A320飞机维护手册 AMM EQUIPMENT/FURNISHINGS 设备2(23)

曝光台 注意防骗 网曝天猫店富美金盛家居专营店坑蒙拐骗欺诈消费者

No specific circuit breaker(s) safety clip(s) No specific 1 CAP - BLANKING, PLASTIC No specific 1 PLUG - BLANKING, PLASTIC No specific 1 SCREWDRIVER - SMALL
 B. Referenced Information
 -------------------------------------------------------------------------------REFERENCE DESIGNATION -------------------------------------------------------------------------------
24-42-00-861-001 Energize the Ground Service Network from the External
 Power 33-51-11-000-001 Removal of the Cabin Emergency Lights 33-51-13-000-001 Removal of the Cabin Wall-Mounted
 Emergency-Exit-Markers 33-51-16-000-001 Removal of the Emergency Exit Sign 52-10-00-010-001 Opening of the Passenger/Crew Door 25-23-45-991-003-A Fig. 402
 3. Job Set-up
__________
 Subtask 25-23-45-861-052
 A. Energize the ground service network
 (Ref. TASK 24-42-00-861-001)

 EFF : ALL

25-23-45Page 414
Feb 01/03
R
 CES  EFF : ALL

 Subtask 25-23-45-010-051
 B. Get Access
 (1) Open the FWD passenger/crew door, Zone 841 (Ref. TASK 52-10-00-010-001).
 (2) Remove the emergency exit sign 40WL (Ref. TASK 33-51-16-000-001).
 (3) Remove the cabin emergency light 20WL (Ref. TASK 33-51-11-000-001).
 (4) Remove the cabin wall-mounted emergency-exit-marker 90WL2 (Ref. TASK 33-51-13-000-001).
 Subtask 25-23-45-865-050
 C. Open, safety and tag this(these) circuit breaker(s):
 -------------------------------------------------------------------------------PANEL SERVICE IDENT. LOCATION -------------------------------------------------------------------------------2000VU VACUUM CLEANER SOCKET-CABIN Z222 1ME A03
 4. Procedure_________
 Subtask 25-23-45-020-052-A 
R R  A. Removal of the door frame linings 222RW, 222SW, 222VW, 222UW, 222TW, (Ref. Fig. 402/TASK 25-23-45-991-003-A) 
R  (1) Remove the lining 222SW:
 CAUTION : MAKE MATCH MARKS ON ALL THE ELECTRICAL WIRES BEFORE YOU_______ DISCONNECT THEM. INCORRECT CONNECTION OF WIRES WILL CAUSE DAMAGE TO EQUIPMENT. 
R R  (a) Disconnect the electrical connectors (19) from the electrical harness.
 (b) Put CAP - BLANKING, PLASTIC on the disconnected electrical connectors. 
R  (c) Loosen the clamp (6) and disconnect the hose (5).
 (d) Put PLUG - BLANKING, PLASTIC on the disconnected line ends.
 (e) Hold the lining 222SW in position.

25-23-45Page 415

R Door Frame Linings at the FWD Passenger/Crew Door, right Side Figure 402/TASK 25-23-45-991-003-A12 (SHEET 1)
 EFF : ALL

25-23-45Page 416
Feb 01/03
 CES

R Door Frame Linings at the FWD Passenger/Crew Door, right Side Figure 402/TASK 25-23-45-991-003-A22 (SHEET 2)
 EFF : ALL

25-23-45Page 417
Feb 01/03
 CES

 (f) Remove the caps (3), the screws (1), (4) and (8), the washers (2) and (7) and remove the lining 222SW.
 (2)
 Remove the lining 222UW:

 (a)
 Remove the handgrip: CAUTION : DO NOT USE TOO MUCH FORCE WHEN YOU REMOVE THE COVER AS

_______

 (b)
 Remove the screws (16), the washers (17) and the latch hook (18).

 (c)
 Remove the screws (1), the washers (2) and the lining 222UW.

 

 (3)
 Remove the lining 222VW:

 (a) Remove the screws (1) and the washers (2) and remove the lining 222VW.

 (4)
 Remove the lining 222TW:

 (a) Remove the caps (3), the screws (4) and (1), the washers (2) and remove the lining 222TW.

 (5)
 Remove the lining 222RW:

 THIS CAN CAUSE DAMAGE TO THE RETAINER.
 1_ Put a SCREWDRIVER - SMALL with a flat blade between the
 handgrip cover (9) and the handgrip (14).
 2_ Carefully push the lugs (10) of the handgrip cover (9) in the
 direction of the arrows and remove the handgrip cover (9).
 3_ Remove the screws (11) and (12), the plates (13), the spacer
 (15) (if installed) and the handgrip (14).

 (a) Remove the handgrip: CAUTION : DO NOT USE TOO MUCH FORCE WHEN YOU REMOVE THE COVER AS
_______ THIS CAN CAUSE DAMAGE TO THE RETAINER.
 1 Put a SCREWDRIVER - SMALL with a flat blade between the
_ handgrip cover (9) and the handgrip (14).
 EFF : ALL

25-23-45Page 418
Feb 01/03
R
 CES

 2_ Carefully push the the lugs (10) of the handgrip cover (9) in
 the direction of the arrows and remove the handgrip cover (9).
 3_ Remove the screws (11) and (12), the plates (13), the spacer
 (15) (if installed) and the handgrip (14).
　
中国航空网 www.aero.cn
航空翻译 www.aviation.cn
本文链接地址：A320飞机维护手册 AMM EQUIPMENT/FURNISHINGS 设备2(23)