R Sliding Windows - Lining Panels
R Figure 402/TASK 56-12-11-991-033
R 1EFF : 051-099, 1 56-12-11 Page 405
1 1 May 01/05
1 1
1CES 1
R (d) Loosen the clamp (28) and disconnect the duct (27).
R (e) Remove the lining panel (29) 211KC (212KC).
R (3) Removal of the sliding window lining (16)
R (a) Open the sliding window 8DG1 (8DG2) (Ref. TASK 56-12-11-010-001).
R (b) Remove the screw (5) and remove the pencil holder assembly (7).
R (c) Remove the screw (21) and the washer (20).
R (d) Remove the screw (19) and the washer (18).
R (e) Remove the handle (6).
R (f) Remove the screw (9) and the washer (8).
R (g) Remove the screw (15) and the washer (14).
R (h) Close the sliding window.
R (i) Remove the blanking plug (4), remove the screw (3) and the washer
R (2).
R (j) Remove the screws (11).
R (k) Remove the screws (12).
R (l) Lift the plate (17) and remove the sliding window lining (16).
R (m) Disconnect the electrical connector (10) from the receptacle.
R (n) Put blanking caps on the disconnected electrical connectors.
R Subtask 56-12-11-020-058
R B. Removal of the Aft Upper Rail
R (Ref. Fig. 403/TASK 56-12-11-991-032)
R (1) Remove the bolts (54),(55) and the nuts (57).
R (2) Remove the aft upper rail (56) from its support.
R 1EFF : 051-099, 1 56-12-11Page 406 1 1 May 01/05 1 1 1CES 1
R Sliding Windows - Removal/Installation
R Figure 403/TASK 56-12-11-991-032
R 1EFF : 051-099, 1 56-12-11 Page 407
1 1 May 01/05
1 1
1CES 1
R Subtask 56-12-11-020-059
R C. Removal of the Sliding Window
R CAUTION : BE CAREFUL WHEN YOU REMOVE THE SLIDING WINDOW.THE HANDLE IS_______
R SPRING -LOADED AND WILL MOVE SUDDENLY WHEN YOU REMOVE THE
R WINDOW FROM THE TRACK. IF YOU ARE NOT CAREFUL THE HANDLE CAN
R HIT YOU.
R (1) Move the sliding window assembly until it touches the rear stop. Then
R remove it.
R Subtask 56-12-11-110-057
R D. Cleaning
R WARNING : USE SOLVENTS/CLEANING AGENTS, SEALANTS AND OTHER SPECIAL_______
R MATERIALS ONLY WITH A GOOD SUPPLY OF AIR.
R OBEY THE MANUFACTURERS INSTRUCTIONS.
R PUT ON PROTECTIVE CLOTHING.
R DO NOT GET THEM IN YOUR MOUTH.
R DO NOT SMOKE.
R DO NOT BREATHE THE GAS.
R THESE MATERIALS ARE POISONOUS, FLAMMABLE AND SKIN IRRITANT.
R GET MEDICAL HELP IF YOUR SKIN OR EYES BECOME IRRITATED.
R (1) Remove the sealant with a non-metallic scraper from the aft upper
R rail (56) and from its support.
R (2) Clean the aft upper rail (56) and its support with the CLEANING
R AGENTS (Material No. 11-003) and MISCELLANEOUS (Material No. 19-003).
R 1EFF : 051-099, 1 56-12-11Page 408 1 1 May 01/05 1 1 1CES 1
R TASK 56-12-11-400-001-A
R Installation of the Sliding Windows R WARNING : MAKE SURE THAT THE CIRCUIT BREAKERS RELATED TO THE WEATHER RADAR ARE
_______ R OPENED, SAFETIED AND TAGGED.
R 1. Reason for the Job
__________________
R This procedure is applicable to the glass windows (SPS supplier, P/N R SPS...). R 2. Job Set-up Information
______________________
R A. Fixtures, Tools, Test and Support Equipment
R -------------------------------------------------------------------------------R REFERENCE QTY DESIGNATION
R -------------------------------------------------------------------------------
R No specific dynamometer 25 daN (56.2022 lbf)
R No specific Torque Wrench : range 0.00 to 1.20 m.daN
R (0.00 to 9.00 lbf.ft)
R B. Consumable Materials
R -------------------------------------------------------------------------------R REFERENCE DESIGNATION
R -------------------------------------------------------------------------------
R Material No. 04-004 R R R Material No. 08-002A R R Material No. 09-019 R R R Material No. 19-010 R R USA MIL-PRF-23827 TYPE I SYNTH.ESTER BASED GREASE HIGH PRESSURE (Ref. 20-31-00)
中国航空网 www.aero.cn
航空翻译 www.aviation.cn
本文链接地址：A320飞机维护手册 AMM WINDOWS 风挡 窗户(49)
