R Subtask 56-12-11-210-061
R E. Sealing Check
R (1) Close the sliding window
R (2) Apply water to the periphery of the sliding window from the outside
R of the aircraft
R (3) Wait ten minutes and make sure that there is no water leakage at
R level of the window frame.
R (4) If water goes into the cockpit, make sure that the adjustments are
R correct and that the seal is in the correct condition.
R (5) Dry if necessary.
R 5. Close-up________
R Subtask 56-12-11-420-060
R A. Installation of the Sliding Window Lining
R (Ref. Fig. 414/TASK 56-12-11-991-030)
R (1) Lift the plate (17) and put the sliding window lining (16) in
R position.
R (2) Put the plate (17) in position, install the screws (12) and tighten
R them.
R (3) Install the screws (11) and tighten them.
R (4) Install the washer (2) and the screw (3).
R (5) Tighten the screw (3).
R (6) Install the blanking plug (4).
R (7) Open the sliding window.
R (8) Install the guide (13) on the sliding window lining (16) with the
R washer (14) and the screw (15).
R (9) Tighten the screw (15).
R (10) Install the washer (8) and the screw (9).
1EFF : 051-099, 1 56-12-11Page 479 1 1 May 01/05 1 1 1CES 1 1EFF : 051-099, 1 56-12-11Page 480 1 1 May 01/05 1 1 1CES 1
R (11) Tighten the screw (9).
R (12) Put the handle (6) in position.
R (13) Install the washer (20) and the screw (21).
R NOTE : Do not tighten the screw (21) fully.____
R (14) Install the washer (18) and the screw (19).
R (15) Tighten the screw (19) and (21).
R (16) Put the pencil holder assembly (7) in position.
R (17) Install the screw (5) and tighten it.
R (18) Connect the electrical connector (10).
R (19) Close the sliding window (Ref. TASK 56-12-11-410-001).
R Subtask 56-12-11-420-061
R B. Installation of Component
R (1) Install the map table light (Ref. TASK 33-12-12-400-002).
R FOR 8DG1
R 41LE
R FOR 8DG2
R 42LE
R (2) Install the map table light rheostats (Ref. TASK 33-12-18-400-001).
R FOR 8DG1
R 39LE
R FOR 8DG2
R 40LE
R Subtask 56-12-11-865-061
R C. Remove the safety clip(s) and the tag(s) and close this(these) circuit
R breaker(s):
R 1DG1, 4DG1, 5DG1, 1DG2, 4DG2, 5DG2, 5SQ1, 5SQ2.
R (1) Remove the safety clip(s) and the tag(s) and close this(these)
R circuit breaker(s):
R Subtask 56-12-11-710-051
R D. Test
R (1) Do the operational test of the anti-icing and defogging of the
R sliding windows (Ref. TASK 30-42-00-710-001).
R Subtask 56-12-11-110-060
R E. Cleaning of the Sliding Window
R (1) Clean the sliding window (Ref. TASK 56-10-00-110-003).
R Subtask 56-12-11-942-057
R F. Close Access
R (1) Close the FWD passenger/crew door (Ref. TASK 52-10-00-410-001).
中国航空网 www.aero.cn
航空翻译 www.aviation.cn
本文链接地址:A320飞机维护手册 AMM WINDOWS 风挡 窗户(67)