D. Test
(1)
Make sure that the level of the fluid in the reservoir of the Blue hydraulic system is correct. Add fluid as necessary (Ref. TASK 12-12-29-611-001) or (Ref. TASK 12-12-29-611-002).
(2)
Pressurize the reservoir of the Blue hydraulic system (Ref. TASK 29-14-00-614-002).
(3)
Pressurize the Blue hydraulic system (Ref. TASK 29-10-00-863-003).
(4)
Examine the hydraulic connections of the RAT and make sure that there are no leaks.
Subtask 29-22-51-942-053
E. Put the aircraft back to the serviceable condition.
(1)
Remove the container from below the hydraulic connections.
(2)
Make sure that the work area is clean and clear of tool(s) and other items.
Subtask 29-22-51-869-051
F. Retract the RAT (Ref. TASK 29-22-00-869-002). Subtask 29-22-51-710-051
G. Do the operational and the functional test of the RAT (Ref. TASK 29-22-00-720-001).
5. Close-up
________ Subtask 29-22-51-914-052
A. Apply SEALANTS (Material No. 09-018) between the sidewall panel (8) and the structure (9).
R 1EFF : 001-049, 051-061, 101-105, 201-203, 1 29-22-51Page 416 1 1 Config-1 May 01/05 1 1 1CES 1 Subtask 29-22-51-410-059
B. Installation of the sidewall panel
(1)
Put the sidewall panel (8) in position.
(2)
Install the sidewall panel (8) with the screws (6), (7) and the washers (5).
Subtask 29-22-51-370-050
C. Apply STRUCTURE PAINTS (Material No. 16-003) around the sidewall panel
(2)
and the support bearing (52). Subtask 29-22-51-410-051
D.
Close Access
(1)
Install the access panels 147BB, 147CB.
(2)
Close the access door 195BB.
(3)
Close the left main gear main door (Ref. TASK 32-12-00-410-001). Subtask 29-22-51-942-052
E.
Remove the warning notice(s).
R 1EFF : 001-049, 051-061, 101-105, 201-203, 1 29-22-51Page 417 1 1 Config-1 May 01/05 1 1 1CES 1R **ON A/C 062-099, 106-149, 151-199, 204-299, 301-399, 401-499,
TASK 29-22-51-000-010
Removal of the Ram Air Turbine (2GE)
WARNING : PUT THE SAFETY DEVICES AND THE WARNING NOTICES IN POSITION BEFORE YOU
_______
START A TASK ON OR NEAR:
-
THE FLIGHT CONTROLS
-
THE FLIGHT CONTROL SURFACES
-
THE LANDING GEAR AND THE RELATED DOORS
-COMPONENTS THAT MOVE.
WARNING : MAKE SURE THAT THE TRAVEL RANGES OF THE FLIGHT CONTROL SURFACES ARE
_______
CLEAR BEFORE YOU PRESSURIZE/DEPRESSURIZE A HYDRAULIC SYSTEM.
WARNING : MAKE SURE THAT THE RAT TRAVEL RANGE IS CLEAR BEFORE YOU
_______
EXTEND/RETRACT THE RAT.
WARNING : MAKE SURE THAT THE GROUND SAFETY-LOCKS ARE IN POSITION ON THE LANDING
_______
GEAR.
1. Reason for the Job
__________________
Self Explanatory
2. Job Set-up Information
______________________
A. Fixtures, Tools, Test and Support Equipment
-------------------------------------------------------------------------------REFERENCE QTY DESIGNATION -------------------------------------------------------------------------------
No specific blanking caps
No specific blanking plugs
No specific circuit breaker(s) safety clip(s)
No specific protective covers
No specific safety barriers
No specific warning notice(s)
No specific container 4.0 l (1.0566 USgal)
R 1EFF : 062-099, 106-149, 151-199, 204-299, 1 29-22-51Page 418 1301-399, 401-499, 1Config-1 Aug 01/05 1 1 1CES 1
B. Referenced Information
-------------------------------------------------------------------------------REFERENCE DESIGNATION -------------------------------------------------------------------------------
29-00-00-864-001 Put the Related Hydraulic System in the Depressurized
Configuration before Maintenance Action 29-00-00-910-002 Safety Procedures of the Hydraulic System 29-14-00-614-001 Depressurization of the Hydraulic Reservoirs 29-22-00-869-005 Extension of the Ram Air Turbine (RAT) on the Ground 32-12-00-010-001 Open the Main Gear Doors for Access 29-22-51-991-024 Fig. 404
3. Job Set-up
__________ Subtask 29-22-51-941-067
A. Put the safety barriers in position.
(1) Put the warning notice(s) in position to tell persons not to pressurize the Blue hydraulic system:
-in the cockpit on the hydraulic section 40VU of the overhead panel, - on the ground service panel of the Blue hydraulic system.
中国航空网 www.aero.cn
航空翻译 www.aviation.cn
本文链接地址：A320飞机维护手册 AMM HYDRAULIC POWER 液压6(11)
