admin
曝光台 注意防骗 网曝天猫店富美金盛家居专营店坑蒙拐骗欺诈消费者

 

 Offwing Escape-Slide Compartment 7504MM (7505MM) Figure 402/TASK 25-62-42-991-005- 33 (SHEET 3) 
R  EFF : 001-049, 051-099, 101-149, 151-199, 201-299, 401-499,  25-62-42 Page 410 Aug 01/05
 CES 

 

 TASK 25-62-42-000-001
 Offwing Escape-Slide - Removal
 1. Reason for the Job
__________________
 Self Explanatory
 2. Job Set-up Information
______________________
 A. Fixtures, Tools, Test and Support Equipment
 -------------------------------------------------------------------------------REFERENCE QTY DESIGNATION -------------------------------------------------------------------------------
No specific blanking caps No specific blanking plugs No specific 1 ACCESS PLATFORM 2M (6 FT) FOR FIN 7504MM No specific 1 ACCESS PLATFORM 3M (10 FT)- ADJUSTABLE FOR FIN 7505MM No specific 1 ACCESS PLATFORM 3M (10 FT)- ADJUSTABLE No specific 1 WARNING NOTICE 98D27803000000 1 LOCKING TOOL - FLAP/SLAT CONTROL LEVER
 B. Referenced Information
 -------------------------------------------------------------------------------REFERENCE DESIGNATION -------------------------------------------------------------------------------
24-42-00-861-001 Energize the Ground Service Network from the External Power 52-30-00-860-001 Open the FWD or AFT Cargo-Compartment Door with the
 Yellow Electric Pump 25-62-42-991-005 Fig. 402 FOR FIN 7505MM 25-62-00-820-001 Adjustment Procedure to Install the Lock pin in the
 Regulator Valve Assembly of the Inflation Reservoir -Offwing Escape-Slide 27-50-00-866-009 Retraction of the Flaps on the Ground
R  EFF : 001-049, 051-099, 101-149, 151-199, 25-62-42Page 411 201-299, 401-499, Aug 01/05
 CES  3. Job Set-up


__________
 Subtask 25-62-42-861-051

 A. Energize the ground service network
 (Ref. TASK 24-42-00-861-001).

 Subtask 25-62-42-010-060
 B. Get Access
 (Ref. Fig. 402/TASK 25-62-42-991-005)

 (1)
 Open the AFT cargo compartment door (Ref. TASK 52-30-00-860-001).

 (2)
 Put an ACCESS PLATFORM 2M (6 FT) in position adjacent to the AFT cargo compartment exit.


 (3) Set the AFT CARGO COMPT light switch 8LU to the ON position. R (4) FOR 7504MM
 -Remove the access panel 151KW. R (5) FOR 7505MM
 -Remove the access panel 152KW.
 (6) Safety the applicable inflation reservoir (2): WARNING : MAKE SURE THAT THE SAFETY/LOCK PIN IS CORRECTLY INSTALLED
_______ IN THE REGULATOR VALVE ASSEMBLY OF THE INFLATION RESERVOIR. THIS PREVENTS ACCIDENTAL:
 -DISCHARGE OF THE INFLATION RESERVOIR
 -DEPLOYMENT OF THE ESCAPE-SLIDE WHICH CAN CAUSE INJURY AND/OR DAMAGE.
 (a)
 Remove the lockpin assembly (4) from the pocket (1).

 (b)
 Install the lockpin assembly (4) in the valve/regulator assembly (3).


 NOTE : If you cannot install the lockpin assembly (4) in the
____ valve/regulator assembly (3) refer to (Ref. TASK 25-62-00-820-001).
R  EFF : 001-049, 051-099, 101-149, 151-199, 25-62-42Page 412 201-299, 401-499, Aug 01/05
 CES  (7) Safety precautions in the cockpit:


 WARNING : PUT THE SAFETY DEVICES AND THE WARNING NOTICES IN POSITION
_______ BEFORE YOU START A TASK ON OR NEAR:
 -
THE FLIGHT CONTROLS

 -
THE FLIGHT CONTROL SURFACES

 -
THE LANDING GEAR AND THE RELATED DOORS


 -COMPONENTS THAT MOVE.
 (a)
 Set the the flap/slat control lever to the 0 position (Ref. TASK 27-50-00-866-009).

 (b)
 Install the LOCKING TOOL - FLAP/SLAT CONTROL LEVER (98D27803000000) on the flap/slat control lever when you work near the flaps.

 (c)
 Put a WARNING NOTICE in position on the flap/slat control lever to tell persons not to operate the flaps.


R (8) FOR 7504MM
 -Put an ACCESS PLATFORM 3M (10 FT)- ADJUSTABLE in position adjacent to the panel 193AT.
R (9) FOR 7505MM
 -Put an ACCESS PLATFORM 3M (10 FT)- ADJUSTABLE in position adjacent to the panel 194AT.
 4. Procedure
_________
 Subtask 25-62-42-020-050
 A. Removal of the Offwing Escape Slide Enclosure
 (Ref. Fig. 402/TASK 25-62-42-991-005)

 (1)
 Remove and retain the seal attach plate screws (10) and the countersunk washers (11).

 (2)
 Remove and retain the seal attach plate (12) and the seal strips (9).

 (3)
 Loosen the escape slide enclosure studs (17).

 (4)
 Move the top of the escape slide enclosure (7) outboard at an angle and hold it.

 (5)
 
中国航空网 www.aero.cn
航空翻译 www.aviation.cn
本文链接地址:A320飞机维护手册 AMM EQUIPMENT/FURNISHINGS 设备4(82)