-------------------------------------------------------------------------------
PANEL DESIGNATION IDENT. LOCATION
 -------------------------------------------------------------------------------121VU APU/FIRE/LP VALVE/STBY 3WF M41 121VU APU/FUEL/LP VALVE/CTL 1QF M40 121VU APU/FUEL/LP VALVE/SPLY 2QF M39 121VU APU/FUEL/PUMP/CTL 3QC M38
 Subtask 49-62-00-860-050
 B. Aircraft Maintenance Configuration
 (1)
 Energize the aircraft electrical circuits
 (Ref. TASK 24-41-00-861-002).
 (2)
 Do the EIS start procedure (Upper ECAM DU and lower ECAM DU only) (Ref. TASK 31-60-00-860-001).
 4. Procedure_________
 Subtask 49-62-00-710-051
 A. Operational Test of the Emergency Shutdown System
 -------------------------------------------------------------------------------ACTION RESULT -------------------------------------------------------------------------------
1. In the INT LT section of the  In the cockpit: 
 overhead panel 25VU:  - all annunciator lights come on fully 
 - put the ANN LT switch in the  bright. 
 TEST position. 
 2. In the INT LT section of the  In the cockpit: 
 overhead panel 25VU:  - the applicable annunciator lights go 
 - put the ANN LT switch in the  off. 
 BRT position. 
 3. On the overhead panel 25VU:  On the overhead panel 25VU: 
 - push the pushbutton APU MASTER  - the ON legend in the pushbutton APU 
 SW to the ON position.  MASTER SW comes on. 
 On the FUEL page of the ECAM lower 
 display unit: 
 - the APU LP fuel-valve symbol is shown 
 in the open position. 
 -------------------------------------------------------------------------------
ACTION RESULT -------------------------------------------------------------------------------
4. On the external power control panel 108VU: 
-push and hold the APU SHUT OFF pushbutton switch (guarded red). 
5. On the overhead panel 25VU: 
-release the APU MASTER SW pushbutton switch. 
6. On the external power control panel 108VU:
 -release the APU SHUT OFF pushbutton switch and close guard.
 7. On the ECAM control panel: 
-push the FUEL pushbutton 
switch.
8. On the glareshield panel 130VU or 131VU: 
-push the MASTER CAUT pushbutton switch.
 9. On the ECAM control panel: 
-push the CLR pushbutton switch. 
On the ECAM upper display unit:
-
the warning,APU EMER SHUT DOWNMASTER SW .... OFFcomes on.
On the glareshield panels 130VU and 131VU:
 -
the MASTER CAUT lights come on,
 -a single chime is heard.
 On the overhead panel 25VU:
 -
the FAULT legend in the pushbutton APU MASTER SW comes on.
On the overhead panel 25VU:
-
the FAULT legend in the APU MASTER SWpushbutton switch goes off,
 -
the ON legend in the APU MASTER SW pushbutton switch goes off.
On the ECAM upper display unit:
 -
the warning, MASTER SW .... OFF goes off.
On the FUEL page of the ECAM lowerdisplay unit:
-
the APU LP fuel-valve symbol is shown in the closed position.
On the glareshield panels 130VU and131VU:
-
the MASTER CAUT lights go off.
On the ECAM upper display unit:
-
the warning,
 -------------------------------------------------------------------------------
ACTION RESULT
 -------------------------------------------------------------------------------APU EMER SHUT DOWN goes off.
 5. Close-up
________
 Subtask 49-62-00-860-051
 A. Put the aircraft back to its initial configuration.
 
中国航空网 www.aero.cn
航空翻译 www.aviation.cn
本文链接地址:A320飞机维护手册 AMM 机载辅助动力 AIRBORNE AUXILIARY POWER5(122)