R 1EFF : 051-099, 1 56-12-11Page 461 1 1 May 01/05 1 1 1CES 1
R C. Referenced Information
R -------------------------------------------------------------------------------R REFERENCE DESIGNATION R -------------------------------------------------------------------------------
R 33-12-12-000-002 R 33-12-18-000-001 R 52-10-00-010-001 R 56-12-11-010-001 R 56-12-11-991-030 R 56-12-11-991-029
R 3. Job Set-up
__________
R Subtask 56-12-11-941-062
R A. Get Access Removal of the Map Table Lights (41LE, 42LE) Removal of the Map Table Light Rheostats (39LE, 40LE) Opening of the Passenger/Crew Door Opening of the Cockpit Sliding Windows Fig. 414 Fig. 415
R (1) Put the access platform in position at the zone 210 in front of the R sliding window.
R Subtask 56-12-11-865-057
R B. Open, safety and tag this(these) circuit breaker(s):
R -------------------------------------------------------------------------------R PANEL DESIGNATION IDENT. LOCATION R -------------------------------------------------------------------------------R 121VU COM NAV/RADAR/2 5SQ2 K14 R 121VU COM NAV/RADAR/1 5SQ1 K13 R FOR 8DG1 R 122VU ANTI ICE/WINDOWS/L 4DG1 X14 R 122VU ANTI ICE/WHC/1 5DG1 X13 R 123VU ANTI ICE/L/WHSLD 1DG1 AF10 R FOR 8DG2 R 122VU ANTI ICE/WINDOWS/R 4DG2 W14 R 122VU ANTI ICE/WHC/2 5DG2 W13 R 123VU ANTI ICE/R/WHSLD 1DG2 AF03
R 1EFF : 051-099, 1 56-12-11Page 462 1 1 May 01/05 1 1 1CES 1
R Subtask 56-12-11-010-059
R C. Get Access
R (1) Put an access platform in position at the FWD passenger/crew door
R 831.
R (2) Open the FWD passenger/crew door (Ref. TASK 52-10-00-010-001).
R Subtask 56-12-11-020-060
R D. Removal of Component
R (1) Remove the map table light (Ref. TASK 33-12-12-000-002).
R FOR 8DG1
R 41LE
R FOR 8DG2
R 42LE
R (2) Remove the map table light rheostats (Ref. TASK 33-12-18-000-001).
R FOR 8DG1
R 39LE
R FOR 8DG2
R 40LE
R Subtask 56-12-11-020-061
R E. Removal of the Sliding Window Lining
R (Ref. Fig. 414/TASK 56-12-11-991-030)
R (1) Open the sliding window (Ref. TASK 56-12-11-010-001).
R (2) Remove the screw (5) and remove the pencil holder assembly (7).
R (3) Remove the screw (21) and the washer (20).
R (4) Remove the screw (19) and the washer (18).
R (5) Remove the handle (6).
R (6) Remove the screw (9) and the washer (8).
R (7) Remove the screw (15) and the washer (14).
R (8) Close the sliding window.
R 1EFF : 051-099, 1 56-12-11Page 463 1 1 May 01/05 1 1 1CES 1
R Sliding Window lining
R Figure 414/TASK 56-12-11-991-030
R 1EFF : 051-099, 1 56-12-11 Page 464
1 1 May 01/05
1 1
1CES 1
R (9) Remove the blanking plug (4), remove the screw (3) and the washer
R (2).
R (10) Remove the screws (11).
R (11) Remove the screws (12).
R (12) Lift the plate (17) and remove the sliding window lining (16).
R (13) Disconnect the electrical connector (10) from the receptacle.
R (14) Put blanking caps on the disconnected electrical connectors.
R 4. Procedure_________
R Subtask 56-12-11-020-062
R A. Removal of the Sliding Window Panel
R (Ref. Fig. 415/TASK 56-12-11-991-029)
R CAUTION : BE CAREFUL DURING THE REMOVAL/INSTALLATION OF EACH SLIDING_______
R WINDOW PANEL TO PREVENT INJURY TO PERSONS AND /OR DAMAGE.
R MAKE SURE THAT THERE ARE SUFFICIENT PERSONS DURING THE
R OPERATION. EACH WINDOW PANEL WEIGHS APPROXIMATELY 20Kg
R (44.11b).
R (1) Loosen the screws (32). Loosen the screw located behind the axis of
R the control handle with the WRENCH, REMOVAL - SLIDING WINDOW
R (98D56103002001).
R (2) Use 2 suction cups to hold and move the sliding window panel (30).
R (3) Hold the window panel (30) in position and remove the screws (32),
R the washers (33).
R (4) Move the frame of the sliding window to the open position (the
中国航空网 www.aero.cn
航空翻译 www.aviation.cn
本文链接地址:A320飞机维护手册 AMM WINDOWS 风挡 窗户(63)