Smoke Detector Ejector Installation
Figure 401
EFFECTIVITYùùùùùùùùùùùùùùùùùùùùùùùùùùùùùù. ú
26-14-02
ALL ú ú 03 Page 402 ú Oct 10/93
BOEING PROPRIETARY - Copyright (C) - Unpublished Work - See title page for details.
C81292
A 747-400 MAINTENANCE MANUAL
3) 4) 7H18 CARGO SMOKE - MAIN DECK ZN 9-16 A7H19 CARGO SMOKE - MAIN DECK ZN 9-16 B
S 864-004
(2) Remove the pressure from the pneumatic crossover duct (AMM 36-00-00/201).
S 014-005
CAUTION:_______WEAR EAR PROTECTION IN THE CARGO COMPARTMENT. THE HIGH NOISE LEVEL OF THE EJECTOR CAN CAUSE EAR DAMAGE.
(3)
Remove the floor panel in the aft end of the lower cargo compartment at the center of the airplane.
S 024-027
(4)
Disconnect the electrical connector of the ejector being removed, (DS2276 (fwd)/DS2277 (aft)) located on the pressure switch.
S 034-007
(5)
Disconnect the pressure supply line.
S 034-008
(6)
Disconnect the rubber tube connection to the main vacuum supply line.
S 034-009
(7)
Remove four ejector mounting screws.
S 024-010
(8)
Remove the ejector from the mounting brackets.
TASK 26-14-02-404-011
3. Ejector Installation (Fig. 401)____________________
A. Reference
(1)
AMM 24-22-00/201, Manual Control
(2)
AMM 36-00-00/201, Pnuematic Systems
(3)
AIPC 26-14-51, Fig. 1
(4)
WDM 26-16-21 thru WDM 26-16-29
B. Access
(1) Location Zone 123 Area Below Fwd Cargo Container Compartment L.H. 124 Area Below Fwd Cargo Container Compartment R.H. 143 Area Below Aft Cargo Container Compartment L.H. 144 Area Below Aft Cargo Container Compartment R.H.
C. Procedure
EFFECTIVITYùùùùùùùùùùùùùùùùùùùùùùùùùùùùùù. ú
26-14-02
ALL ú ú 05 Page 403 ú Feb 15/99
BOEING PROPRIETARY - Copyright (C) - Unpublished Work - See title page for details.
A
747-400 MAINTENANCE MANUAL
S 424-012 CAUTION: YOU MUST WEAR EAR PROTECTION IN THE CARGO COMPARTMENT BECAUSE
_______ OF THE HIGH NOISE LEVEL OF THE EJECTOR.
(1)
Install ejector S2276 (fwd ejector) or S2277 (aft ejector) on mounting brackets and install the four ejector mounting screws.
S 434-013
(2)
Connect the air supply line from the pneumatic crossover duct.
S 434-014
(3)
Connect the rubber tube from the main vacuum supply line and clamp it to the ejector.
S 434-015
(4)
Install the vacuum sense line on the ejector mounting base.
S 434-025
(5)
Attach the electrical connector DS2276 (fwd ejector) or DS2277 (aft ejector) to the S2276 (for fwd ejector) or S2277 (for aft ejector) pressure switch.
S 864-017
(6)
Close these circuit breakers, and remove DO-NOT-CLOSE identifier:
(a) P7 Overhead Circuit Breaker Panel
1) 7H16 CARGO SMOKE - MAIN DECK ZN 1-8 A
2) 7H17 CARGO SMOKE - MAIN DECK ZN 1-8 B
3) 7H17 CARGO SMOKE DETECT MAIN DECK ZN 1 B
or
CARGO SMOKE - MAIN DECK ZN 1-8 B 4) 7H18 CARGO SMOKE DETECT MAIN DECK ZN 2&3 A 5) 7H18 CARGO SMOKE - MAIN DECK ZN 9-16 A
中国航空网 www.aero.cn
航空翻译 www.aviation.cn
本文链接地址:747-400 AMM 飞机维护手册 防火 FIRE PROTECTION 1(74)