(5)
Put blanking caps on the disconnected electrical connectors.
(6)
Remove the ELT (5):
(a)
Only do these steps if a programming dongle (19) is installed in the aircraft:
(b)
Hold the ELT (5) and release the burr-strips (velcro) on the straps (3).
(c)
Pull the auxiliary-antenna (4) out of the loops (25) on the straps (3).
1_ Connect a maintenance dongle to the RCP connector (12).
2_ Set the ON/ARM/OFF switch (10) to the ARM position for a short
time.
NOTE : This programs the ELT (5) with a maintenance____
identification-data (ID). If you disconnect the
maintenance dongle, without programming the ELT (5)
with a maintenance ID, the ELT (5) retains its aircraft
ID.
3_ Set the ON/ARM/OFF switch (10) back to the OFF position.
4_ Disconnect the maintenance dongle from the RCP connector (12).
ELT 110MX Figure 401/TASK 25-65-35-991-001
R EFF : 151-199, 211-228, 301-302, 25-65-35 Page 403 Feb 01/05
CES
NOTE : Be careful with the auxiliary-antenna (4), it is held in
____ the loops (25) folded back on itself. When you remove the auxiliary-antenna (4) it will move quickly back to a straight position. The auxiliary-antenna is (4) attached to the ELT (5) with the safety strap (17).
(d) Carefully remove the ELT (5) and the auxiliary-antenna (4) from the bracket (1).
TASK 25-65-35-400-001
Installation of the Emergency Locator Transmitter (ELT) 110MX
1. Reason for the Job
__________________
Self Explanatory
2. Job Set-up Information
______________________
A. Fixtures, Tools, Test and Support Equipment
-------------------------------------------------------------------------------
REFERENCE QTY DESIGNATION
-------------------------------------------------------------------------------
No specific 1 SCRAPER - NON METALLIC
B. Consumable Materials
-------------------------------------------------------------------------------
REFERENCE DESIGNATION
-------------------------------------------------------------------------------
R Material No. 07-020 AI TNA 007-10012 IDENTIFICATION PAINT (Ref. 20-31-00) Material No. 11-004 USA MIL-T-81533 1.1.1TRICHLOROETHANE (METHYL CHLOROFORM) (Ref. 20-31-00) Material No. 19-003 USA AMS 3819 LINT-FREE COTTON CLOTH (Ref. 20-31-00)
C. Referenced Information
-------------------------------------------------------------------------------
REFERENCE DESIGNATION
-------------------------------------------------------------------------------
24-42-00-861-001 Energize the Ground Service Network from the External Power 24-42-00-862-001 De-energize the Ground Service Network Supplied from
the External Power 25-23-42-000-002 Removal of the Ceiling Panels - Aft Utility Area 25-23-42-400-002 Installation of the Ceiling Panels - Aft Utility Area 25-65-00-740-001 Emergency Locator Transmitter (ELT) System - BITE
Test
-------------------------------------------------------------------------------REFERENCE DESIGNATION -------------------------------------------------------------------------------
25-65-00-840-001 Procedure after a Change of Aircraft Registration Number 25-65-35-991-001 Fig. 401
3. Job Set-up
__________
Subtask 25-65-35-860-050
A. Aircraft Maintenance Configuration
(1)
Make sure the ground service network is energized (Ref. TASK 24-42-00-861-001).
(2)
Make sure the ceiling panel 261BC is removed (Ref. TASK 25-23-42-000-002).
4. Procedure
_________
Subtask 25-65-35-560-050-A
A. Preparation for Installation
(1) If the aircraft registration code/number (ICAO) is changed refer to (Ref. TASK 25-65-00-840-001).
Subtask 25-65-35-420-050
B. Installation of the ELT 110MX
(Ref. Fig. 401/TASK 25-65-35-991-001)
WARNING : MAKE SURE THAT THERE IS A GOOD FLOW OF AIR THROUGH THE WORK
_______ AREA WHEN YOU USE SPECIAL MATERIALS. IF YOU GET ONE OF THESE MATERIALS ON YOUR SKIN, IN YOUR MOUTH OR IN YOUR EYES : -FLUSH IT AWAY WITH A FLOW OF CLEAN WATER FOR BETWEEN 10 AND 15 MINUTES. -GET IMMEDIATE MEDICAL AID IF IRRITATION OCCURS. DO NOT BREATHE THE FUMES FROM THE MATERIAL. DO NOT SMOKE WHEN YOU USE THE MATERIAL. DO NOT USE THE MATERIAL NEAR A FLAME, SPARKS OR SOURCES OF HEAT. THESE MATERIALS ARE DANGEROUS : THEY ARE POISONOUS, FLAMMABLE AND SKIN IRRITANTS.
(1) Clean the component interface and/or the adjacent area. WARNING : OBEY THE MANUFACTURER'S INSTRUCTIONS WHEN YOU USE
中国航空网 www.aero.cn
航空翻译 www.aviation.cn
本文链接地址：A320飞机维护手册 AMM EQUIPMENT/FURNISHINGS 设备4(161)
