-
push the EMER LIGHT BATTERY line select key.
-
push the BAT TEST RESET line select key.
-
push the DSPL ON membrane switch.
5. Close-up
________
Subtask 33-51-00-410-052 On the PTP 110RH after approx. 2 h:
-
the EMER BATTERY ATA 33-51-38 TEST OK status comes on.
-
the BAT OK light comes on.
On the PTP 110RH:
-
the EMER LIGHT BATTERY display comes on.
NOTE : If you select another mode/menu
____ on the PTP when the battery capacity check is running. And you then push the RET line select key the PTP will not show the EMER BATTERY TEST page. But it will show the first page of the mode/menu you selected before.
-
the EMER BATTERY TEST page comes on.
-
the SYST TEST menu comes on.
-
the BAT OK light goes off.
-
the integral light of the BAT membrane switch goes off.
-
the CIDS menu comes on.
A. Close the access panels of the emergency power supply-units 10WL thru 13WL FOR 10WL 221BC (Ref. TASK 25-23-45-400-006) FOR 11WL 241KW (Ref. TASK 25-23-44-400-001) FOR 12WL 242KW (Ref. TASK 25-23-44-400-001) FOR 13WL 261CC (Ref. TASK 25-23-45-400-008).
R 1EFF : 001-049, 051-099, 101-105, 151-199, 1 33-51-00Page 510 1201-299, 1May 01/05 1 1 1CES 1 Subtask 33-51-00-862-052
B. Put the aircraft back to the serviceable condition.
(1)
De-energize the CIDS (Ref. TASK 23-73-00-862-001).
(2)
De-energize the aircraft electrical circuits (Ref. TASK 24-41-00-862-002).
R 1EFF : 001-049, 051-099, 101-105, 151-199, 1 33-51-00Page 511 1201-299, 1May 01/05 1 1 1CES 1 TASK 33-51-00-710-003- 01
Battery Capacity Check alternative to the Procedure with the 'TEST EMER LIGHT BAT' Pushbutton
1.
Reason for the Job
__________________
Refer to the MPD TASK: 335100-03
2.
Job Set-up Information
______________________
A. Referenced Information
-------------------------------------------------------------------------------REFERENCE DESIGNATION -------------------------------------------------------------------------------
33-51-38-000-002 Removal of the Battery of the Emergency Power-Supply Unit 33-51-38-400-002 Installation of the Battery of the Emergency Power-Supply Unit
3. Job Set-up
__________ Subtask 33-51-00-860-057
A. There is no special job set-up for this task.
4. Procedure
_________ Subtask 33-51-00-920-050
A. Replacement of the Battery Pack
(1)
Remove the batteries of all Emergency Power Supply Units (EPSU) (Ref. TASK 33-51-38-000-002).
(2)
Install fully charged batteries to all EPSU (Ref. TASK 33-51-38-400-002).
R 1EFF : 001-049, 051-099, 101-105, 151-199, 1 33-51-00Page 512 1201-299, 1May 01/05 1 1 1CES 1R **ON A/C ALL
TASK 33-51-00-710-004
Check manual Operation from both Control Panels and check all Cabin Lights and Signs illuminated by Batteries
1.
Reason for the Job
__________________
Refer to the MPD TASK: 335100-05
2.
Job Set-up Information
______________________
A. Referenced Information
-------------------------------------------------------------------------------REFERENCE DESIGNATION -------------------------------------------------------------------------------
24-41-00-861-002 Energize the Aircraft Electrical Circuits from the External Power 24-41-00-862-002 De-energize the Aircraft Electrical Circuits Supplied from the External Power
3. Job Set-up
__________
Subtask 33-51-00-861-053
A. Energize the aircraft electrical circuits (Ref. TASK 24-41-00-861-002). Subtask 33-51-00-865-053
B. Make sure that this(these) circuit breaker(s) is(are) closed:
-------------------------------------------------------------------------------PANEL DESIGNATION IDENT. LOCATION -------------------------------------------------------------------------------49VU LIGHTING/EMER LT/CABIN 2WL H06 49VU LIGHTING/EMER LT/CABIN 1WL H05 122VU LIGHTING/CABIN/EMER/LT 3WL V07
4. Procedure
_________
**ON A/C 001-049, 051-099, 101-105, 151-199, 201-299,
Subtask 33-51-00-860-052
A. Preparation for Test
(1)
On the overhead panel 25VU, make sure that the EMER EXIT LT switch 4WL is in the OFF position.
(2)
On the overhead panel 25VU, make sure that the NO SMOKING switch 190RH is in the OFF position.
中国航空网 www.aero.cn
航空翻译 www.aviation.cn
本文链接地址：A320飞机维护手册 AMM LIGHTS 灯光2(112)
