(b)
Make sure the operating instructions placard is clean and that you can easily read it. The placard is installed on the side of the kit.
(c)
Examine the snap-hook that attaches the pack to the kit attach-loop on the escape-slide raft girt. Make sure that the snap-hook is not damaged or corroded and operates correctly.
NOTE : If you think that the kit or its attach items are in an
____ unsatisfactory condition, you must replace the kit.
(d) Remove the service history card from the kit pocket. Make sure that the expiration date of the age-limited module has not expired.
NOTE : The kits have a service cycle because some of the items
____ have life limits. If the service cycle has expired, you must remove the kit from the aircraft and install a serviceable kit.
(e) Put the service history card back into the kit pocket.
**ON A/C ALL
5. Close-up
________ R **ON A/C 001-002, 151-199, 301-399, 401-499,
Subtask 25-66-00-410-052-A
A. Close Access
(1)
Install the life vests (7580MM, 7581MM, 7583MM, 7584MM, 7585MM, 7586MM). Make sure that life vests are installed in all the required positions.
(2)
Install the DEMO life vests (7582MM) in the overhead-stowage compartments and close the doors.
(3)
Make sure that the work area is clean and clear of tool(s) and other items.
**ON A/C 003-049, 051-099, 101-149, 201-299,
Subtask 25-66-00-410-052
A. Close Access
(1)
Install the life vests (7580MM, 7581MM, 7583MM, 7584MM, 7585MM, 7586MM). Make sure that life vests are installed in all the required positions.
(2)
Install the DEMO life vests (7582MM) in the overhead-stowage compartments and close the doors.
EFF : ALL
25-66-00Page 604
(3)
Install the escape-slide raft survival-kits in the overhead-stowage compartments and close the doors.
(4)
Make sure that the work area is clean and clear of tool(s) and other items.
RAFT - LIFE (7519MM) - REMOVAL/INSTALLATION___________________________________________ TASK 25-66-41-920-001
Remove Supplemental Life Raft for Restoration 1. Reason for the Job__________________
Refer to the MPD TASK: 256600-01
2. Job Set-up Information______________________ A. Referenced Information
-------------------------------------------------------------------------------REFERENCE DESIGNATION -------------------------------------------------------------------------------
24-42-00-861-001 24-42-00-862-001 Energize the Ground Service Network from the External PowerDe-energize the Ground Service Network Supplied from the External Power
R **ON A/C 003-049, 101-105, 201-210,
R 25-66-41-991-002-A **ON A/C 051-099, Fig. 401
R R 25-66-41-991-002-C Fig. 401A **ON A/C 301-301, 303-399,
R R 25-66-41-991-002-B Fig. 401B **ON A/C 003-049, 051-099, 101-105, 201-210, 301-301, 303-399,
3. Job Set-up__________ Subtask 25-66-41-861-051
A. Energize the ground service network (Ref. TASK 24-42-00-861-001).
CES CES
Subtask 25-66-41-010-050
B. Get Access
R **ON A/C 003-049, 101-105, 201-210,
(Ref. Fig. 401/TASK 25-66-41-991-002-A)
R **ON A/C 051-099,
R (Ref. Fig. 401A/TASK 25-66-41-991-002-C)
R **ON A/C 301-301, 303-399,
R (Ref. Fig. 401B/TASK 25-66-41-991-002-B)
R **ON A/C 003-049, 051-099, 101-105, 201-210, 301-301, 303-399,
(1) Open the door/access panel of the stowage compartment(s).
NOTE : The location of the supplemental life raft(s) are shown with____ placards, which are bonded on the outside of the stowage compartment(s).
(2) If necessary, release/open the strap/clamp and remove the supplemental life raft(s) from the aircraft.
4. Procedure_________
Subtask 25-66-41-280-050-A
A. Workshop Procedure
(1) Do the restoration of the supplemental life raft. Refer to the Manufacturers Component Maintenance Manual (CMM) for the correct procedure.
Supplemental Life Raft/s - Component Location Figure 401/TASK 25-66-41-991-002-A
R EFF : 003-049, 101-105, 201-210, 25-66-41 Page 403 May 01/05
CES
R R Supplemental Life Raft/s - Location Figure 401A/TASK 25-66-41-991-002-C
R EFF : 051-099, 25-66-41 Page 404 May 01/05
CES
中国航空网 www.aero.cn 航空翻译 www.aviation.cn 本文链接地址：A320飞机维护手册 AMM EQUIPMENT/FURNISHINGS 设备4(170)
