28-22-17
ALL ú ú 03 Page 402 ú Oct 18/00
BOEING PROPRIETARY - Copyright (C) - Unpublished Work - See title page for details.
A
747-400 MAINTENANCE MANUAL
S 864-020
(3)
Close these circuit breakers:
(a)
On the main power distribution panel, P6:
1) 6F20, FLT DK LIGHTS PILOTS MISC IND 2
2) 6F26, FLT DK LIGHTS F/O IND
3) 6F27, FLT DK LIGHTS F/O IND & DGTL DSPL
4) 6L14, FUEL XFEED VALVE ENG 1
5) 6L15, FUEL XFEED VALVE ENG 2
6) 6L16, FUEL XFEED VALVE ENG 3
7) 6L17, FUEL XFEED VALVE ENG 4
(b)
On the DC power distribution panel, P180:
1) 180E2, OVRD/JTSN PUMP CONT L
2) 180E3, FUEL OVRD/JTSN PUMP CONT FWD 2 & 3
3) 180E4, PUMP CONT BST 1 AFT 4 FWD
4) 180E18, FUEL OVRD/JTSN PUMP CONT AFT 2 & 3
5) 180E19, PUMP CONT BOOST 1 FWD 4 AFT
6) 180H4, PUMP CONT BST 2 AFT 3 FWD
7) 180H18, OVRD/JTSN PUMP CONT R
8) 180H19, PUMP CONT BOOST 2 FWD 3 AFT
(c)
On the left power distribution center, P414:
1) 414E24, MN-AFT PUMP CONT BOOST 2
S 714-016
(4)
Do these two tasks in this procedure: Engine Fuel-Feed System (AMM 28-22-00/501).
(a)
Fuel Crossfeed Valves - Operational Test.
(b)
Fuel Pumps - Operational Test.
EFFECTIVITYùùùùùùùùùùùùùùùùùùùùùùùùùùùùùù. ú
28-22-17
ALL ú ú 04 Page 403 ú Oct 18/00
BOEING PROPRIETARY - Copyright (C) - Unpublished Work - See title page for details.
A
747-400
MAINTENANCE MANUAL
FUEL MANAGEMENT CONTROL MODULE, M154
SEE A
QUARTER-TURN FASTENERS (4 LOCATIONS)
FUEL FUEL
1 X FEED 2 3 X FEED 4
VALVE VALVE L CTR R VALVE VALVE
a a a a
w w ON w ON w w w
PRESS PRESS
a a
MAIN 1 OVRD 2 MAIN MAIN 3 OVRD MAIN 4
ON F ON ON ON ON F ON
w W w w w w W w
a PRESS D a PRESS a PRESS a PRESS a PRESS D a PRESS
ON A ON ON ON ON A ON
w F w w w w F w
a PRESS T a PRESS a PRESS a PRESS PRESS a T a PRESS
FUEL MANAGEMENT CONTROL MODULE, M154
A
Fuel Management Control Module, M154
Figure 401
EFFECTIVITYùùùùùùùùùùùùùùùùùùùùùùùùùùùùùù. ú
28-22-17
ALL ú ú 04 Page 404 ú Oct 10/95
BOEING PROPRIETARY - Copyright (C) - Unpublished Work - See title page for details.
F21292
A
747-400 MAINTENANCE MANUAL
MAIN TANK BOOST PUMP REMOVAL CHECK VALVE - REMOVAL/INSTALLATION
______________________________________________________________
1. General_______
A. This procedure contains instructions to remove and install the removal check valve for the main tank boost pumps.
B. The removal check valve is installed in each main tank boost pump housing, found in the inboard and outboard main tanks.the check valve is a spring-loaded poppet type valve located in the inlet tube.
C. Access to the removal check valves is through the applicable fuel tank access doors in the inboard and outboard main tanks.
TASK 28-22-18-004-001
2. Removal Check Valve Removal (Fig. 401)___________________________
A. References
(1)
AMM 28-11-00/201, Fuel Tanks
中国航空网 www.aero.cn
航空翻译 www.aviation.cn
本文链接地址：747-400 AMM 飞机维护手册 燃油 FUEL 3(76)
