4. Procedure
_________
(Ref. Fig. 410/TASK 29-22-51-991-026) Subtask 29-22-51-020-063
A. Removal of the Delta Pressure Indicator
(1)
Remove the delta pressure indicator (1).
(2)
Put a blanking cap in the open port of the RAT hydraulic pump housing (4).
(3)
Remove and discard the packings (2), (3) from the delta pressure indicator (1).
R 1EFF : 062-099, 106-149, 151-199, 204-299, 1 29-22-51Page 492 1301-399, 401-499, 1Config-1 Aug 01/05 1 1 1CES 1
RAT Delta Pressure Indicator
Figure 410/TASK 29-22-51-991-026
R 1EFF : 062-099, 106-149, 151-199, 204-299, 1 29-22-51Page 493 1301-399, 401-499, 1Config-1 Aug 01/05 1 1 1CES 1 TASK 29-22-51-400-012
Installation of the RAT Delta Pressure Indicator
WARNING : PUT THE SAFETY DEVICES AND THE WARNING NOTICES IN POSITION BEFORE YOU
_______ START A TASK ON OR NEAR:
-
THE FLIGHT CONTROLS
-
THE FLIGHT CONTROL SURFACES
-
THE LANDING GEAR AND THE RELATED DOORS
-COMPONENTS THAT MOVE.
WARNING : MAKE SURE THAT THE TRAVEL RANGES OF THE FLIGHT CONTROL SURFACES ARE
_______ CLEAR BEFORE YOU PRESSURIZE/DEPRESSURIZE A HYDRAULIC SYSTEM.
WARNING : MAKE SURE THAT THE GROUND SAFETY-LOCKS ARE IN POSITION ON THE LANDING
_______ GEAR.
1. Reason for the Job
__________________
Self Explanatory
2. Job Set-up Information
______________________
A. Fixtures, Tools, Test and Support Equipment
-------------------------------------------------------------------------------REFERENCE QTY DESIGNATION -------------------------------------------------------------------------------
No specific blanking cap No specific safety barriers No specific warning notices No specific Torque Wrench : range 0.20 to 3.60 m.daN
(2.00 to 26.00 lbf.ft)
B. Consumable Materials
-------------------------------------------------------------------------------REFERENCE DESIGNATION -------------------------------------------------------------------------------
Material No. 02-003 F NSA 307110 TYPE 4 HYDRAULIC FLUID (PHOSPHATE ESTER BASE) (Ref. 20-31-00)
R 1EFF : 062-099, 106-149, 151-199, 204-299, 1 29-22-51Page 494 1301-399, 401-499, 1Config-1 Aug 01/05 1 1 1CES 1
C. Expendable Parts -------------------------------------------------------------------------------
FIG.ITEM --------- |DESIGNATION ---------------------------------------- |IPC-CSN------------------------------
2 packing 29-22-51 01A-250
3 packing 29-22-51 01A-260
D. Referenced Information
------------------REFERENCE -------------------------------DESIGNATION ------------------------------
-------------------------------------------------------------------------------
29-00-00-864-001 Put the Related Hydraulic System in the Depressurized
Configuration before Maintenance Action 29-00-00-910-002 Safety Procedures of the Hydraulic System 29-10-00-863-003 Pressurize the Blue Hydraulic System with a Ground
Power Supply 29-10-00-864-003 Depressurize the Blue Hydraulic System 29-14-00-614-001 Depressurization of the Hydraulic Reservoirs 29-14-00-614-002 Pressurization of the Hydraulic Reservoirs through
the Ground Connector 29-22-00-710-007 Operational Test of the Manual Deployment and the
Retraction of the Ram Air Turbine 29-22-00-869-005 Extension of the Ram Air Turbine (RAT) on the Ground 29-22-00-869-006 Retraction of the Ram Air Turbine (RAT) on the Ground 29-22-51-991-026 Fig. 410
3. Job Set-up
__________
Subtask 29-22-51-860-104
A. Aircraft Maintenance Configuration
WARNING : OBEY THE HYDRAULIC SAFETY PROCEDURES.
_______
(1)
Obey the hydraulic safety procedures (Ref. TASK 29-00-00-910-002).
(2)
Make sure that the Blue hydraulic system is depressurized and put it in the maintenance configuration (Ref. TASK 29-00-00-864-001).
(3)
Make sure that the reservoir of the Blue hydraulic system is depressurized (Ref. TASK 29-14-00-614-001).
R 1EFF : 062-099, 106-149, 151-199, 204-299, 1 29-22-51Page 495 1301-399, 401-499, 1Config-1 Aug 01/05 1 1 1CES 1
(4)
Make sure that the warning notices are in position to tell persons not to pressurize the Blue hydraulic system:
-in the cockpit on the hydraulic section 40VU of the overhead panel, - on the ground service panel of the Blue hydraulic system.
(5)
Make sure that the safety barriers are in position.
(6)
Make sure that the RAT is extended (Ref. TASK 29-22-00-869-005). Subtask 29-22-51-865-101
中国航空网 www.aero.cn
航空翻译 www.aviation.cn
本文链接地址：A320飞机维护手册 AMM HYDRAULIC POWER 液压6(33)
