• 热门标签

当前位置: 主页 > 航空资料 > 机务资料 >

时间:2011-03-21 08:16来源:蓝天飞行翻译 作者:admin
曝光台 注意防骗 网曝天猫店富美金盛家居专营店坑蒙拐骗欺诈消费者

 

 Location of Conduit Fittings Figure 607/TASK 24-92-00-991-011 
R 1EFF : 1 1 1CES  ALL  1 111 24-92-00 Page 621 Feb 01/04

 

 (4)
 Disconnect the aircraft from the ground (Ref. TASK 12-34-24-869-002).

 (5)
 Remove the access platform(s).


R 1EFF : ALL 1 24-92-00Page 622 1 1 Feb 01/04 1 1 1CES 1 TASK 24-92-00-210-006


 Inspection of the End Fittings of Electrical Conduits in Wing Outboard Trailing -Edge
 WARNING : MAKE SURE THAT THE GROUND SAFETY-LOCKS ARE IN POSITION ON THE LANDING
_______ GEAR.
 WARNING : PUT THE SAFETY DEVICES AND THE WARNING NOTICES IN POSITION BEFORE YOU
_______ START A TASK ON OR NEAR:
 -
THE FLIGHT CONTROLS

 -
THE FLIGHT CONTROL SURFACES

 -
THE LANDING GEAR AND THE RELATED DOORS


 -COMPONENTS THAT MOVE.
 WARNING : MAKE SURE THAT YOU OBEY ALL THE WARNINGS AND THE CAUTIONS INCLUDED IN
_______ THE REFERENCED PROCEDURES.
 WARNING : USE SOLVENTS/CLEANING AGENTS, SEALANTS AND OTHER SPECIAL MATERIALS
_______ ONLY WITH A GOOD SUPPLY OF AIR. OBEY THE MANUFACTURERS INSTRUCTIONS. PUT ON PROTECTIVE CLOTHING. DO NOT GET THEM IN YOUR MOUTH. DO NOT SMOKE. DO NOT BREATHE THE GAS. THESE MATERIALS ARE POISONOUS, FLAMMABLE AND SKIN IRRITANT. GET MEDICAL HELP IF YOUR SKIN OR EYES BECOME IRRITATED.
 1. Reason for the Job
__________________
 Refer to the MPD TASK: 240000-07 Apply temporary protection to end fittings of electrical conduits in wing outboard trailing-edge.
R 1EFF : ALL 1 24-92-00Page 623 1 1 Feb 01/04 1 1 1CES 1


 2. Job Set-up Information
______________________
 A. Fixtures, Tools, Test and Support Equipment
 -------------------------------------------------------------------------------REFERENCE QTY DESIGNATION -------------------------------------------------------------------------------
No specific airless spray
 No specific brush
 No specific dental
 No specific lint-free cloth
 No specific seal tools
 No specific adjustable access platform 3 m (9 ft. 10 in.)

 B. Consumable Materials
 -------------------------------------------------------------------------------REFERENCE DESIGNATION -------------------------------------------------------------------------------
Material No. 11-004  USA MIL-T-81533
 1.1.1TRICHLOROETHANE (METHYL CHLOROFORM)
 (Ref. 20-31-00)

 Material No. 15-008  AIB TN 10138 TYPE II GRADE 2 CORROSION PREVENTIVE TEMPORARY PROTECTIVE COMPOUND (Ref. 20-31-00)
 C. Referenced Information
 -------------------------------------------------------------------------------REFERENCE DESIGNATION -------------------------------------------------------------------------------
12-34-24-869-002 Aircraft Grounding for the Maintenance Operations 24-41-00-862-002 De-energize the Aircraft Electrical Circuits Supplied
 from the External Power 27-50-00-866-008 Extension of the Flaps on the Ground 27-50-00-866-009 Retraction of the Flaps on the Ground 27-60-00-866-002 Extension-Retraction of the Spoilers for Maintenance 24-92-00-991-006 Fig. 602 24-92-00-991-012 Fig. 608
R 24-92-00-991-013-A Fig. 609 3. Job Set-up


__________
 Subtask 24-92-00-860-061

 A. Aircraft Maintenance Configuration
 (1) Extend the flaps (Ref. TASK 27-50-00-866-008).
 (2) Extend the spoilers (Ref. TASK 27-60-00-866-002).
 Subtask 24-92-00-862-055

 B. De-energize the aircraft electrical circuits
 (Ref. TASK 24-41-00-862-002).

 Subtask 24-92-00-869-061
 C. Connect the aircraft to the ground (Ref. TASK 12-34-24-869-002).
 Subtask 24-92-00-010-055

 D. Get Access
 (1)
 Put the adjustable access platform in position at the wing outboard trealing-edge.

 (2)
 For the left wing.

 (a) Remove and retain the access panel: 575BB, 575CB, 575DB, 575EB, 575FB, 575GB, 575HB, 575KB, 575LB, 575MB.

 (3)
 For the right wing.


 (a) Remove and retain the access panel: 675BB, 675CB, 675DB, 675EB, 675FB, 675GB, 675HB, 675KB, 675LB, 675MB.
 4. Procedure
_________
 Subtask 24-92-00-210-055

 A. Inspection of the End Fittings of Electrical Conduits
R  (Ref. Fig. 602/TASK 24-92-00-991-006, 608/TASK 24-92-00-991-012, 609/TASK 24-92-00-991-013-A)
 WARNING : BE CAREFUL NOT TO CUT YOUR FINGERS. FLAKES OF NICKEL ARE SHARP.
_______


 Electrical Harness Conduits - Corrosion Protection Figure 608/TASK 24-92-00-991-012 
R 1EFF : 1 1 1CES  ALL  1 111 24-92-00 Page 626 Feb 01/04
 
中国航空网 www.aero.cn
航空翻译 www.aviation.cn
本文链接地址:A320飞机维护手册 AMM ELECTRICAL POWER 电源2(153)