TASK 32-41-22-004-001
2. Hydrualic Pressure Surge Accumualtor - Removal (Fig. 401)______________________________________________
A. General
(1)
In subsequent steps the hydraulic pressure surge accumulator is referred to as the surge accumulator.
B.
References
(1)
AMM 09-11-00/201, Towing
(2)
AMM 24-22-00/201, Manual Control
(3)
AMM 29-11-00/201, Main Hydraulic Supply System
(4)
AMM 32-00-30/201, Landing Gear Door Locks
(5)
AIPC 32-41-32 Fig. 1
C.
Access
(1)
Location Zones 138 Body Landing Gear Well, RH (Body Gear Hydraulic Pressure Surge Accumulator) 571 Rear Spar to Landing Gear Support Beam, LH (Left Wing Gear Hydraulic Pressure Surge Accumulator)
671 Rear Spar to Landing Gear Support Beam, RH (Right Wing Gear Hydraulic Pressure Surge Accumulator)
EFFECTIVITYùùùùùùùùùùùùùùùùùùùùùùùùùùùùùù. ú
32-41-22
ALL ú ú 01 Page 401 ú Jun 15/98
BOEING PROPRIETARY - Copyright (C) - Unpublished Work - See title page for details.
A
747-400 MAINTENANCE MANUAL
D. Prepare for the Removal
S 494-002
(1) Make sure the landing gear ground locks are installed
(AMM 09-11-00/201).
S 494-003
WARNING: YOU MUST CAREFULLY DO THE STEPS IN THE TASK BELOW TO INSTALL
_______ THE DOOR LOCKS ON THE LANDING GEAR DOORS. THE DOORS CAN CLOSE QUICKLY IF YOU DO NOT INSTALL THE DOOR LOCKS CORRECTLY. THIS CAN CAUSE INJURY TO PERSONS OR DAMAGE TO EQUIPMENT.
(2)
Do this task: "Installation of the Door Locks on the Wing Landing Gear" (AMM 32-00-30/201).
S 494-028
(3)
Do this task: "Installation of the Door Locks on the Body Landing Gear" (AMM 32-00-30/201).
S 944-004
(4)
Make sure the wheel chocks are installed at all wheels.
S 864-022
(5)
Supply electrical power (AMM 24-22-00/201).
S 864-005
(6)
Release the parking brake.
(7)
Remove the pressure from hydraulic system No. 4 (AMM 29-11-00/201).
S 684-007
(8)
Do these steps to remove the hydraulic fluid from the brake accumulator:
(a)
Look at the pressure indication of the HYD BRAKE PRESS gage on the Captain's Main Instrument Panel, P1.
S 864-006
EFFECTIVITYùùùùùùùùùùùùùùùùùùùùùùùùùùùùùù. ú
32-41-22
ALL ú ú 01 Page 402 ú Oct 10/97
BOEING PROPRIETARY - Copyright (C) - Unpublished Work - See title page for details.
A
747-400 MAINTENANCE MANUAL
(b) Slowly push one set of brake pedals to the limit of travel, hold momentarily, and then release. Do this cycle again 10 times. 1) Make sure the pressure indication of the HYD BRAKE PRESS
gage decreases during the manual brake operation.
2) After ten cycles of manual brake operation, make sure the HYD BRAKE PRESS gage does not continue to decrease in pressure.
S 684-008
(9)
Do these steps to release the gas from the surge accumulator:
(a)
Remove the dust cap from the air charging valve.
WARNING:_______DO NOT LOOSEN THE VALVE BODY. IF YOU LOOSEN THE VALVE BODY, THE VALVE CAN BLOW OFF. THIS CAN CAUSE INJURY TO PERSONS OR DAMAGE TO EQUIPMENT.
(b)
Loosen the swivel hexagonal nut on the air charging valve a maximum of one turn.
(c)
Look at the pressure gage located near the surge accumulator.
(d)
Make sure the pressure gage shows zero pressure.
E.
Procedure
S 024-009
(1)
Do these steps to remove the surge accumulator:
(a)
Disconnect the hydraulic line from the surge accumulator.
(b)
Put a cap on the hydraulic line and a plug on the surge accumulator port.
(c)
Disconnect the gas line from the surge accumulator.
(d)
Hold the surge accumulator in its position.
中国航空网 www.aero.cn
航空翻译 www.aviation.cn
本文链接地址：747-400 AMM 飞机维护手册 起落架 LANDING GEAR 6(108)
